[Species of Iron in Size-resolved Particle Emitted from Xuanwei Coal Combustion and Their Oxidative Potential].

Many reports have claimed that high lung cancer mortality rate in Xuanwei is associated with the residential coal combustion. Considering iron is the main chemical element in the particles emitted from Xuanwei coal combustion, and especially, reactive oxygen species (ROS) could be generated by redox-active transition metals (TM) such as iron (Fe) in particles, therefore, raw coal samples from 4 coal mines in Xuanwei were sampled, and size-resolved particles emitted from the raw coal samples were collected by using of Andersen Five-stage High Volume Sampler. Species of iron in the raw coal sample, size-resolved particles and bottom ashes were analyzed by BCR sequential extraction method (community bureau of reference, BCR). The generation potential of·OH free radicals from coal emission particles in the surrogate lung fluid (SLF) solution was measured by using high pressure liquid chromatography (HPLC). Our results demonstrated that a large fraction of oxidizable Fe could be found in raw coal samples. However, the acid extractable, reducible and oxidizable fractions of Fe in the fly ash particles accounted for a large proportion (46%-78%) in the size-resolved particles after coal combustion. There was difference in levels of·OH free radicals generated from coal emission particles in the SLF for 24 hours among particles with different sizes. The concentration of·OH increased in both fine particles (<1 µm, 1.1-2 µm, 2-3.3 µm) and coarse particles (3.3-7 µm, >7 µm) as the particles size decreased. Linear correlation could be found between the oxidizable fractions of iron and the generation of·OH in particles emitted from coal combustion (R2=0.32).

Mineralogical characterization of airborne individual particulates in Beijing PM10.

This work mainly focuses on the mineralogical study of particulate matter (PM10) in Beijing. Samples were collected on polycarbonate filter from April, 2002 to March, 2003 in Beijing urban area. Scanning electronic microscopy coupled with energy dispersive X-ray (SEM/EDX) was used to investigate individual mineral particles in Beijing PM10. 1454 individual mineral particulates from 48 samples were analysed by SEM/EDX. The results revealed that mineral particulates were complex and heterogeneous. 38 kinds of minerals in PM10 were identified. The clay minerals, of annual average percentage of 30.1%, were the main composition among the identified minerals, and illite/smectite was the main composition in clay minerals, reaching up to 35%. Annual average percentage of quartz, calcite, compound particulates, carbonates were 13.5%, 10.9%, 11.95%, 10.31%, respectively. Annual average percentage less than 10% were gypsum, feldspar, dolomite, and so on. Fluorite, apatite, halite, barite and chloridize zinc (ZnCl2) were firstly identified in Beijing PM10. Sulfurization was found on surface of mineral particles, suggested extensive atmospheric reaction in air during summer.

[Distribution Characteristics of Heavy Metals in the Street Dusts in Xuanwei and Their Health Risk Assessment].

Relationship between high lung cancer incidence in Xuanwei residents and environmental pollution has been a hot topic in the field of environmental sciences. Street dusts in Xuanwei power plant area as well as its upwind area (Banqiao town) and downwind area (Laibin town, Tangtang town) were collected. Chemical elements in the street dust samples were investigated using ICP-MS. Health risk assessment of heavy metals in the street dusts was carried out using the US EPA Health Risk Assessment Model. Our results showed that the mass level of Al, V, Ni, Co, Zn and Cd in street dusts followed the order of Xuanwei power plant > Laibin town > Tangtang town. The mean concentrations of V, Cd, Cr, Cu, Mn, Co, Ni, Pb, As and Zn were all higher than the background values in Yunnan soil, indicating that the street dusts of Xuanwei city have been heavily polluted by those metals. The health risk assessment results showed that the non-cancer hazard risks induced by the 10 heavy metals were higher to children compared to adults. The heavy metals in street dust were mainly ingested by human bodies through hand-mouth ingestion. The 5 carcinogenic metals, including Cd, Cr, Ni, Cr and As, had a potential risk of carcinogenicity in human after exposed to the dusts. Cr was the major toxic element to the local children's health.

Comparison between Doppler echocardiography and hot-film anemometry in measuring the turbulent shear stress downstream of artificial mitral valves: a methodological study.

BACKGROUND: Turbulent shear stress (TSS) plays an important role in the research of fluid dynamics of heart valves. This study aimed to perform a quantitative study of TSS downstream of porcine artificial mitral valves in order to verify the correlation of hot-film anemometry (HFA) and Doppler echocardiography combined with computer-aided image analysis for the detection of TSS. METHODS: A porcine model of mitral valve replacement was established. HFA and Doppler ultrasound techniques were used to directly and indirectly measure TSS-relevant parameters of the artificial mitral valve following different mitral valve replacements: different approaches were used to reserve the subvalvular apparatus of the mitral valve. A correlation analysis was then carried out. RESULTS: There was a significant correlation between the HFA and Doppler ultrasound combined with computer-aided image analysis of the TSS at the same time and at the same site. No significant difference was found in the TSS measured by the two methods. CONCLUSIONS: Compared with HFA, Doppler echocardiography combined with computer-aided image analysis is a safe, non-invasive, and real-time method that enables accurate and quantitative detection of TSS downstream in vivo, objectively reflecting the flow field downstream of the artificial mitral valve. Doppler ultrasound combined with computer-aided image analysis can be employed for quantitatively evaluating the downstream hemodynamic performance of the mitral valve.

Surface derivatization state of polystyrene latex nanoparticles determines both their potency and their mechanism of causing human platelet aggregation in vitro.

There is evidence that nanoparticles (NP) can enter the bloodstream following deposition in the lungs, where they may interact with platelets. Polystyrene latex nanoparticles (PLNP) of the same size but with different surface charge-unmodified (umPLNP), aminated (aPLNP), and carboxylated (cPLNP)-were used as model NP to study interactions with human blood and platelets. Both the cPLNP and the aPLNP caused platelet aggregation, whereas the umPLNP did not. Whereas cPLNP caused aggregation by classical upregulation of adhesion receptors, aPLNP did not upregulate adhesion receptors and appeared to act by perturbation of the platelet membrane, revealing anionic phospholipids. Neither oxidative stress generation by particles nor metal contamination was responsible for these effects, which were a result of differential surface derivatization. The study reveals that NP composed of insoluble low-toxicity material are significantly altered in their potency in causing platelet aggregation by altering the surface chemistry. The two surface modifications, aminated and carboxylated, that did cause aggregation did so by different mechanisms. The study highlights the fundamental role of surface chemistry on bioactivity of NP in a platelet activation model.

[Perspectives on synergic biological effects induced by ambient allergenic pollen and urban fine/ultrafine particulate matters in atmosphere].

Ambient particulate matters (PM) and allergenic pollens in urban atmosphere have taken negative effects on human health and air quality. Studies on synergistic effects between the two pollutants are being focused in disciplines, such as atmospheric sciences, environmental toxicology, and immunology. In this study, physicochemical characterization of airborne fine/ultrafine particles in Shanghai, China and ambient allergenic pollens (cedar) in Kanto, Japan were investigated. We found that allergenic protein particles (Ubisch body) with diameter less than 0.7 microm were absorbed on Japanese cedar pollen, and airborne particles which contained allergenic particles mainly distributed in < 1 microm size range. The highest mass concentration of chemical elements in Shanghai airborne particles was found in the 0.3-0.18 microm size range, but mass level of pollutant elements, such as S and Pb, in ambient in ultrafine (nano) particles were higher than that in coarse and fine particles. And also, pollen particles were found in Shanghai airborne particles. Synergistic effects between diesel exhaust particles (DEPs), which were the main component in urban airborne particles, and ambient pollens in urban atmosphere can be found, but their mechanism have not been clear. After our new results and other conclusions published recently on allergenic pollen and airborne fine/ultrafine particles were summarized, perspectives of this new discipline were presented.

[Physicochemistry and bioreactivity characterization of fine particles (PM(2.5)) in Shanghai air].

PM(2.5) was collected at Shanghai urban and suburban sites during spring and autumn. PIXE (Proton Induced X-ray Emission) was used to investigate mass concentration of 15 elements (S, K, Ca, Ti, Cr, Mn, Fe, Ni, Cu, Zn, As, Se, Br, Sr, Pb) in Shanghai PM(2.5). The total mass concentration of the 15 chemical elements was higher in spring (5 038.6 ng x m(-3)) than in summer (3 810.6 ng x m(-3)). In spring, mass concentrations of these elements in urban and suburban samples were in the same level. In summer, concentration of the elements in urban samples were lower than in suburban samples, however, the elements which were originated from anthropogenic resources were in higher level in urban samples. The results of FESEM showed that Shanghai PM(2.5) was consisted of soot aggregates, coal fly ashes, minerals, bio-particles and unidentified particles. The result of Plasmid DNA assay demonstrated bioreactivity of urban PM(2.5) was more reactive than that of suburban PM(2.5), this phenomenon probably was explained by higher mass level of heavy metals and more proportion of soot aggregates in urban PM(2.5).