RESUMO
Phase separation technology has attracted extensive scientific interest because of its intriguing structure changes during the phase separation process. Phase separation inside emulsion droplets in continuous surroundings has been well studied in recent years. Many investigations have also been conducted to study the droplet phase separation phenomena in noncontinuous surroundings. However, studies on the phase separation phenomena and the spreading behavior of suspended droplets at the air-liquid interface were rarely reported. In this study, PEGDA-glycerol suspended Janus droplets with a patchy structure were produced by utilizing solvent evaporation-induced droplet phase separation at the air-liquid interface. By altering the glycerol/PEGDA volume ratio, the initial proportion of ethanol, and the concentration of surfactants, suspended droplets with different morphologies can be achieved, which include filbert-shaped droplets (FSDs), half lotus seedpod single-phase Janus droplets (HLSDs), lotus seedpod single-phase Janus droplets (LSDs), lotus seedpod-shaped droplets (LSSDs), multiple-bulge droplets (MBDs), and half gourd-shaped droplets (HGSDs). A patchy structure was generated at the air-droplet interface, which was attributed to the Marangoni stresses induced by nonuniform evaporation. Furthermore, a modified spreading coefficient theory was constructed and verified to illustrate the phase separation at the air-droplet interface, which was the first research to predict the phase separation phenomena at the air-liquid interface via spreading coefficients theory. Moreover, we studied the factors that led to the droplets being able to float by designing the combined parameters, including three interfacial tensions and the equilibrium contact angles. Therefore, a simple and versatile strategy for creating suspended Janus droplets has been developed for the first time, which holds significant potential in a variety of applications for material synthesis, such as the electrospinning solution behavior when sprayed from the nozzle into the air.
RESUMO
Acute kidney injury (AKI) is a common and severe problem associated with high morbidity, mortality, and healthcare costs. There are no reliable therapeutic interventions except dialysis that could improve survival, limit injury, or speed up recovery. Thus, it is essential to develop new therapies to treat AKI. Previous studies revealed that histone deacetylase inhibitor (HDACi) could attenuate renal injury and enhance kidney recovery in AKI. However, the hydrophobic nature of HDACi, such as vorinostat (SAHA), requires organic solvents to promote its dissolution, leading to inevitable detrimental effects. Herein, calcium alginate microspheres (CAM) were prepared by the microfluidic method as HDACi carriers to treat AKI by intravenous injection. First, we designed the structure of the microfluidic channel for the fabrication of the PDMS microfluidic chip in which the emulsion state of droplets was analyzed. As the flow rate increases, the continuous phase changed from laminar flow to the dripping pattern in the microfluidic device. Then, the CAM was fabricated by a W/O microfluidic emulsion template and the size of the microspheres was adjusted from 3 to 7 µm by the concentration of alginate and the flow rate of the continuous phase and dispersal phase. The higher degree of cross-linking of sodium alginate with calcium ions would lead to longer drug release time but lower swelling rates. Furthermore, we selected CAM with suitable sizes as the HDACi carrier and delivered the HDACi-loaded CAM to the AKI mice by intravenous tail injection. The in vivo results showed that the HDACi-loaded CAM could effectively reduce the renal regional inflammatory response and attenuate renal injury.