Metallic glass coating for improved needle tattooing performance in reducing trauma: analysis on porcine and pig skins.

The dissemination of tattooing into mainstream culture has raised concerns pertaining to the medical implications of these practices. This paper reports on the coating of tattoo needles with metallic-glass (MG) to reduce trauma to the skin. Extensive experimentation using pork samples and live pigs demonstrated the beneficial effects of non-stick MG coatings. Following 30 insertions into pork skin, significantly less tissue adhered to the MG-coated needles than to uncoated needles. MG-coated needles were also shown to reduce the spread of pigment to the surface of surrounding skin by up to 57%. This resulted in narrower tattoo lines of higher density, indicating that MG-coated needles could be useful in high-resolution tattooing. Histopathological analysis on live pigs revealed severe trauma induced by bare needles, as indicated by the secretion of fluids immediately after tattooing. The wounds formed by coated needles closed within 2 h after tattooing; however, those formed by bare needles remained open for at least 2 h and inflammation was still observed after 3 days. At 5 days after tattooing, skin punctured by the coated needle was entirely healed, whereas skin punctured by the bare needle was still covered with scabs. In addition to the medical benefits, it appears that MG-coated needles could improve the quality of tattoos, based on the fact that the amount of pigment retained in the skin is inversely proportional to the trauma caused by needles.

Coating Cutting Blades with Thin-Film Metallic Glass to Enhance Sharpness.

In this study, we sought to enhance the cutting properties of the various blades by coating them with Zr- and Fe-based thin film metallic glasses (TFMGs) to a thickness of 234-255 nm via sputter deposition. In oil-repellency/sliding tests on kitchen blades, the sliding angle and friction forces were as follows: bare blades (31.6°) and (35 µN), Ti-coated blades (20.3°) and (23.7 µN), and Z-TFMG coated blades (16.2°) and (19.2 µN). Comparisons were conducted with bare blades and those with a Teflon coating (a low-friction material commonly used for the coating of microtome blades). We also found that the Teflon coating reduced the cutting forces of an uncoated microtome blade by ~80%, whereas the proposed Z-TFMG achieved a ~51% reduction. The Z-TFMG presented no indications of delamination after being used 30 times for cutting; however, the Teflon coating proved highly susceptible to peeling and the bare blade was affected by surface staining. These results demonstrate the efficacy of the TFMG coating in terms of low friction, non-stick performance, and substrate adhesion. The performance of Z-TFMG and F-TFMG was also evaluated in split-thickness skin graft surgery using dermatome blades aimed at elucidating the influence of TFMG coatings on the healing of surgical incisions. When tested repeatedly on hairless skin, the surface roughness of uncoated blades increased by approximately 70%, whereas the surface roughness of TFMG-coated blades increases by only 8.6%. In the presence of hair, the surface roughness of uncoated blades increased by approximately ~108%, whereas the surface roughness of TFMG-coated blades increases by only ~23%. By Day 7, the wounds produced using TFMG-coated blades were noticeably smaller than those produced using uncoated blades, and these effects were particularly evident in hairy samples. This is a clear demonstration of the efficacy of TFMG surface coatings in preserving the cutting quality of surgical instruments.