Development of Uniform Polydimethylsiloxane Arrays through Inkjet Printing.

The inkjet printing method is a promising method to deposit polymer and functional nanoparticles at the microscale. It can be applied in the fabrication of multicolor polymer light emitting diodes (polyLEDs), polymer base electronics, multicolor color conversion layers, and quantum dot light emitting diodes (QLEDs). One of the main challenges is to print high-resolution polymer dots from dilute polymer solution. In addition, the quality of printed multicolor polyLEDs, QLEDs and multicolor color conversion layers is currently limited by non-uniformity of the printed dots. In this paper, polydimethylsiloxane (PDMS) is selected as the functional polymer, due to its high transparency, good reflective index value, inflammable and flexible properties. The optimal ink to form a uniform PDMS dot array is presented in this paper. Both the solvent and PDMS were tuned to form the uniform PDMS dot array. The uniform PDMS dot array was printed with a diameter of around 50 µm, and the array of closely spaced green quantum dots (QDs) mixed with PDMS ink was also printed on the substrate uniformly. While the green QD-PDMS film was printed at a resolution of 1693 dpi, the uniformity was evaluated using the photoluminescence (PL) spectrum and color coordinate value.

Characterization and Evaluation of 3D-Printed Connectors for Microfluidics.

3D printing is regarded as a useful tool for the fabrication of microfluidic connectors to overcome the challenges of time consumption, clogging, poor alignment and bulky fixtures existing for current interconnections. 3D-printed connectors without any additional components can be directly printed to substrate with an orifice by UV-assisted coaxial printing. This paper further characterized and evaluated 3D-printed connectors fabricated by the proposed method. A process window with an operable combination of flow rates was identified. The outer flow rate could control the inner channel dimensions of 3D-printed connectors, which were expected to achieve less geometric mismatch of flow paths in microfluidic interfaces. The achieved smallest inner channel diameter was around 120 µm. Furthermore, the withstood pressure of 3D-printed connectors was evaluated to exceed 450 kPa, which could enable microfluidic chips to work at normal pressure.