RESUMO
In a recent experimental campaign, we used laser-accelerated relativistic hot electrons to ensure heating of thin titanium wire targets up to a warm dense matter (WDM) state [EPL114, 45002 (2016)10.1209/0295-5075/114/45002]. The WDM temperature profiles along several hundred microns of the wire were inferred by using spatially resolved X-ray emission spectroscopy looking at the Ti Kα characteristic lines. A maximum temperature of â¼30â eV was reached. Our study extends this work by discussing the influence of the laser parameters on temperature profiles and the optimisation of WDM wire-based generation. The depth of wire heating may reach several hundreds of microns and it is proven to be strictly dependent on the laser intensity. At the same time, it is quantitatively demonstrated that the maximum WDM temperature doesn't appear to be sensitive to the laser intensity and mainly depends on the deposited laser energy considering ranges of 6×1018-6×1020 W/cm2 and 50-200 J.
RESUMO
Collimated transport of ultrahigh intensity electron current was observed in cold and in laser-shocked vitreous carbon, in agreement with simulation predictions. The fast electron beams were created by coupling high-intensity and high-contrast laser pulses onto copper-coated cones drilled into the carbon samples. The guiding mechanism-observed only for times before the shock breakout at the inner cone tip-is due to self-generated resistive magnetic fields of â¼0.5-1 kT arising from the intense currents of fast electrons in vitreous carbon, by virtue of its specific high resistivity over the range of explored background temperatures. The spatial distribution of the electron beams, injected through the samples at different stages of compression, was characterized by side-on imaging of hard x-ray fluorescence.
RESUMO
In an experiment performed with a high-intensity and high-energy laser system, α-particle production in proton-boron reaction by using a laser-driven proton beam was measured. α particles were observed from the front and also from the rear side, even after a 2-mm-thick boron target. The data obtained in this experiment have been analyzed using a sequence of numerical simulations. The simulations clarify the mechanisms of α-particle production and transport through the boron targets. α-particle energies observed in the experiment and in the simulation reach 10-20 MeV through energy transfer from 20-30 MeV energy incident protons. Despite the lower cross sections for protons with energy above the sub-MeV resonances in the proton-boron reactions, 10^{8}-10^{9}α particles per steradian have been detected.
RESUMO
Protontherapy is hadrontherapy's fastest-growing modality and a pillar in the battle against cancer. Hadrontherapy's superiority lies in its inverted depth-dose profile, hence tumour-confined irradiation. Protons, however, lack distinct radiobiological advantages over photons or electrons. Higher LET (Linear Energy Transfer) 12C-ions can overcome cancer radioresistance: DNA lesion complexity increases with LET, resulting in efficient cell killing, i.e. higher Relative Biological Effectiveness (RBE). However, economic and radiobiological issues hamper 12C-ion clinical amenability. Thus, enhancing proton RBE is desirable. To this end, we exploited the p + 11B â 3α reaction to generate high-LET alpha particles with a clinical proton beam. To maximize the reaction rate, we used sodium borocaptate (BSH) with natural boron content. Boron-Neutron Capture Therapy (BNCT) uses 10B-enriched BSH for neutron irradiation-triggered alpha particles. We recorded significantly increased cellular lethality and chromosome aberration complexity. A strategy combining protontherapy's ballistic precision with the higher RBE promised by BNCT and 12C-ion therapy is thus demonstrated.
Assuntos
Terapia por Captura de Nêutron de Boro/métodos , Boro/uso terapêutico , Terapia Combinada/métodos , Nêutrons , Neoplasias da Próstata/radioterapia , Terapia com Prótons , Terapia com Prótons/métodos , Partículas alfa/uso terapêutico , Animais , Boroidretos/química , Boro/química , Terapia por Captura de Nêutron de Boro/instrumentação , Isótopos de Carbono/química , Morte Celular/efeitos da radiação , Linhagem Celular Tumoral , Aberrações Cromossômicas/efeitos da radiação , Terapia Combinada/instrumentação , Ciclotrons , Dano ao DNA , DNA de Neoplasias/genética , DNA de Neoplasias/metabolismo , DNA de Neoplasias/efeitos da radiação , Relação Dose-Resposta à Radiação , Corantes Fluorescentes/química , Humanos , Cariotipagem , Transferência Linear de Energia , Masculino , Neoplasias da Próstata/patologia , Terapia com Prótons/instrumentação , Eficiência Biológica Relativa , Compostos de Sulfidrila/químicaRESUMO
Intense lasers interacting with dense targets accelerate relativistic electron beams, which transport part of the laser energy into the target depth. However, the overall laser-to-target energy coupling efficiency is impaired by the large divergence of the electron beam, intrinsic to the laser-plasma interaction. Here we demonstrate that an efficient guiding of MeV electrons with about 30 MA current in solid matter is obtained by imposing a laser-driven longitudinal magnetostatic field of 600 T. In the magnetized conditions the transported energy density and the peak background electron temperature at the 60-µm-thick target's rear surface rise by about a factor of five, as unfolded from benchmarked simulations. Such an improvement of energy-density flux through dense matter paves the ground for advances in laser-driven intense sources of energetic particles and radiation, driving matter to extreme temperatures, reaching states relevant for planetary or stellar science as yet inaccessible at the laboratory scale and achieving high-gain laser-driven thermonuclear fusion.
RESUMO
Stüve-Wiedemann syndrome (SWS) is an extremely rare congenital skeletal disorder associated with significant newborn mortality and morbidity in survivors. Prenatal diagnosis is reportedly possible, but a precise diagnosis is difficult because SWS is part of a heterogeneous group of bone dysplasias. Molecular analysis remains the gold standard for establishing a specific diagnosis of this kind of disorders and for providing effective prenatal counselling. This article presents a case of SWS suspected at prenatal ultrasound in the second trimester of pregnancy and confirmed by multidisciplinary approach at birth.
Assuntos
Doenças do Desenvolvimento Ósseo/congênito , Doenças do Desenvolvimento Ósseo/diagnóstico por imagem , Ultrassonografia Pré-Natal , Adulto , Feminino , Humanos , Recém-Nascido , Gravidez , SíndromeRESUMO
In an experiment at the laser facility ECLIPSE of the CELIA laboratory, University of Bordeaux, we measure the reflectivity of spherically bent crystals that are commonly used to investigate the propagation of fast electrons through the Kα radiation they generate in matter. The experimental reflectivity compares well with predictions from a ray-tracing code that takes into account the specific geometry, although the crystals seem to suffer from aging problems.
RESUMO
Transmission crystal spectrometers (TCS) are used on many laser facilities to record hard X-ray spectra. During experiments, signal recorded on imaging plates is often degraded by a background noise. Monte-Carlo simulations made with the code GEANT4 show that this background noise is mainly generated by diffusion of MeV electrons and very hard X-rays. An experiment, carried out at LULI2000, confirmed that the use of magnets in front of the diagnostic, that bent the electron trajectories, reduces significantly this background. The new spectrometer SPECTIX (Spectromètre PETAL à Cristal en TransmIssion X), built for the LMJ/PETAL facility, will include this optimized shielding.
RESUMO
Ge crystals were prepared by means of laser-induced ion implantation technique. A Nd:YAG pulsed laser (repetition rate: 10 Hz; pulse duration: 3.5 ns; pulse energy: â¼0.5 J) was used both as an ion source and to carry out the ablation processes. The optimization of the laser-generated ion beam parameters in a broad energy and current density range has been obtained controlling the electrostatic field parameters. Numerical simulations of the focusing system, performed adopting an OPERA 3D code, and an investigation of the ion characteristics, using the ion time-of-flight method, have allowed to optimize the preparation parameters. The structural properties of the samples were investigated by means of x-ray photoelectron, micro-Raman spectroscopies, and scanning electron microscopy techniques. Experimental results show that, by appropriately varying the ion implantation parameters and by a post-preparation annealing treatment, it is possible to achieve the development of a micrometer-sized crystalline Ge phase and∕or an amorphous one.
RESUMO
A 10(16) W∕cm(2) Asterix laser pulse intensity, 1315 nm at the fundamental frequency, 300 ps pulse duration, was employed at PALS laboratory of Prague, to irradiate thick and thin primary CD(2) targets placed inside a high vacuum chamber. The laser irradiation produces non-equilibrium plasma with deutons and carbon ions emission with energy of up to about 4 MeV per charge state, as measured by time-of-flight (TOF) techniques by using ion collectors and silicon carbide detectors. Accelerated deutons may induce high D-D cross section for fusion processes generating 3 MeV protons and 2.5 MeV neutrons, as measured by TOF analyses. In order to increase the mono-energetic proton yield, secondary CD(2) targets can be employed to be irradiated by the plasma-accelerated deutons. Experiments demonstrated that high intensity laser pulses can be employed to promote nuclear reactions from which characteristic ion streams may be developed. Results open new scenario for applications of laser-generated plasma to the fields of ion sources and ion accelerators.
RESUMO
The iodine laser at PALS Laboratory in Prague, operating at 1315 nm fundamental harmonics and at 300 ps FWHM pulse length, is employed to irradiate thin hydrogenated targets placed in vacuum at intensities on the order of 10(16) W∕cm(2). The laser-generated plasma is investigated in terms of proton and ion emission in the forward and backward directions. The time-of-flight technique, using ion collectors and semiconductor detectors, is used to measure the ion currents and the corresponding velocities and energies. Thomson parabola spectrometer is employed to separate the contribution of the ion emission from single laser shots. A particular attention is given to the proton production in terms of the maximum energy, emission yield, and angular distribution as a function of the laser energy, focal position, target thickness, and composition. Metallic and polymeric targets allow to generate protons with large energy range and different yield, depending on the laser, target composition, and target geometry properties.
Assuntos
Hidrogênio/química , Lasers , Prótons , Radiometria/instrumentação , Gases em Plasma/química , Análise EspectralRESUMO
An overview of the last experimental campaigns on laser-driven ion acceleration performed at the PALS facility in Prague is given. Both the 2 TW, sub-nanosecond iodine laser system and the 20 TW, femtosecond Ti:sapphire laser, recently installed at PALS, are used along our experiments performed in the intensity range 10(16)-10(19) W∕cm(2). The main goal of our studies was to generate high energy, high current ion streams at relatively low laser intensities. The discussed experimental investigations show promising results in terms of maximum ion energy and current density, which make the laser-accelerated ion beams a candidate for new-generation ion sources to be employed in medicine, nuclear physics, matter physics, and industry.
RESUMO
A pulsed neodymium-doped yttrium aluminum garnet laser ion source has been used as proton beams generator. The laser wavelength is 1064 nm, the pulse duration is 9 ns and the intensity reaches 10(10) W/cm(2). Laser irradiates hydrogenated polymers targets located in a chamber at 10(-7) mbar. The ions are post-accelerated in a suitable chamber by 30 kV of voltage between the target, positively biased, and the following ground electrode. The extracted beams is characterized through a time-of-flight technique. Possible applications to the field of nuclear physics, such as nuclear excitation and de-excitations, nuclear reactions and nuclear fusion, will be presented and discussed.
RESUMO
The Onley-Yip procedure for determining ethylenethiourea (ETU) in milk and crops was modified to reduce interferences by the ethylenebisdithiocarbamates (EBDCs). A 20 g crop-methanol extract is cleaned up by adsorbing the sample onto Gas-Chrom S. desorbing ETU, and eluting ETU from aluminum oxide with chloroform containing ethanol. ETU is converted to the S-butyl derivative for gas-liquid chromatography (GLC) and flame photometric detection (sulfur mode). For liquid chromatography (LC), ETU is cleaned up on another aluminum oxide column and injected directly. LC and GLC results are confirmed by thin layer chromatography. A cooking procedure based on conversion of EBDCs to ETU is included for surveying crops for possible EBDC content. Recoveries from 8 crops and milk fortified at 0.05 ppm ETU ranged from 73 to 100%.
Assuntos
Etilenotioureia/análise , Análise de Alimentos , Imidazóis/análise , Animais , Cromatografia Gasosa , Cromatografia Líquida , Frutas/análise , Temperatura Alta , Métodos , Leite/análise , Verduras/análiseRESUMO
Two chlorinated insecticide feeding studies from 1967-1968, using broiler chicks, have been completed. In Study I, lindane, heptachlor epoxide, dieldrin, endrin, methoxychlor, and DDT were fed in combination at 3 levels: 0.05, 0.15, and 0.45 ppm. Data show that, in fat tissues, heptachlor epoxide attained a level approximately 20 times the respective levels in the feed; dieldrin 15 times; endrin 10 times; p,p'-DDT 9 times; lindane 3 times; and o.p'-DDT less than the feeding levels. Of the DDT metabolites, p.p'-DDE and p,p'-DDD, only p,p'-DDE was significant at 3 times the 0.45 ppm feeding level. Endrin ketone, a metabolite of endrin, reached plateau levels approximately equal to feeding levels. All residue levels in liver tissues were less than 0.02 ppm. In Study II, technical chlordane was fed singly at the 0.05, 0.15, and 0.45 ppm levels. Results are tabulated for both total chlordane and for 6 identifiable isomers. Total chlordane in fat tissues attained plateau levels 3-5 times the respective feeding levels. Total chlordane levels in liver and breast tissues were all less than 0.01 ppm.