Tetracycline adsorption/desorption by raw and activated Tunisian clays.

Clay-based adsorbents have applications in environmental remediation, particularly in the removal of emerging pollutants such as antibiotics. Taking that into account, we studied the adsorption/desorption process of tetracycline (TC) using three raw and acid- or base-activated clays (AM, HJ1 and HJ2) collected, respectively, from Aleg (Mazzouna), El Haria (Jebess, Maknessy), and Chouabine (Jebess, Maknessy) formations, located in the Maknessy-Mazzouna basin, center-western of Tunisia. The main physicochemical properties of the clays were determined using standard procedures, where the studied clays presented a basic pH (8.39-9.08) and a high electrical conductivity (446-495 dS m-1). Their organic matter contents were also high (14-20%), as well as the values of the effective cation exchange capacity (80.65-97.45 cmolckg-1). In the exchange complex, the predominant cations were Na and Ca, in the case of clays HJ1 and AM, while Mg and Ca were dominant in the HJ2 clay. The sorption experimental setup consisted in performing batch tests, using 0.5 g of each clay sample, adding the selected TC concentrations, then carrying out quantification of the antibiotic by means of HPL-UV equipment. Raw clays showed high adsorption potential for TC (close to 100%) and very low desorption (generally less than 5%). This high adsorption capacity was also present in the clays after being activated with acid or base, allowing them to adsorb TC in a rather irreversible way for a wide range of pH (3.3-10) and electrical conductivity values (3.03-495 dS m-1). Adsorption experimental data were studied as regards their fitting to the Freundlich, Langmuir, Linear and Sips isotherms, being the Sips model the most appropriate to explain the adsorption of TC in these clays (natural or activated). These results could help to improve the overall knowledge on the application of new low-cost methods, using clay based adsorbents, to reduce risks due to emerging pollutants (and specifically TC) affecting the environment.

Experimental data and modeling of sulfadiazine adsorption onto raw and modified clays from Tunisia.

In recent years, the increasing detection of emerging pollutants (particularly antibiotics, such as sulfonamides) in agricultural soils and water bodies has raised growing concern about related environmental and health problems. In the current research, sulfadiazine (SDZ) adsorption was studied for three raw and chemically modified clays. The experiments were carried out for increasing doses of the antibiotic (0, 1, 5, 10, 20, and 40 µmol L-1) at ambient temperature and natural pH with a contact time of 24 h. The eventual fitting to Freundlich, Langmuir and Linear adsorption models, as well as residual concentrations of antibiotics after adsorption, was assessed. The results obtained showed that one of the clays (HJ1) adsorbed more SDZ (reaching 99.9 % when 40 µmol L-1 of SDZ were added) than the other clay materials, followed by the acid-activated AM clay (which reached 99.4 % for the same SDZ concentration added). The adsorption of SDZ followed a linear adsorption isotherm, suggesting that hydrophobic interactions, rather than cation exchange, played a significant role in SDZ retention. Concerning the adsorption data, the best adjustment corresponded to the Freundlich model. The highest Freundlich KF scores were obtained for the AM acid-treated and raw HJ1 clays (606.051 and 312.969 Ln µmol1-n kg-1, respectively). The Freundlich n parameter ranged between 0.047 and 1.506. Regarding desorption, the highest value corresponded to the AM clay, being generally <10 % for raw clays, <8 % for base-activated clays, and <6 % for acid-activated clays. Chemical modifications contributed to improve the adsorption capacity of the AM clay, especially when the highest concentrations of the antibiotic were added. The results of this research can be considered relevant as regard environmental and public health assessment since they estimate the feasibility of three Tunisian clays in SDZ removal from aqueous solutions.

Microbiological and physicochemical quality enhancement of treated wastewater using raw and chemically modified clays from Sidi Bouzid region, Tunisia.

Environmental discharge of wastewater represents a source of chemical and biological pollutants. This study firstly evaluates the microbiological and physicochemical quality of treated wastewaters collected from two wastewater treatment plants (WWTPs) located in two different Tunisian cities namely Sidi Bouzid (SB) and Gafsa (G). Then, the capacity of three raw and acid/base-activated local clays to enhance the quality of wastewaters was assessed. The results indicate that the quantities of enteric bacteria (oscillating from 1.381 × 103 to 1.4 × 108 CFU/100 mL), fungi (between 1.331 × 103 and 1.781 × 104 CFU/100 mL), as well as SARS-CoV-2 (between 4.25 × 103 and 5.05 × 105 CFU/100 mL) and Hepatitis A virus RNA (form 4.25 × 103 to 7.4 × 104 CFU/100 mL) detected in effluent wastewaters were not in compliance with the Tunisian standards for both studied WWTPs. Likewise for other indicators such as electrical conductivity (ranging 4.9-5.4 mS/cm), suspended matter (145-160 g l-1), chemical oxygen demand (123-160 mg l-1), biological oxygen demand 5 (172-195 mg l-1), chloride, Total Kjeldahl nitrogen (TKN) and phosphorus contents (710, 58-66 and 9.47-10.83 mg l-1 respectively), the registered values do not agree with the set standards established for wastewater treatment. On the other hand, the pH values fitted (oscillating from 6.86 (at G) to 7.24 (at SB) with the Tunisian standards for both WWTPs. After treatment, wastewaters showed better values for the microbiological parameters, especially for the clays designed as AM and HJ1, which eliminated 100% of viruses. In addition, when acid-activated AM clays were applied, a marked improvement in the quality of physicochemical parameters was obtained, especially for suspended matter (2 and 4 g l-1 for SB and G, respectively), TKN (5.2 (SB) and 6.40 (G) mg/l), phosphorus (1.01 (SB) and 0.81 (G) mg/l). Our results open perspectives for the possibility of efficiently using these specific clays in the enhancement of the quality of treated wastewaters.

Approaches to Addressing Nonmedical Services and Care Coordination Needs for Older Adults.

OBJECTIVE: Non-medical services care coordination for daily activities of living is crucial in improving older adults' health and enabling them to age in place, but little is known about specific practices and barriers in this space. METHODS: Semi-structured interviews were conducted with 41 professionals serving older adults in greater Chicago, Illinois-which consists of diverse urban, suburban, and semi-rural communities-to contextualize non-medical services needs and care coordination processes. RESULTS: In-home care, home-delivered meals, non-emergency transportation, and housing support were cited as the most commonly needed services, all requiring complex coordination support. Respondents noted a reliance on inefficient phone/fax usage for referral-making and cited major challenges in inter-professional communication, service funding/reimbursement, and HIPAA. CONCLUSIONS: Non-medical services delivery for older adults is severely impacted by general siloing throughout the care continuum. Interventions are needed to enhance communication pathways and improve the salience and interdisciplinarity of non-medical services coordination for this population.