Opening and closure characteristics of different types of stented biological valves.

BACKGROUND: In an increasingly senescent population stented biological valves have regained renewed popularity because of the absence of anticoagulation, while the stented design allows for safe and easier implantation. Constructed bovine pericardial valves as well as valves with porcine cusps are used, both of which exhibit good clinical results although degeneration still appears. While clinical hemodynamic studies did not show particular differences between both valves types, the opening and closure behavior of native cusps and artificially constructed pericardial leaflets is different. It is unclear whether these phenomena account for differences in load and stress which may influence onset and course of degeneration. MATERIAL AND METHODS: Edwards Perimount (EP) and Medtronic Mosaic (MM) heart valves with diameters of 21 mm, 23 mm, and 25 mm were investigated in a pulse duplicator. Movements of the valves were visualized with a high-speed camera (1000 frames/sec). Mean transvalvular gradient (mm Hg), dissipated power (mW), and power transfer by stretching (mW), mean orifice area (mm2), opening time (ms), and closure time (ms) were analyzed in a range of cardiac outputs from 1.4 l/min to 6.3 l/min and 70 beats per minute. RESULTS: Closure times were generally longer than opening times for both valve types. Opening time of EP valves was longer than opening time of the MM valves of the same size (EP23: 31.2 +/- 2.5 ms; MM23: 12.7 +/- 0.1 ms). With respect to closure times, however, there were no marked differences between all valves (EP23: 69.3 +/- 2.0 ms; MM23: 63.2 +/- 6.3 ms). Smaller sized Perimount valves exhibited lower mean transvalvular gradients than Mosaic valves of the same size (EP23: 7.21 +/- 0.07 mm Hg; MM23: 10.5 +/- 0.15 mm Hg). In larger sizes these differences diminished. Power transfer to the valve's structures was significantly enhanced in EP valves (EP23: 134 +/- 1.3 mW; MM23: 64 +/- 0.9 mW). CONCLUSIONS: While valves with constructed pericardium showed lower mean transvalvular gradients, particularly in the smaller sizes, this valve type exhibited alterations of movement performance in contrast to porcine valves. It can be speculated that constant power transfer to the valve's structures may result in an earlier degeneration because of the impact of the increased load and stress on the suspension apparatus of the constructed pericardial leaflets.

Different tilting disc valves show similar rotation-dependent impairment in hemodynamic performance under a tilted implantation position.

BACKGROUND: Aortic annulus calcification can promote tilted implantation of mechanical valves. This study evaluates the hemodynamics of tilting disc valves under this condition. METHODS: 23 mm and 25 mm Ultracor (UC) and Medtronic-Hall-Easy-Fit (MH) valves were investigated in a pulse-duplicator under physiological conditions. Mean pressure gradient (dP(mean)), systolic energy loss (dW(sys)), effective orifice area (EOA), closure (V(Cl)), leakage (V(L)), and total regurgitation volume (V(R)) were assessed. Valves were independently positioned at five axial rotations (0 - 180 degrees , zero defined as major orifice facing the top of the "tilt-ramp") and three tilt angles (0 degrees, 10 degrees, 20 degrees) by lifting the prosthesis in the noncoronary sinus. RESULTS: Diameter-enhanced MH valves exhibited a better systolic performance but a higher regurgitation than corresponding UC valves. Moderate tilting showed a rotation-independent increase in dP(mean) and dW(sys) and a decrease in V (R) and EOA with no fundamental differences between valve types. Further tilting caused small additional changes at 90 - 180 degrees rotation. At 0 degrees rotation, however, dramatic regurgitation occurred throughout. CONCLUSION: Tilting worsened systolic performance regardless of valve type. It should therefore be avoided. Due to extensive regurgitation at 0 degrees rotation, this position should be corrected whenever tilting is inevitable.