RESUMO
The temperature-dependent viscosity η(T) is measured for the equilibrium liquid of the chalcogenide Ag-In-Sb-Te (AIST), the first time this has been reported for a material of actual interest for phase-change memory. The measurements, in the range 829-1254 K, are made using an oscillating-crucible viscometer, and show a liquid with high fragility and low viscosity, similar to liquid pure metals. Combining the high-temperature viscosity measurements with values inferred from crystal growth rates in the supercooled liquid allows the form of η(T) to be estimated over the entire temperature range from above the melting point down to the glass transition. It is then clear that η(T) for liquid AIST cannot be described with a single fragility value, unlike other phase-change chalcogenides such as liquid Ge-Sb-Te. There is clear evidence for a fragile-to-strong crossover on cooling liquid AIST, similar to that analyzed in Te85Ge15. The change in fragility associated with the crossover in both these cases is rather weak, giving a broad temperature range over which η(T) is near-Arrhenius. We discuss how such behavior may be beneficial for the performance of phase-change memory. Consideration of the fragile-to-strong crossover in liquid chalcogenides may be important in tuning compositions to optimize the device performance.
RESUMO
Structural and calorimetric investigation of Ge(x)Te(100-x) films over wide range of concentration 10 < x < 50 led to evidence two structural singularities at x â¼ 22 at. % and x â¼ 33-35 at. %. Analysis of bond distribution, bond variability, and glass thermal stability led to conclude to the origin of the first singularity being the flexible/rigid transition proposed in the framework of rigidity model and the origin of the second one being the disappearance of the undercooled region resulting in amorphous materials with statistical distributions of bonds. While the first singularity signs the onset of the Ge-Ge homopolar bonds, the second is related to compositions where enhanced Ge-Ge correlations at intermediate lengthscales (7.7 Å) are observed. These two threshold compositions correspond to recently reported resistance drift threshold compositions, an important support for models pointing the breaking of homopolar Ge-Ge bonds as the main phenomenon behind the ageing of phase change materials.
RESUMO
We investigate the structure of liquid monotectic alloy Bi(30)Ga(70) above and below the critical point. The three-dimensional structure at 265 °C is modelled by means of the reverse Monte Carlo simulation technique using neutron and x-ray diffraction experimental data. It is shown that atomic segregation on the short-range scale exists in the liquid Bi(30)Ga(70) slightly above the critical temperature (T(C) = 262 °C). We present also the structure factors of Bi(30)Ga(70) liquid alloy under the critical point at 240 and 230 °C obtained with neutron diffraction to highlight the temperature effect in the atomic structure.
RESUMO
Atomic structures of Ge(25)Sb(15)S(60) and Ge(35)Sb(5)S(60) glasses are investigated in the gamma-irradiated and annealed after gamma-irradiation states by means of high-energy synchrotron x-ray diffraction technique. The first sharp diffraction peak (FSDP) is detected at around 1.1 A(-1) in the structure factors of both alloys studied. The FSDP position is found to be stable for radiation/annealing treatment of the samples, while the FSDP intensity shows some changes between gamma-irradiated and annealed states. The peaks in the pair distribution functions observed between 2 and 4 A are related to the Ge-S, Ge-Sb, and Sb-Sb first neighbor correlations and Ge-Ge second neighbor correlations in the edge-shared GeS(42) tetrahedra, and S-S and/or Ge-Ge second neighbor correlations in the corner-shared GeS(42) tetrahedra. Three mechanisms of the radiation-/annealing-induced changes are discussed in the framework of coordination topological defect formation and bond-free solid angle concepts.
RESUMO
A systematic and detailed investigation of the structure of As(x)Te(100-x) glasses (20
RESUMO
The structure of sputtered amorphous Ge(2)Sb(2)Te(5) was investigated by high energy x-ray diffraction, neutron diffraction and Ge-, Sb- and Te K-edge EXAFS measurements. The five datasets were modelled simultaneously in the framework of the reverse Monte Carlo simulation technique. It was found that apart from Te-Sb and Te-Ge bonds existing in the crystalline phases, Ge-Ge and Sb-Ge bonding is also significant in sputtered amorphous Ge(2)Sb(2)Te(5). According to our results, all components obey the '8-N' rule.
RESUMO
Glassy As(25)Si(40)Te(35) has been studied by x-ray and neutron diffraction as well as x-ray absorption spectroscopy (EXAFS) at As and Te K-edges. Simultaneous modelling of the four independent measurements by means of the reverse Monte Carlo (RMC) simulation technique allowed the separation of partial pair distribution functions and estimation of the corresponding coordination numbers. It is shown that the atomic structure of As(25)Si(40)Te(35) glass can be presented as a three-dimensional network of twofold coordinated Te, threefold coordinated As and fourfold coordinated Si atoms.
RESUMO
Density functional/molecular dynamics simulations have been performed to determine structural and other properties of amorphous Ag/Ge/S and Ge/S alloys. In the former, the calculations have been combined with experimental data (x-ray and neutron diffraction, extended x-ray absorption fine structure). Ag/Ge/As alloys have high ionic conductivity and are among the most promising candidates for future memristor technology. We find excellent agreement between the experimental results and large-scale (500 atoms) simulations in Ag/Ge/S, and we compare and contrast the structures of Ge/S and Ag/Ge/S. The calculated electronic structures, vibrational densities of states, ionic mobilities, and cavity distributions of the amorphous materials are discussed and compared with data on crystalline phases where available. The high mobility of Ag in solid state electrolyte applications is related to the presence of cavities and can occur via jumps to a neighbouring vacant site.
RESUMO
Metallic glasses (MGs) inherit their amorphous structure from the liquid state, which predetermines their ability to withstand high loads approaching the theoretical limit. However, the absence of slip systems makes them very sensitive to the type of loading and extremely brittle in tension. The latter can be improved by precipitation of ductile crystals, which suppress a catastrophic propagation of shear bands in a glassy matrix. Here we report a novel approach to obtain MG-matrix composites with tensile ductility by flash Joule heating applied to Cu47.5Zr47.5Al5 (at.%) metallic glass. This homogeneous, volumetric and controllable rapid heat treatment allows achieving uniformly distributed metastable B2 CuZr crystals in the glassy matrix. It results in a significant tensile strain of 6.8±0.5%. Moreover, optimized adjustment of the heat-treatment conditions enables tuning of microstructure to achieve desired mechanical properties.
RESUMO
Amorphous Ge(x)Te(100-x) alloys were obtained over a broad composition range (12 ≤ x ≤ 44.6) by thermal co-evaporation. Their structure was investigated by x-ray diffraction and extended x-ray absorption fine structure measurements. Experimental datasets were fitted simultaneously by the reverse Monte Carlo simulation technique. It is concluded that Te is mostly twofold coordinated and the majority of Ge atoms have four neighbours. The number of Ge-Ge and Te-Te bonds evolves monotonically with composition. Ge-Ge bonding can be observed already at x = 24 while Te-Te bonds can be found even in Ge44.6Te55.4. The models obtained by simulation show that the structure of compositions with x > 24 should be considered as a random covalent network but there is chemical ordering for x ≤ 24, exactly in the composition range where glasses can be obtained from the melt by fast quenching. The composition dependences of some physical properties also point to the connection between chemical short range order and the stability of the amorphous phase: while the glass transition temperature and microhardness increase monotonically with the composition, the thermal stability of the amorphous films goes through a maximum around x = 20-24.
Assuntos
Ligas/química , Germânio/química , Telúrio/química , Dureza , Temperatura Alta , Teste de Materiais , Tamanho da Partícula , Transição de Fase , Propriedades de Superfície , Temperatura de TransiçãoRESUMO
The structure of Ag-doped GeS3 glasses (0, 15, 20, 25 at.% Ag) was investigated by diffraction techniques and extended x-ray absorption fine structure measurements. Structural models were obtained by fitting the experimental datasets simultaneously by the reverse Monte Carlo simulation technique. It is observed that Ge has mostly S neighbours in GeS3, but Ge-Ge bonds appear already at 15% Ag content. Sulfur has ~2 S/Ge neighbours over the whole concentration range, while the S-Ag coordination number increases with increasing Ag content. Ag-Ag pairs can already be found at 15% Ag. The Ag-S mean coordination number changes from 2.17 ± 0.2 to 2.86 ± 0.2 between 15% and 25% Ag content. Unlike the As-S network in AsS2-25Ag glass, the Ge-S network is not fragmented upon Ag-doping of GeS3 glass.
RESUMO
The phase equilibria and the solidification behavior of ternary Co-Gd-Ti (Co ≤35 at.%) alloys have been investigated. The phase transformation and equilibria in the liquid phase were studied in situ for two alloys, Co30Gd35Ti35 and Co30Gd50Ti20, by combining electrostatic levitation of the samples with high-energy synchrotron x-ray diffraction (XRD) at elevated temperature. The XRD patterns with two diffuse maxima for molten Co30Gd35Ti35 give direct evidence for liquid-liquid phase separation in this composition. In contrast, no indication for phase separation in the Co30Gd50Ti20 alloy is detected. Coarsened microstructures, typical for the phase-separating systems, are observed for the Co30Gd35Ti35, Co25Gd37.5Ti37.5, Co10Gd45Ti45 and Co30Gd20Ti50 cast alloys. Our findings suggest that the stable miscibility gap of binary Gd-Ti extends into the ternary Co-Gd-Ti system (up to about 30 at.% Co). Thermodynamic calculations of the ternary Co-Gd-Ti system by the CALPHAD method are in good agreement with the experimental results.
RESUMO
The structure of Ge(5)As(x)Se(95-x) (x = 10, 20, 30, 38 at.%) and Ge(15)As(x)Se(85-x) (x = 10, 25, 34 at.%) glasses has been investigated by high-energy x-ray diffraction and extended x-ray absorption fine structure measurements. The experimental datasets have been modelled using the reverse Monte Carlo simulation technique. The model atomic configurations have been analysed in detail. It has been found that the homonuclear Ge-Ge, As-As, Se-Se and heteronuclear Ge-As bonds play an important role in the structure formation of the Ge-As-Se glasses. The total number of these bonds decreases quite slowly with the mean coordination number similarly to the nonlinear refractive index.
RESUMO
(Ge(0.2)Se(0.8))(100-x)In(x) and (Ge(0.17)Se(0.83))(100-x)In(x) (x = 0, 5, 10, 15 at.%) chalcogenide glasses have been studied with high-energy x-ray diffraction, neutron diffraction and extended x-ray absorption spectroscopy at Ge, Se and In K-edges. The experimental data were modelled simultaneously with the reverse Monte Carlo simulation method. GeSe(4/2) tetrahedra are shown to be the main structural units in the binary and ternary glasses investigated. Indium bonds to the excess Se atoms in the ternary Ge-Se-In glasses. While the majority of In atoms have three Se neighbours, some In atoms may be tetrahedrally coordinated by Se.
Assuntos
Germânio/química , Vidro/química , Índio/química , Método de Monte Carlo , Selênio/química , Simulação por Computador , Modelos Químicos , Espectroscopia por Absorção de Raios X , Difração de Raios XRESUMO
The structure of Zr(60)Cu(20)Fe(20) metallic glass has been studied with high-energy x-ray diffraction, neutron diffraction and extended x-ray absorption spectroscopy and modelled with the reverse Monte Carlo simulation technique. It is found that Cu and Fe atoms prefer Zr as a nearest neighbour. The mean interatomic distance between Cu/Fe and Zr atoms in the glass is remarkably shorter than the sum of the respective atomic radii. The coordination numbers for Cu/Fe-Cu/Fe pairs are very close to each other, suggesting a regular distribution of Cu and Fe atoms in the Zr(60)Cu(20)Fe(20) metallic glass.
Assuntos
Cobre/química , Vidro/química , Compostos de Ferro/química , Modelos Moleculares , Método de Monte Carlo , Difração de Nêutrons , Difração de Raios X , Zircônio/química , Simulação por Computador , Espectroscopia por Absorção de Raios XRESUMO
(As(0.4)S(0.6))(100-x)Ag(x) glasses (x = 0, 4, 8, 12 at.%) have been studied with high-energy x-ray diffraction, neutron diffraction and extended x-ray absorption spectroscopy at As and Ag K-edges. The experimental data were modelled simultaneously with the reverse Monte Carlo simulation method. Analysis of the partial pair correlation functions and coordination numbers extracted from the model atomic configurations revealed that silver preferentially bonds to sulfur in the As(2)S(3)-Ag ternary glasses, which results in the formation of homoatomic As-As bonds. Upon the addition of Ag, a small proportion of Ag-As bonds (N(AgAs)≈0.3) are formed in all three ternary compositions, while the direct Ag-Ag bonds (N(AgAg)≈ 0.4) appear only in the glass with the highest Ag content (12 at.%). Similar to the g- As(2)S(3) binary, the mean coordination number of arsenic is close to three, and that of sulfur is close to two, in the As(2)S(3)-Ag ternary glasses. The first sharp diffraction peak on the total structure factors of As(2)S(3) binary and (As(0.4)S(0.6))(100-x)Ag(x) ternary glasses is related to the As-As and As-S correlations.