Dynamic focus shaping with mixed-aperture coherent beam combining.

A novel concept for dynamic focus shaping based on highly efficient coherent beam combining with micro-lens arrays (MLAs) as the combining element is presented. This concept allows us to control the power weights of diffraction orders by varying the absolute phases of an array of input beams. A proof-of-principle experiment is supported by simulations. For this, an input beam matrix of 5×5 beams is combined proving both the ability for further power scaling and dynamic focus shaping.

Thin-disk laser system operating above 10 kW at near fundamental mode beam quality.

We report on a thin-disk laser system with more than 10 kW of output power and a beam quality of M2=1.76 at an overall optical-to-optical efficiency of 51%. The system consists of two thin-disk laser oscillators and a thin-disk multi-pass amplifier system. To reach high output powers while maintaining good beam quality, the output beams of two identical laser oscillators are polarization-combined. Subsequently, the beam is amplified in a multi-pass system. To the best of our knowledge, this is the highest output power achieved for a thin-disk laser system with a beam quality close to fundamental mode.

Ultrafast thin-disk multi-pass amplifier system providing 1.9 kW of average output power and pulse energies in the 10 mJ range at 1 ps of pulse duration for glass-cleaving applications.

An ultrafast Yb-doped thin-disk multi-pass laser amplifier system with flexible parameters for material processing is reported. We can generate bursts consisting of four pulses at a distance of 20 ns and a total energy of 46.7 mJ at a repetition rate of 25 kHz. In single-pulse operation, 1.5 kW of average output is achieved at 400 kHz when optimizing for a beam quality of M2 = 1.5. Alignment for maximum output power provides 1.9 kW at the same repetition rate. All results are obtained without chirped-pulse amplification in the multi-pass set-up. The application potential of the system is demonstrated exploring its performance in materials processing of dielectrics. Cleaving of 3.8-mm-thick SCHOTT borofloat glass with a velocity of 1200 mm/s is demonstrated with 300 W of input power. Single-pass modification of 30 mm borosilicate glass is enabled with a Bessel beam at 1 kW of average power delivered by four-pulse bursts of an energy of 30 mJ.

Coherent beam combining with micro-lens arrays.

A novel, to the best of our knowledge, concept for coherent beam combining is presented based on a simple setup with micro-lens arrays. These standard components are used in a proof-of-principle experiment for both coherent beam splitting and a combination of 5×5 beams. Here a combination efficiency above 90% is achieved. We call this novel concept "mixed aperture."

Ultrafast green thin-disk laser exceeding 1.4 kW of average power.

We present an ultrafast laser with a near-diffraction-limited beam quality delivering more than 1.4 kW of average power in the visible spectral range. The laser is based on second harmonic generation in a lithium triborate crystal of a Yb:YAG thin-disk multipass amplifier emitting more than 2 kW of average power in the infrared.

Ultrafast thin-disk multipass laser amplifier delivering 1.4 kW (4.7 mJ, 1030 nm) average power converted to 820 W at 515 nm and 234 W at 343 nm.

We report on an Yb:YAG thin-disk multipass laser amplifier delivering sub-8 ps pulses at a wavelength of 1030 nm with 1420 W of average output power and 4.7 mJ of pulse energy. The amplifier is seeded by a regenerative amplifier delivering 6.5 ps pulses with 300 kHz of repetition rate and an average power of 115 W. The optical efficiency of the multipass amplifier was measured to be 48% and the beam quality factor was better than M2 = 1.4. Furthermore we report on the external second harmonic generation from 1030 nm to 515 nm using an LBO crystal leading to an output power of 820 W with 2.7 mJ of energy per pulse. This corresponds to a conversion efficiency of 70%. Additionally, 234 W of average power were obtained at the third harmonic with a wavelength of 343 nm.

1.1 kW average output power from a thin-disk multipass amplifier for ultrashort laser pulses.

We report on a thin-disk multipass amplifier for ultrashort laser pulses delivering an average output power of 1105 W. The amplifier was seeded by a Trumpf TruMicro5050 laser with a power of 80 W at a wavelength of 1030 nm, pulse duration of 6.5 ps, and repetition rate of 800 kHz. The energy of the amplified pulses is 1.38 mJ with a duration of 7.3 ps. The amplifier exhibits an optical efficiency of 44% and a slope efficiency of 46%. The beam quality was measured to be better than M²=1.25.

Mode-locked Yb:YAG thin-disk oscillator with 41 µJ pulse energy at 145 W average infrared power and high power frequency conversion.

We demonstrate the generation of 1.1 ps pulses containing more than 41 µJ of energy directly out of an Yb:YAG thin-disk without any additional amplification stages. The laser oscillator operates in ambient atmosphere with a 3.5 MHz repetition rate and 145 W of average output power at a fundamental wavelength of 1030 nm. An average output power of 91.5 W at 515 nm was obtained by frequency doubling with a conversion efficiency exceeding 65%. Third harmonic generation resulted in 34 W at 343 nm at 34% efficiency.

Improving the brightness of a multi-kilowatt single thin-disk laser by an aspherical phase front correction.

We report on results obtained with an aspherical mirror to compensate for the phase front aberrations of a cw thin-disk laser with a single disk in the resonator. A record output power of 5 kW with a beam quality suitable for laser cutting (beam propagation factor M2=9.2) has been achieved.

Subpicosecond thin-disk laser oscillator with pulse energies of up to 25.9 microjoules by use of an active multipass geometry.

The pulse shaping dynamics of a diode-pumped laser oscillator with active multipass cell was studied experimentally and numerically. We demonstrate the generation of high energy subpicosecond pulses with a pulse energy of up to 25.9 microJ at a pulse duration of 928 fs directly from a thin-disk laser oscillator. These results are achieved by employing a selfimaging active multipass geometry operated in ambient atmosphere. Stable single pulse operation has been obtained with an average output power in excess of 76 W and at a repetition rate of 2.93 MHz. Self starting passive mode locking was accomplished using a semiconductor saturable absorber mirror. The experimental results are compared with numerical simulations, showing good agreement including the appearance of Kelly sidebands. Furthermore, a modified soliton-area theorem for approximating the pulse duration is presented.

Generation of few-cycle pulses directly from a MHz-NOPA.

We demonstrate the generation of 10-fs-pulses from a noncollinear optical parametric amplifier (NOPA). The NOPA is driven by microjoule pulses from a directly diode pumped Yb:KYW oscillator with cavity-dumping.

Diode-pumped, ultrafast, multi-octave supercontinuum source at repetition rates between 500 kHz and 20 MHz using Yb:glass lasers and tapered fibers.

We present a compact, all diode-pumped supercontinuum source based on a SESAM mode-locked Yb:glass oscillator at 1040 nm and a tapered fiber. The oscillator has a repetition rate of 20 MHz, a pulse duration of 200 fs, and a maximum pulse energy of about 15 nJ. This system delivers an 1100 nm broad spectrum with an output power of more than 100 mW. Decreasing the repetition rate to 500 kHz by cavity-dumping results in a supercontinuum with a high pulse energy of about 50 nJ. Furthermore, using the frequency-doubled output of this laser at 520 nm with 300 fs pulse duration resulted in supercontinua in the near-UV and visible spectral region. We compare the experimental spectra with theoretical simulations.

High speed electro-optical cavity dumping of mode-locked laser oscillators.

High speed electro-optical cavity dumping is demonstrated with diode-pumped mode-locked laser oscillators, namely a femtosecond Yb:glass and a picosecond Nd:YVO4 oscillator. Repetition frequencies exceeding 1MHz are obtained with pulse energies of more than 300nJ /1 microJ. Being compact and easy to operate light sources, these laser systems open up various scientific and industrial applications.

Solitary pulse shaping dynamics in cavity-dumped laser oscillators.

The pulse shaping dynamics of a diode-pumped laser oscillator with cavity dumping operating in the solitary regime is studied experimentally and numerically. The stability of the laser system is investigated in dependence on the relevant laser parameters. With a stroboscopic detection technique the intracavity temporal and spectral pulse profiles are measured between two dumping events. The results are compared to the numerical analysis of the system. Due to the strong periodic disturbance of the solitary pulse imposed by the dumping process a second set of Kelly-side bands can be identified.

Period doubling and deterministic chaos in continuously pumped regenerative amplifiers.

Multi-energy and chaotic pulse energy output from a continuously pumped regenerative amplifier is observed for dumping rates around the inverse upper state lifetime of the gain medium. The relevant regimes of operation are analyzed numerically and experimentally in a diode-pumped Yb:glass regenerative amplifier. The boundaries between stable and unstable pulsing are identified and stability criteria in dependence on the amplifier gate length and pump power are discussed.

High-repetition-rate picosecond pump laser based on a Yb:YAG disk amplifier for optical parametric amplification.

We report an optically synchronized picosecond pump laser for optical parametric amplifiers based on an Yb:YAG thin-disk amplifier. At 3 kHz repetition rate, pulse energies of 25 mJ with 1.6 ps pulse duration were achieved with an rms fluctuation in pulse energy of <0.7% by utilizing a broadly intermittent single-energy regime in the deterministic chaos of a continuously pumped regenerative amplifier.

Passively mode-locked Yb:YAG thin-disk laser with pulse energies exceeding 13 microJ by use of an active multipass geometry.

We demonstrate the generation of high-energy picosecond pulses directly from a thin-disk laser oscillator by employing a self-imaging active multipass geometry. Stable single-pulse operation has been obtained with an average output power in excess of 50 W, excluding a cw background of 8%, at a repetition rate of 3.8 MHz. Self-starting passive mode locking was accomplished using a semiconductor saturable absorber mirror. The maximum pulse energy was 13.4 microJ at a pulse duration of 1.36 ps with a time-bandwidth product of 0.34. Single-pass external frequency doubling with a conversion efficiency of 60% yielded >28 W of average power at 515 nm.

Megahertz optical parametric amplifier pumped by a femtosecond oscillator.

We demonstrate, for the first time to our knowledge, an optical parametric amplifier directly pumped by a femtosecond oscillator. Wavelength-tunable pulses in the ranges 0.65-0.85 microm (signal) and 1.4-2.5 microm (idler) are generated at a repetition frequency of 1 MHz. For pumping the beta-barium borate crystal we use a microjoule Yb:KY(WO4)2 femtosecond oscillator with cavity dumping. Pulses with 30 nJ of energy and a duration of 16 fs are achieved from a supercontinuum seed generated in a sapphire plate.

High-peak-power pulses from a cavity-dumped Yb:KY(WO4)2 oscillator.

We report generation of 1.35 microJ femtosecond laser pulses with a peak power of 3 MW at 1 MHz repetition rate from a diode-pumped Yb:KY(WO4)2 laser oscillator with cavity dumping. By extracavity compression with a large-mode-area fiber and a prism sequence, we generate ultrashort pulses with a duration of 21 fs and a peak power of 13 MW.

Optical waveguide writing with a diode-pumped femtosecond oscillator.

Optical waveguide writing is demonstrated by means of a diode-pumped cavity-dumped Yb:glass femtosecond laser oscillator with a pulse energy of 270 nJ at a 166-kHz repetition rate. Waveguides realized on an Er:Yb-doped phosphate glass are almost perfectly mode matched to standard single-mode fibers at 1.55 microm and show a 1.2-dB net gain in a standard telecommunications amplifier setup. Waveguide writing with a compact femtosecond laser oscillator is an important step toward introducing this technique into an industrial context.