Polychlorinated biphenyls (PCBs) in the Persian Gulf and Gulf of Oman: baseline report on occurrence, distribution, and ecological risk assessment.

In the present study, 18 polychlorinated biphenyl (PCB) compounds were measured in marine sediments collected from 49 offshore stations in the Persian Gulf and the Gulf of Oman in 2019. After the last oceanographic cruise in 2006, no study has been performed on the offshore sediments of this region, and this is the first study on the PCBs in this area. The total amount of PCB compounds in the sediment samples ranged from 74.38 ng kg-1 (near Abu Musa Island) to 1212.98 ng kg-1 (near Siri and Kish Island). The maximum and minimum values of the individual detected PCB compounds were 175.88 ng kg-1 (PCB52) and 2.09 ng kg-1 (PCB156), respectively. The levels of total PCBs detected in sediments were lower than the Canadian interim sediment quality guideline value of 21500 ng kg-1 for marine sediments. The sedimentary mass inventories for Σ18PCBs were 0.6 and 0.2 mt for the Persian Gulf and Gulf of Oman, respectively.

Distribution pattern and pollution status by analysis of selected heavy metal amounts in coastal sediments from the southern Caspian Sea.

Amounts of heavy metal elements (Zn, Cd, Pb, Cu, Ni, Co, Mn, and Fe) in surficial sediments at four regions (coastline, estuaries, rivers discharging into the sea, and Gorgan Bay) along the southern coastline of the Caspian Sea were investigated in summer 2015. Collected data was applied to appraise the sediment contamination degree and the origin of pollutants based on the Geo-accumulation Index. Pollution status was assessed via the Enrichment Factor (EF) and the Potential Ecological Risk Index (PERI, the Hakanson index). Heavy metal contents in sediments in mg g-1 dw varied from 3000 to 39,500 for Fe, 166.66 to 2000 for Mn, 11 to 4198 for Zn, not detected (ND) to 822.83 for Pb, ND to 40.66 for Cd, 6.16 to 37.16 for Cu, 11.66 to 69 for Ni, and 6.33 to 33.00 for Co. Higher amounts of Cd, Pb, Cu, Mn, and Fe were determined in rivers discharging sediments into the sea. In Gorgan Bay, Zn, Ni, and Co were highest. Greater potential ecological risk levels were detected along the coastline as well as rivers discharging into the sea. Among heavy metals considered, Zn and Cd had the highest enrichment factors. The Geo-accumulation Index proved that the investigated region could be classified as Zn- and Cd-polluted area.

Heavy metals and arsenic content in water along the southern Caspian coasts in Iran.

Due to the importance of pollution monitoring in marine ecosystems and lack of a coherent and systematic investigation of heavy metal ions along the southern shores of the Caspian Sea, in the present study, the amount of these metals and As ions in coastal waters along its 780-km-long coast in Iran have been studied. Heavy metals (cobalt, nickel, copper, zinc, cadmium, mercury, lead) and a poisonous metalloid (arsenic) were selected in 59 sampling stations and determined using differential pulse polarography method. The multivariate statistical tools were applied to describe and interpret the experimental data. The overall mean concentrations of studied metals (in microgram per liter; µg L-1) in the samples were found in the order Zn (10.9) > Ni (7.4) > Cu (5.5) > Pb (1.9) > Hg (1.4) > As (1.3) > Co (1.1) > Cd (0.2). The results when compared with reported international standards confirmed that the sampled waters do contain some of these elements above the suggested maximum permissible limits. Hg and Cu were detected in 54.2 and 72.9% of the samples, almost all above the permissible limits. Ni, Zn, Pb, and Co were detected in 100, 96.6, 93.2, and 88.1%, respectively, while 8.5, 22.0, 3.4, and 1.7% were above the permissible limits. Cd and As were present in 61 and 93% of the samples, and their concentrations were higher than the rate presented by Russian System of Management Chemicals (RSMC). In addition, spatial distribution of heavy metal concentrations showed that Gorgan Bay is an ecosystem serving as a filter, trapping natural and anthropogenic materials that are brought from industrial, commercial, and urbanized areas. The multivariate data analysis reveals that Caspian Sea is contaminated by both anthropogenic as well as pedo-geochemical sources.