Does the use of patient-specific instrumentation improve resource use in the operating room and outcome after total knee arthroplasty?-A multicenter study.

Patient-specific instrumentation (PSI) in total knee arthroplasty (TKA) has been introduced to reduce instruments and surgical time and to improve implant alignment. The aim of this study was to compare TKA with patient-specific and conventional instrumentation with regard to the use of resources in the operating room (OR), alignment and patient-reported outcome. A total of 139 TKA with PSI or conventional instrumentation were included in three centers. Economic variables of the surgery (number of instrument trays, setup and cut-sew-time), radiological alignment and patient reported outcomes (VAS Pain Scale, Oxford Knee Score, EQ-5D) were assessed after 6 weeks, 6 and 12 months. There was a significant reduction of instrument trays and of time in the OR in the PSI group. The reduction varied between the centers. With strict reorganization, more than 50% of the instrument trays could be reduced while using PSI. There were no significant differences in cut-sew-time, implant position, leg axis, pain and function. The use of PSI was associated with significantly less OR resources. However, the savings did not compensate the costs for this technology.

Revision of failed acetabular components utilizing a cementless oblong cup: an average 9-year follow-up study.

INTRODUCTION: Failure of acetabular components often leads to bone loss with extensive elongated defects in the surrounding bone. In these cases, reconstruction is challenging and stable fixation of the revision implant difficult. The use of an oblong cup has been described as an option for acetabular reconstruction in such revisions. We report the first long-term results obtained with this implant to date. MATERIALS AND METHODS: Fifty-six longitudinal oblong revision cups (LOR) were evaluated clinically and radiologically after a follow-up of 8-12 years (average 9 years). The defects treated with the LOR cup ranged from Paprosky type 1-3. Allogenic cancellous bone chips were additionally used in 31 reconstructions to fill cavitary defects. RESULTS: Based on radiological criteria, 50 acetabular implants underwent osseointegration without any definitive signs of loosening; 2 consistently exhibited zonal radiolucent lines that were always smaller than 2 mm, 1 migrated by around 3 mm. None of these cases exhibited any clinical symptoms. In 11 cases where acetabular defects manifested postoperatively, 8 were remodeled completely and 3 partially at final follow-up. Three revision implants migrated farther than 5 mm and had to be revised before 32-month follow-up. In addition, 1 septic implant failure occurred. After an average follow-up of 9 years, 93% of the investigated implants remained in situ without further revision and 95% without aseptic implant failure. CONCLUSION: This 12-year clinical study demonstrates that the LOR cup offers a successful concept for the revision of failed acetabular components that also promotes the biological reconstruction of bony defects. Compared with other methods with similarly long follow-ups, our long-term results prove this procedure has a very low rate of revision and aseptic implant failure.

Five- to 10-year results using a noncemented modular revision stem without bone grafting.

The aim of the study was to evaluate the 5- to 10-year results (mean, 6.2 years) of a modular uncemented revision stem (Profemur-R). From a total series of 184 consecutive stem revisions, the first 73 were evaluated. The implant was fixed without bone grafting in all cases. The average Harris hip score increased from 40 to 75. A complete remodeling of bone defects could be documented radiographically in 70% of the cases and a partial restoration in 30%. Progressive subsidence appeared in 2 stems. Three rerevisions were required, including 1 septic case. The survival rate with aseptic loosening as the end point was 96% over an average of 10 years. The revision prosthesis examined in this study can be considered a viable and useful option to reconstruct femoral defects in revision hip arthroplasty.

Metal-on-metal bearings and hypersensitivity in patients with artificial hip joints. A clinical and histomorphological study.

BACKGROUND: Some patients who have a total hip replacement with a second-generation metal-on-metal articulation have persistent or early recurrence of preoperative symptoms. Characteristic histological changes in the periprosthetic tissues suggested the development of an immunological response. Therefore, in order to determine the relevance of these symptoms, we performed a study of the clinical data and periprosthetic tissues associated with endoprostheses with a metal-on metal articulation that had been retrieved at revision. METHODS: Periprosthetic tissues as well as the clinical data on the patients were obtained from the first nineteen consecutive revisions performed at the treating hospitals. At the time of the revision, fourteen patients had the metal-on-metal articulation exchanged for either an alumina-ceramic or a metal-on-polyethylene articulation. Five patients received another second-generation metal-on-metal total joint replacement. Five-micrometer sections were prepared from the tissue samples, were stained with routine and immunohistochemical methods, and were examined histologically. Histological specimens from three groups of patients, two of which were treated with non-metal-on-metal implants, served as controls. RESULTS: The majority of patients had persistence of their preoperative pain or early recurrence of the pain after the original total hip replacement, and often a pronounced hip joint effusion had developed after the original replacement. Radiographic follow-up showed the development of radiolucent lines in five hips and of osteolysis in another seven hips. At the revision surgery, both the cup and the stem were found to be well fixed in nine patients. The characteristic histological features were diffuse and perivascular infiltrates of T and B lymphocytes and plasma cells, high endothelial venules, massive fibrin exudation, accumulation of macrophages with droplike inclusions, and infiltrates of eosinophilic granulocytes and necrosis. Only a few metal particles were detected. Immunohistochemical analysis demonstrated that the cellular reaction was still active. The patients who received another second-generation metal-on-metal articulation at the time of the revision had no decrease in symptoms. In the control group of tissues obtained at revisions of endoprostheses without cobalt, chromium, or nickel articulations, there were no similar signs of immune reactions. CONCLUSIONS: These histological findings support the possibility of a lymphocyte-dominated immunological response. Although the prevalence of this reaction is low, the persistence or early reappearance of symptoms, including a marked joint effusion and the development of osteolysis, after primary implantation may suggest the possibility of such a reaction.

Giant synovial osteochondromatosis of the acromio-clavicular joint in a child. A case report and review of the literature.

Primary intra-articular synovial chondromatosis represents an uncommon condition involving mainly the large joints predominantly of middle-aged adults. We herein document the first case of synovial chondromatosis affecting the acromio-clavicular joint of a 10-year-old girl, characterized by a solitary huge intra-articular osteochondromatous body (giant synovial chondromatosis) that had caused dislocation and deformation of the lateral portion of the clavicle. Successful surgical treatment consisted of removal of the osteochondral body and replacement of the clavicle by fixation with a K-wire.

Interface abrasion between rough surface femoral stems and PMMA cement results in extreme wear volumes--a retrieval study and failure analysis.

During the loosening cascade of cemented rough femoral stems, the destruction of the mantle and the production of cement and metal wear debris occur after the loss of constraint at the interface. Two-dimensional (2D) measurements (light microscopy based morphometry on fragments of mantles and vertical scanning interferometry of femoral stems) permitted mathematical 3D-extrapolations to estimate the wear volumes. Fragments of the cement mantles available lost volumes from 0.85 mm(3) to 494.10 mm(3) (median amount of bone cement wear = 178,426 mg). The harder metal surfaces lost between 1.459 mm(3) and 5.688 mm(3) of material (the median amount of metal wear per surface = 1.504 mg/100 mm(2)). Compared to the loss of material due to the fretting of stems, the abrasion of metal, and cement in defective cement mantles produced wear volumes sufficiently high to induce osteolysis. Though the design of the femoral stem and the handling of bone cement do not represent contemporary design and clinical practice, respectively, an extremely high number of joint replacements still in daily use may be impacted by this study because of possible predicted failures. Once the processes of fragmentation, abrasion, and osteolysis have been realized, the time until revision surgery should not be unduly prolonged.

Acupuncture treatment of chronic low-back pain -- a randomized, blinded, placebo-controlled trial with 9-month follow-up.

There is some evidence for the efficacy of acupuncture in chronic low-back pain (LBP), but it remains unclear whether acupuncture is superior to placebo. In a randomized, blinded, placebo-controlled trial, we evaluated the effect of traditional acupuncture in chronic LBP. A total of 131 consecutive out-patients of the Department of Orthopaedics, University Goettingen, Germany, (age=48.1 years, 58.5% female, duration of pain: 9.6 years) with non-radiating LBP for at least 6 months and a normal neurological examination were randomized to one of three groups over 12 weeks. Each group received active physiotherapy over 12 weeks. The control group (n=46) received no further treatment, the acupuncture group (n=40) received 20 sessions of traditional acupuncture and the sham-acupuncture group (n=45) 20 sessions of minimal acupuncture. Changes from baseline to the end of treatment and to 9-month follow-up were assessed in pain intensity and in pain disability, and secondary in psychological distress and in spine flexion, compared by intervention groups. Acupuncture was superior to the control condition (physiotherapy) regarding pain intensity (P=0.000), pain disability (P=0.000), and psychological distress (P=0.020) at the end of treatment. Compared to sham-acupuncture, acupuncture reduced psychological distress (P=0.040) only. At 9-month follow-up, the superiority of acupuncture compared to the control condition became less and acupuncture was not different to sham-acupuncture. We found a significant improvement by traditional acupuncture in chronic LBP compared to routine care (physiotherapy) but not compared to sham-acupuncture. The trial demonstrated a placebo effect of traditional acupuncture in chronic LBP.

Ceramic and PMMA particles differentially affect osteoblast phenotype.

There is increasing evidence that wear debris particles present in periprosthetic tissues have direct effects on osteoblasts. The nature of the cell response varies with the chemistry of the particle and the number of particles. Most studies have used Ti, Ti-6Al-4V, and ultrahigh molecular weight polyethylene (UHMWPE) particles since these materials are most frequently used in implants and as a result, these particles predominate in peri-prosthetic tissues. Ceramics have also been used successfully as load-bearing surfaces in implants for years, although it is unknown how wear debris from these surfaces may contribute to aseptic bone loss. Further, particles resulting from polymethylmethacrylate (PMMA) cements used for fixation may also be involved in aseptic loosening of implants, but how these particles may affect bone formation is unknown. In the present study, we examined whether aluminum oxide (Al2O3), zirconium oxide (ZrO2), and PMMA particles exert effects on osteoblast proliferation, phenotypic expression, and local factor production, and if so, whether the effects were specific to the particle type. ZrO2 particles were produced in a custom-made axial mixer in which ZrO2 containers were filled with ZrO2 bars and 95% ethanol and then rotated continuously at room temperature. PMMA particles were prepared in a ZrO2 roller mill. Al2O3 was produced and provided by Aesculap AG. Particles were endotoxin-free with equivalent circle diameters <3 microm; Al2O3 particles were significantly smaller than ZrO2 or PMMA particles. Particle suspensions were added to confluent cultures of MG63 osteoblast-like cells after diluting them 1:100, 1:10, and 1:1 with culture medium. Cells were incubated with the particles for 24 h. Transmission electron microscopy showed that MG63 cells phagocytosed Al2O3 particles and exhibited ultrastructural changes consistent with cytotoxicity. This was supported by biochemical changes as well. Proliferation, alkaline phosphatase activity, and TGF-beta1 levels were decreased. ZrO2 and PMMA particles increased proliferation and alkaline phosphatase specific activity. The effect of ZrO2 on alkaline phosphatase was targeted to matrix vesicles, the effect of PMMA was greater on the cells. All particles increased prostaglandin E2 production. These results show that Al2O3, ZrO2, and PMMA particles elicit direct effects on osteoblasts and that cell response depends on the particle type. None of the particles tested had the same effect as noted previously for UHMWPE: increased proliferation and decreased alkaline phosphatase. These results may indicate that the response of peri-prosthetic tissues to wear particles may be modulated by the relative contributions of the various particle types present.

Early results and patient satisfaction after total hip arthroplasty using a minimally invasive anterolateral approach.

Rehabilitation and patient satisfaction following a modified anterolateral approach for implantation of a total hip replacement (THR) were reviewed following 72 consecutive cases. The Harris Hip and Merle d'Aubigné Scores were recorded at 6 and 12 weeks postoperatively. The patient's satisfaction with regard to the surgical result and the need for analgesia for mobilization were recorded. Rehabilitation was assessed by postoperative crutch use.Significant improvements of the Harris Hip and Merle d'Aubigné scores were demonstrated. All patients thought their surgical outcome was good or better. 2 patients needed pain medicine on an irregular basis and 4 patients used crutches at 12 weeks. This study demonstrates patient satisfaction and satisfactory rehabilitation following a modified antero-lateral approach for minimally-invasive implantation of THR.