High efficiency and stability of perovskite solar cells prepared by alkali metal interfacial modification.

Perovskite solar cells (PSCs) have attracted much attention at home and abroad due to their excellent photoelectric properties. Defects in the electron transport layer (ETL) and ETL/perovskite interface greatly affect the power conversion efficiency (PCE) and stability of PSCs. In the paper, the surface of tin dioxide (SnO2) ETL was modified by an alkali metal salt (NaBr, KBr, and RbBr) solution to optimize electron transport and passivate SnO2/perovskite. The results show that the photovoltaic performance of the PSCs is significantly improved after interfacial modification, especially the KBr-modified PSC has the highest PCE, which is 7.8% higher than that of the unmodified device, and the open-circuit voltage, short-circuit current density and fill factor are all greatly improved. This improvement is attributed to the fact that interfacial modification reduces the trap density of the SnO2 films, increases the mobility of the SnO2 films film, effectively passivates defects, and significantly inhibits the recombination at the SnO2/perovskite interface. This method aims to use simple and low-cost inorganic materials for effective interface modification.

A biomimetic cartilage gradient hybrid scaffold for functional tissue engineering of cartilage.

Osteochondral tissue has a complex layered structure that is not self-repairing after a cartilage defect. Therefore, constructing a biomimetic gradient scaffold that meets the specific structural requirements of osteochondral tissue is a major challenge in the field of cartilage tissue engineering. In this study, chitosan/Sodium ß-glycerophosphate/Gelatin (Cs/GP/Gel) biomimetic gradient scaffolds were prepared by regulating the mass ratio of single layer raw materials. The same ratio of Cs/GP/Gel hybrid scaffold material was used as the control. Physical properties such as water absorption, porosity and the degradation rate of the material were compared to optimize the proportion of scaffold materials. P3 Bone Mesenchymal Stem Cells (BMSCs) were inoculated on the gradient and the control scaffolds to investigate its biocompatibility. Scanning electron microscopy (SEM) results show that 3:1:2, 6:1:3.5, 9:1:5, 12:1:6.5, 15:1:8 Cs/GP/Gel gradient scaffolds had excellent three-dimensional porous structures. Channels were also shown to have been interconnected, and the walls of the pores were folded. In the longitudinal dimension, gradient scaffolds had an obvious stratified structure and pore gradient gradualism, that effectively simulated the natural physiological stratified structure of real cartilage. The diameter of the pores in the control scaffold was uniform and without any pore gradient. Gradient scaffolds had good water absorption (584.24 ± 3.79˜677.47 ± 1.70%), porosity (86.34 ± 5.10˜95.20 ± 2.86%) and degradation (86.09 ± 2.46˜92.48 ± 3.86%). After considering the physical properties assessed, the Cs/GP/Gel gradient scaffold with a ratio of 9:1:5 was found to be the most suitable material to support osteochondral tissue. BMSCs were subsequently inoculated on the proportional gradient and hybrid scaffolds culture. These cells survived, distributed and extended well on the gradient and hybrid scaffold material. The biomimetic gradient scaffold designed and prepared in this study provides an important foundation for the development of new gradient composite biomedical materials for osteochondral repair.