RESUMO
The present work reports the development of a sensitive and selective method for ethinylestradiol detection using screen-printed electrode (SPE) modified with functionalized graphene (FG), graphene quantum dots (GQDs) and magnetic nanoparticles coated with molecularly imprinted polymers (mag@MIP). The performance of the mag@MIP sensor was compared with that of a non-molecularly imprinted sensor (mag@NIP). Chemical and physical characterizations of the mag@NIP and mag@MIP sensors were performed using scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy (EDS) and Brunauer-Emmett-Teller (BET) techniques. The electrochemical behavior of the electrodes investigated, which included (mag@MIP)-GQDs-FG-NF/SPE, (mag@NIP)-GQDs-FG-NF/SPE, GQDs-FG-NF/SPE and FG-NF/SPE, was evaluated by cyclic voltammetry. The results obtained show a significant increase in peak current magnitude for (mag@MIP)-GQDs-FG-NF/SPE. Using square wave voltammetry experiments, the efficiency of the (mag@MIP)-GQDs-FG-NF/SPE sensor was also tested under optimized conditions. The linear response range obtained for ethinylestradiol concentration was 10 nmol L-1 to 2.5 µmol L-1, with limit of detection of 2.6 nmol L-1. The analytical signal of the (mag@MIP)-GQDs-FG-NF/SPE sensor suffered no interference from different compounds and the sensor exhibited good repeatability. The proposed sensor was successfully applied for ethynilestradiol detection in river water, serum and urine samples, where recovery rates between 96 to 105% and 97-104% were obtained for environmental and biological samples, respectively.
Assuntos
Grafite , Nanopartículas de Magnetita , Impressão Molecular , Pontos Quânticos , Técnicas Eletroquímicas , Eletrodos , Etinilestradiol , Limite de Detecção , Polímeros Molecularmente ImpressosRESUMO
A new disposable microfluidic electrochemical paper-based device (ePAD) consisting of two spot sensors in the same working electrode for the simultaneous determination of uric acid and creatinine was developed. The spot 1 surface was modified with graphene quantum dots for direct uric acid oxidation and spot 2 surface modified with graphene quantum dots, creatininase and a ruthenium electrochemical mediator for creatinine oxidation. The ePAD was employed to construct an electrochemical sensor (based on square wave voltammetry analysis) for the simultaneous determination of uric acid and creatinine in the 0.010-3.0⯵molâ¯L-1 range. The device showed excellent analytical performance with a very low simultaneous detection limit of 8.4 nmol L-1 to uric acid and 3.7 nmol L-1 to creatinine and high selectivity. The ePAD was applied to the rapid and successful determination of those clinical biomarkers in human urine samples.
Assuntos
Creatinina/urina , Técnicas Eletroquímicas/instrumentação , Dispositivos Lab-On-A-Chip , Ácido Úrico/urina , Biomarcadores/química , Biomarcadores/urina , Creatinina/química , Eletrodos , Grafite/química , Humanos , Oxirredução , Papel , Pontos Quânticos/química , Rutênio/química , Ureo-Hidrolases/química , Ácido Úrico/químicaRESUMO
In order to reduce the sample consumption and waste generation for electrochemical purposes, a screen-printed electrode (SPE) used for electrodeposition of bismuth film (SPE-BiFE) and a thermostated electrochemical flow cell (EFC) were developed. The SPE-BiFE with the EFC was employed to determine Cd(2+) and Pb(2+) ions in natural, wastewater and tap water samples by square-wave anodic stripping voltammetry (SWASV). For this, the flow-batch analysis (FBA) approach based on solenoid micro-pumps and three-way valves was developed to carry out a fully automated procedure with temperature control. Furthermore, the FBA and the SWASV parameters were optimized, on line simultaneous determination of Cd(2+) and Pb(2+) ions was performed and two analytical curves were linearly acquired in the concentration ranges from 6.30 to 75.6µg L(-1) and from 3.20 to 38.4µg L(-1), respectively. Moreover, limits of detection of 0.60µg L(-1) and 0.10µg L(-1) for Cd(2+) and Pb(2+), respectively, were obtained. Studies of precision for the same SPE-BiFE and repeatability for five built SPE-BiFE were carried out for Cd(2+) and Pb(2+) ion measurements and RSD of 4.1% and 2.9% (n=3) with repeatabilities (n=5) of 6.5% and 8.0% were respectively obtained for both analytes. Besides, a low consumption of 700µL of reagents and a sampling frequency of 13h(-1) were acquired. Simplicity, fast response, accuracy, high portability, robustness and suitability for in loco analyses are the main features of the proposed electroanalytical method.