RESUMO
OBJECTIVES: To evaluate the survival rate of minimally invasive semipermanent occlusal polymethylmethacrylate (PMMA) onlays/veneers in previous temporomandibular disorder (TMD) patients with severe tooth wear and with a loss of vertical dimension after up to 7 years. METHOD AND MATERIALS: This case series was designed as a follow-up evaluation with consecutive patient recruitment. All patients bearing the indication for this kind of rehabilitation were treated by the same clinician using the same adhesive methodology. The study included 22 patients (3 males/19 females), with a mean [SD] age of 50.7 [11.6] years. Controls followed within the first 4 weeks (and subsequently as required). Failure criteria included damage by fracture, chipping, and retention loss. Survival rates were determined based on the Kaplan-Meier analysis. RESULTS: 328 semipermanent occlusal/incisal veneers were included (142 maxillary/186 mandibular teeth). Almost 80% of the restorations were in place and in function when starting the follow-up treatment after 180 days; failures predominantly occurred within the first 3 to 6 months but proved reparable. Depending on the patients' priorities, scheduled replacements followed successively, and more than 65% did not show repair or any renewal needs for more than 360 days. CONCLUSION: Within the limitations of this study the survival rates of occlusal veneers made of PMMA were sufficiently high to allow for consecutive treatment of the respective teeth by means of permanent restorations while preserving the restored vertical dimension. In patients with severe tooth wear and a TMD history, semipermanent restorative therapy with occlusal PMMA onlays/veneers would seem a noteworthy option.
RESUMO
This preregistered ex vivo investigation examined the dentinal hybrid layer formation of a resinous infiltrant (Icon), with reference to both thickness (HLT) and homogeneity when combined with modified tunnel preparation (occlusal cavity only) and internal/external caries infiltration. The adhesives Syntac and Scotchbond MP were used as controls (Groups 1 and 3) or in combination with Icon (Groups 2 and 4). A split-tooth design using healthy third molars from 20 donors resulted in 20 prepared dentine cavities per experimental group. The cavity surfaces (n = 80) were etched (37% H3PO4), rinsed, and air-dried. Rewetting with ethanol was followed by application of the respective primers. After labeling with fluorescent dyes, either Syntac Adhesive/Heliobond or Scotchbond MP Adhesive was used alone or supplemented with Icon. HLT, as evaluated by scanning electron microscopy, did not significantly differ (P > 0.05), and confocal laser scanning microscopy revealed homogeneously mixed/polymerized resin-dentine interdiffusion zones in all groups. Icon can be successfully integrated into an ethanol-wet dentine bonding strategy, and will result in compact and homogeneous hybrid layers of comparable thickness considered equivalent to the non-Icon controls, thus allowing for preservation of the tooth's marginal ridge and interdental space in the case of internal/external infiltration of proximal caries.