RESUMO
The deep sea remains the largest unknown territory on Earth because it is so difficult to explore1-4. Owing to the extremely high pressure in the deep sea, rigid vessels5-7 and pressure-compensation systems8-10 are typically required to protect mechatronic systems. However, deep-sea creatures that lack bulky or heavy pressure-tolerant systems can thrive at extreme depths11-17. Here, inspired by the structure of a deep-sea snailfish15, we develop an untethered soft robot for deep-sea exploration, with onboard power, control and actuation protected from pressure by integrating electronics in a silicone matrix. This self-powered robot eliminates the requirement for any rigid vessel. To reduce shear stress at the interfaces between electronic components, we decentralize the electronics by increasing the distance between components or separating them from the printed circuit board. Careful design of the dielectric elastomer material used for the robot's flapping fins allowed the robot to be actuated successfully in a field test in the Mariana Trench down to a depth of 10,900 metres and to swim freely in the South China Sea at a depth of 3,224 metres. We validate the pressure resilience of the electronic components and soft actuators through systematic experiments and theoretical analyses. Our work highlights the potential of designing soft, lightweight devices for use in extreme conditions.
RESUMO
Considering the further exploration of the ocean, the requirements for deep-sea operation equipment have increased. Many problems existing in the widely used deep-sea hydraulic system have become increasingly prominent. Compared with the traditional deep-sea hydraulic system, actuators using a paraffin phase change material (PCM) have incomparable advantages, including lightweight structure, low energy consumption, high adaptability to the deep sea, and good biocompatibility. Thus, a deep-sea drive microunit (DDM) based on paraffin PCM is proposed in this paper. The device adopts a flexible shell, adapting to the high-pressure environment of the deep-sea based on the principle of pressure compensation. The device realizes the output of displacement and force through the electrothermal drive, which can be used as actuator or power source of other underwater operation equipment. The microunit successfully completes the functional verification experiments in air, shallow water, and hydrostatic pressure of 110 MPa. In accordance with experimental results, a reasonable control curve is fitted, highlighting its potential application in deep-sea micro electro mechanical systems, especially in underwater soft robot.
RESUMO
In this paper, coating removal characteristics of water jet by micro jet flow affected by cleaning parameters is analyzed. Numerical simulation of fluid field calculates the velocity and pressure distribution of a water jet impinging on a rigid wall, which is used for design experiments of coating removal affected by jet pressure, traversal speed, and repeated impacting times. The removal width is used as a measure of water jet coating removal capability. Experiment results show that the coating removal width is constant, independent with traversal speed or repeated times when total exposure time of waterjet impingement is fixed. According to results of coating removal by a linear moving water jet, this study also analyzes characteristics of coating removal by rotating jet disc, especially residual coating affected by rotational and moving speed of the cleaning disc. The research is helpful to improve the coating removal efficiency of cleaning disc devices.
RESUMO
Due to the extremely high pressures in the deep sea, heavy ballast tanks and pressure compensating hydraulic tanks are typically required to support the operation of classic buoyancy controls. Buoyancy control systems driven by phase-change materials (PCM) have unique advantages over conventional hydraulically actuated buoyancy control systems, including high adaptability for deep-sea exploration and simple, lightweight, and compact structures. Inspired by this, a buoyancy control module (BCM) was designed with flexible material as the shell. Instead of a conventional mechanical system, the device uses an electric heating drive to control buoyancy by heating and cooling the PCM. Based on the principle of pressure compensation, this device can adjust the buoyancy of a small underwater vehicle in a deep-sea high-pressure environment. The BCM successfully adjusts the buoyancy to lift itself up and down in the South China Sea at a depth of 3223 m. The performance of the phase-change BCM to control buoyancy under high pressure is validated by systematic experiments and theoretical analysis. Our work proposes a flexible scheme for the design of a deep-sea phase-change-driven BCM and highlights its potential application in deep-sea micro-mechanical systems, especially soft robots.