RESUMO
Stable aluminosilicate zeolites with extra-large pores that are open through rings of more than 12 tetrahedra could be used to process molecules larger than those currently manageable in zeolite materials. However, until very recently1-3, they proved elusive. In analogy to the interlayer expansion of layered zeolite precursors4,5, we report a strategy that yields thermally and hydrothermally stable silicates by expansion of a one-dimensional silicate chain with an intercalated silylating agent that separates and connects the chains. As a result, zeolites with extra-large pores delimited by 20, 16 and 16 Si tetrahedra along the three crystallographic directions are obtained. The as-made interchain-expanded zeolite contains dangling Si-CH3 groups that, by calcination, connect to each other, resulting in a true, fully connected (except possible defects) three-dimensional zeolite framework with a very low density. Additionally, it features triple four-ring units not seen before in any type of zeolite. The silicate expansion-condensation approach we report may be amenable to further extra-large-pore zeolite formation. Ti can be introduced in this zeolite, leading to a catalyst that is active in liquid-phase alkene oxidations involving bulky molecules, which shows promise in the industrially relevant clean production of propylene oxide using cumene hydroperoxide as an oxidant.
RESUMO
For zeolites synthesized using imidazolium cations, the organic matter can be extracted at very low temperatures (100 °C) using ozone. This is possible for zeolites with 12-ring or larger pores but requires higher temperatures in medium-pore zeolites. The first chemical events in this process occur fast, even at room temperature, and imply the loss of aromaticity likely by the formation of an adduct between ozone and the imidazole ring through carbons C4 and C5. Subsequent rupture of the imidazole ring provides smaller and more flexible fragments that can desorb more readily. This process has been studied experimentally, mainly through infrared spectroscopy, and theoretically by density functional theory. Amazingly, fluoride anions occluded in the small double-four-ring units (d4r) during the synthesis remain inside the cage throughout the whole process when the temperature is not too high (≤150 °C). However, fluoride in larger cages in MFI ends up bonded to silicon in penta or hexacoordinated units, likely out of the cages, after ozone treatment at 150 °C. For several germanosilicate zeolites, the process allows their subsequent degermanation to yield stable high-silica zeolites. Quaternary ammonium cations require harsher conditions that eventually also extract fluoride from zeolite cages, including the d4r unit.
RESUMO
The development of chiral zeolitic catalysts possessing extra-large pores and endowed with the capability of enantioselectively processing bulky products represents one of the greatest challenges in chemistry. Here, we report the discovery of GTM-3, an enantio-enriched extra-large pore chiral zeolite material with -ITV framework structure, obtained using a simple enantiopure organic cation derived from the chiral pool, N,N-ethyl-methyl-pseudoephedrinium, as the chiral-inductor agent. We demonstrate the enantio-enrichment of GTM-3 in one of the two enantiomorphic polymorphs using the two enantiomers of the organic cation. Interestingly, we prove the ability of this zeolitic material to perform enantioselective catalytic operations with very large substrates, here exemplified by the catalytic epoxide aperture of the bulky trans-stilbene oxide with alcohols, yielding unprecedented product enantiomeric excesses up to 30%. Our discovery opens the way for the use of accessible chiral zeolitic materials for the catalytic asymmetric synthesis of chiral pharmaceutical compounds.
Assuntos
Zeolitas , Catálise , EstereoisomerismoRESUMO
Gold nanoclusters and isolated gold atoms have been produced in a two-liquid phase procedure that involves a solution of gold in aqua regia and rosemary essential oil as organic layer. These gold entities have been immobilized on the ordered mesoporous silica material SBA-15 functionalized with different amounts of aminopropyl groups. The resulting materials have been characterized by XRD, N2 adsorption, chemical analysis, TGA, 29Si MAS NMR, 13C CP/MAS NMR, UV-vis spectroscopy, XPS, and STEM. The Au-containing materials retain the ordering and porosity of the pristine support. Gold content varies in the range of 0.07-0.7 wt% as a function of the specific immobilization conditions, while STEM evidences the presence of isolated gold atoms. XPS shows a shift of the Au 4f BE toward values lower than those of metallic gold. The catalytic activity in the oxidation of cyclohexene with molecular oxygen at atmospheric pressure parallels the Au content of the aminopropyl-SBA-15 supports. This activity is higher than that of analogous Au entities immobilized on SBA-15 functionalized with thiol or sulfonate groups, the activity decreasing in the order Au-NH2 > Au-SO3- > Au-SH. This behavior has been attributed to differences in the interaction strength between the functional group and the Au entities, which is optimum for the aminopropyl groups.
Assuntos
Cicloexenos/química , Ouro/química , Oxirredução , Catálise , Fenômenos Químicos , Técnicas de Química Sintética , Cicloexenos/síntese química , Espectroscopia de Ressonância Magnética , Porosidade , Dióxido de Silício/química , Difração de Raios XRESUMO
Mesoporous silica materials are promising carriers for enzyme immobilization in heterogeneous biocatalysis applications. By tailoring their pore structural framework, these materials are designable for appropriate enzyme binding capacity and internal diffusivity. To supply O2 efficiently to solid-supported immobilized enzymes represents a core problem of heterogeneously catalyzed oxidative biotransformations. In this study, therefore, we synthesized and compared three internally well-ordered and two amorphous silica materials as enzyme carriers, each of those with pore sizes of ≥10 nm, to enable the coimmobilization of d-amino-acid oxidase (79 kDa) and catalase (217 kDa). Both enzymes were fused to the silica-binding module Zbasic2 to facilitate their selective and oriented immobilization directly from crude protein mixtures on native silica materials. Analyzing the effects of varied pore architecture and internal surface area on the performance of the immobilized bienzymatic system, we showed that a uniform pore structural framework was beneficial for enzyme loading (≥70 mg protein/g carrier), immobilization yield (≥90%), surface and pore volume filling without hindered adsorption, and catalytic effectiveness (≥60%) of the coimmobilizate. Using the best carrier LP-SBA-15, we obtained a solid oxidase-catalase preparation with an activity of 2000 µmol/(min g_material) that was recyclable and stable during oxidation of d-methionine. These results affirm a strategy of optimizing immobilized O2-dependent enzymes via tunable internal structuring of the silica material used as carrier. They thus make a significant advance toward the molecular design of heterogeneous oxidation biocatalysts on mesoporous silica supports.
Assuntos
Dióxido de Silício/química , Adsorção , Biocatálise , Catalase , Enzimas Imobilizadas , PorosidadeRESUMO
Siliceous ordered mesoporous materials (OMM) are gaining interest as supports for enzyme immobilization due to their uniform pore size, large surface area, tunable pore network and the introduction of organic components to mesoporous structure. We used SBA-15 type silica materials, which exhibit a regular 2D hexagonal packing of cylindrical mesopores of uniform size, for non-covalent immobilization of laccase. Synthesis conditions were adjusted in order to obtain supports with different particle shape, where those with shorter channels had higher loading capacity. Despite the similar isoelectric points of silica and laccase and the close match between the size of laccase and the pore dimensions of these SBA-15 materials, immobilization was achieved with very low leaching. Surface modification of macro-/mesoporous amorphous silica by grafting of amine moieties was proved to significantly increase the isoelectric point of this support and improve the immobilization yield.
Assuntos
Enzimas Imobilizadas/química , Lacase/química , Dióxido de Silício/química , PorosidadeRESUMO
A surprising inversion of chirality of the -ITV zeolite framework is observed when the ethyl group of the enantiopure N,N-ethyl-methyl-pseudoephedrinium organic structure-directing agent is replaced by a benzyl or 2-methylbenzyl group, keeping the same molecular absolute configuration. Interestingly, chiral zeolite materials obtained with these new benzyl-containing cations reach unprecedentedly high enantiomeric excesses up to 55%.
RESUMO
The new zeolite NUD-3 possesses a three-dimensional system of large pore channels that is topologically identical to those of ITQ-21 and PKU-14. However, the three zeolites have distinctly different frameworks: a particular single 4-membered ring inside the denser portion of the zeolite is missing in PKU-14, disordered in ITQ-21 and fully ordered in NUD-3. We document these differences and use molecular simulations to unravel the mechanism by which a particular structure directing agent dication, 1,1'-(1,2-phenylenebis(methylene))bis(3-methylimidazolium), is able to orient this inner ring.
RESUMO
The synthesis of micro/mesoporous aluminosilicate with a hexagonal arrangement of pores has been achieved by cationic surfactant-templating in a tetramethylammonium-containing solution precursor of colloidal faujasite; this material is zeolite nanocrystal-free and exhibits high catalytic activity in m-xylene conversion.
RESUMO
TiO(2) catalysts of anatase, rutile and brookite phase were prepared at low temperature and tested for carrying out the photocatalytic partial oxidation of 4-methoxybenzyl alcohol to 4-methoxybenzaldehyde (p-anisaldehyde) in organic-free water suspensions. Traces of 4-methoxybenzoic acid and open-ring products were the only by-products present, CO(2) being the other main oxidation product. Rutile exhibited the highest yield to p-anisaldehyde (62% mol) at a rate of the same order of magnitude of that showed by the other samples. Commercial rutile and anatase photocatalysts were also used for the sake of comparison. The samples have been characterised by an in situ ATR-FTIR investigation carried out in conditions simulating the photoreaction ones.