Adsorption and reaction of acetylene on clean and oxygen-precovered Pd(100) studied with high-resolution X-ray photoelectron spectroscopy.

We investigated the adsorption and thermal evolution of acetylene on clean Pd(100) and Pd(100) precovered with 0.25 ML oxygen. The measurements were performed in situ by fast XPS at the synchrotron radiation facility BESSY II. On Pd(100) acetylene molecularly adsorbs at 130 K. Upon heating transformation to a CCH species occurs around 390 K along with the formation of a completely dehydrogenated carbon species. On the oxygen-precovered surface partial CCH formation already occurs upon adsorption at 130 K, and the dehydrogenation temperature and the stability range of CCH are shifted to lower temperatures by ∼200 K.

Ethene adsorption and dehydrogenation on clean and oxygen precovered Ni(111) studied by high resolution x-ray photoelectron spectroscopy.

The adsorption and thermal evolution of ethene (ethylene) on clean and oxygen precovered Ni(111) was investigated with high resolution x-ray photoelectron spectroscopy using synchrotron radiation at BESSY II. The high resolution spectra allow to unequivocally identify the local environment of individual carbon atoms. Upon adsorption at 110 K, ethene adsorbs in a geometry, where the two carbon atoms within the intact ethene molecule occupy nonequivalent sites, most likely hollow and on top; this new result unambiguously solves an old puzzle concerning the adsorption geometry of ethene on Ni(111). On the oxygen precovered surface a different adsorption geometry is found with both carbon atoms occupying equivalent hollow sites. Upon heating ethene on the clean surface, we can confirm the dehydrogenation to ethine (acetylene), which adsorbs in a geometry, where both carbon atoms occupy equivalent sites. On the oxygen precovered surface dehydrogenation of ethene is completely suppressed. For the identification of the adsorbed species and the quantitative analysis the vibrational fine structure of the x-ray photoelectron spectra was analyzed in detail.

Site blocking and CO/sulfur site exchange processes on stepped Pt surfaces.

The influence of preadsorbed sulfur on the adsorption of CO on Pt(355) and Pt(322) is investigated systematically for sulfur precoverages between 0.02 and 0.30 ML by in situ x-ray photoelectron spectroscopy of the C 1s and S 2p core levels. The two surfaces have the same nominal terrace width of 5 atomic rows, but different step orientation. For both, at low temperatures (130 and 150 K), S preferentially adsorbs at the steps and passivates them for CO adsorption. The required S precoverage is significantly smaller for Pt(322), because of the lower number of steps as a result of the S-induced double-step formation. Upon heating, population of step sites with CO occurs due to irreversible CO/S site exchange. At low S precoverages, the characteristic transition temperatures of 165 K for Pt(355) and 245 K for Pt(322) are significantly different, indicating a higher activation barrier for the CO/S site exchange process for Pt(322). For medium to high S precoverages the transition temperature stays unchanged for Pt(322) but increases for Pt(355). The observed behavior is attributed to a kinetic passivation of the steps by sulfur at low temperatures, which is lifted upon heating.