Systematic variations in polymer gel dosimeter calibration due to container influence and deviations from water equivalence.

There are a number of gel dosimeter calibration methods in contemporary usage. The present study is a detailed Monte Carlo investigation into the accuracy of several calibration techniques. Results show that for most arrangements the dose to gel accurately reflects the dose to water, with the most accurate method involving the use of a large diameter flask of gel into which multiple small fields of varying dose are directed. The least accurate method was found to be that of a long test tube in a water phantom, coaxial with the beam. The large flask method is also the most straightforward and least likely to introduce errors during the set-up, though, to its detriment, the volume of gel required is much more than other methods.

Levels of leakage radiation from electron collimators of a linear accelerator.

The leakage radiation from electron applicators used with our linear accelerator has been measured. For the applicators 6 X 6 to 25 X 25 cm size, the leakage was measured in the plane of the patient and on the sides of the applicators with the available electron energies of 6, 9, 12, 15 and 18 MeV. The levels were significant. The highest leakage on the side was for the combination of 6 X 6-cm applicator and 9-MeV electrons (32%) and in the plane of the patient for 25 X 25-cm applicator with 18 MeV (10%) relative to the peak dose. Adding lead 1-2 mm, at appropriate locations inside the applicators has reduced the leakages to acceptable levels without affecting the beam parameters.

A feasibility study for megavoltage cone beam CT using a commercial EPID.

This study used a standard commercial electronic portal imaging device (EPID) area detector attached to an isocentric linear accelerator and the Feldkamp algorithm to produce cone beam tomographic reconstructions. The EPID has a active area of 32.5 x 32.5 cm2, and can record 12-bit images using two monitor units (MU), with a resolution of 2.1 x 2.0 mm2 FWHM. Since the EPID was not large enough to record the full patient projection at about 1.5 geometric magnification, it was necessary to offset the detector to collect half-cone projections. Corrections are required to convert pixel values into units of exit dose and to realign the projections to overcome the +/- 4 mm support arm sag. With a geometric magnification of 1.5 the sensitive volume is a cylinder of radius 21 cm and length 17 cm. Unfortunately, the patient couch contains metal bed support rails that lie just outside this cylinder, and produce streak artefacts in the reconstruction. Using 90 views the system delivers a central dose of 90 cGy, and has a density resolution of 4%.

Effect of growth temperature on the positional distribution of eicosapentaenoic acid and trans hexadecenoic acid in the phospholipids of a Vibrio species of bacterium.

Phosphatidylethanolamine (PE) and phosphatidylglycerol (PG) were isolated from a Vibrio species of bacterium, known to produce eicosapentaenoic acid (20:5n-3) and trans-hexadecenoic acid (16:1n-7), and subjected to phospholipase A2 degradation to determine the positional distribution of component fatty acids. At the two growth temperatures studied (20 and 5 degrees C), both 20:5n-3 and trans 16:1 n-7 were located mainly at position sn-2 in PE. Increases in the proportions of 20:5n-3 and trans 16:1n-7 in position sn-2 with decreasing growth temperature were balanced mainly by decreases in the level of iso-15:0. In PG, trans 16:1n-7 was located predominantly in position sn-1, although the difference between the two positions was not as great as in PE. Eicosapentaenoic acid was preferentially located in position sn-2 of PG, particularly at 5 degrees C when it comprised 29.9% of the total fatty acids in this position. It is concluded that trans 16:1n-7/20:5n-3 is not a major molecular species of phospholipid in this species of Vibrio and that changes in the levels of molecular species of PE containing iso-15:0 may feature in thermal acclimation.

Hydrolysis of fish oils containing polymers of triacylglycerols by pancreatic lipase in vitro.

Fish oils containing different levels of polymers of triacylglycerols formed during autoxidation were incubated with pancreatic lipase to establish whether these polymers are substrates for lipase hydrolysis. With oils containing low amounts (less than 4%) of triacylglycerol polymers as substrates, both triacylglycerols and polymers of triacylglycerols were almost completely hydrolyzed, and fatty acid monomers and monoacylglycerols were the major lipid products. Under the same incubation conditions, some triacylglycerols remained intact when highly oxidized oils containing 20 or 30% triacylglycerol polymers were the substrate. The fatty acid composition of these residual triacylglycerols was almost identical to that of triacylglycerols present at the start of the assay. When fish oil containing 30% triacylglycerol polymers was incubated with the lipase, the component triacylglycerols and polymers of triacylglycerols were hydrolyzed at similar rates, and fatty acid dimers were detected as a product. It is concluded that the high molecular weight polymers of triacylglycerols present in oxidized fish oils can be hydrolyzed by pancreatic lipase in vitro.

Trans-monoenoic and polyunsaturated fatty acids in phospholipids of a Vibrio species of bacterium in relation to growth conditions.

A Vibrio species of bacterium known to contain the polyunsaturated fatty acid 20:5n-3 was grown in both freshwater and seawater media at 5 and 20 degrees C and examined for adaptive changes in lipid composition. Phosphatidylethanolamine (PE) and phosphatidylglycerol (PG), together with a smaller proportion of nonesterified fatty acids (NEFA), comprised almost all the lipid under all growth conditions examined. Temperature had a more pronounced effect than the salinity of the medium on lipid composition. The proportion of PE in total lipid was always higher at 5 than at 20 degrees C. Conversely, the proportion of NEFA was lower at 5 than 20 degrees C whereas that of PG was not altered. The levels of saturated fatty acids in total lipid, PE and PG were all decreased by growth at 5 degrees C. No differences were observed with respect to growth temperature in the levels of cis 16:1n-7, the principal monoenoic fatty acid in both PE and PG. Trans 16:1n-7 was found to comprise 12.8-15.2% of fatty acids in PE and PG of bacteria grown at 5 degrees C but only 4.4-8.5% of phospholipid fatty acids in bacteria cultured at 20 degrees C. Regardless of medium composition, a reduction in growth temperature from 20 to 5 degrees C also caused the proportions of 20:5n-3 to increase from around 0.8 to 4.4% in PE and from around 4 to 20% in PG. The simultaneous occurrence of trans 16:1n-7 and 20:5n-3 is unique to this Vibrio species of bacterium.(ABSTRACT TRUNCATED AT 250 WORDS)

Thickness of shielding required for dose reduction with 4-22 MeV electrons.

In electron therapy, it is common practice to shape the treatment area by the use of lead or cerroband alloy on the skin, or as insert at the electron collimator. We have studied the effect of the position of these shields on the skin dose and the thickness of the shield to reduce the dose to less than 5%. With energies above 12 MeV, it is not practicable to reduce the dose to 5% or less with reasonable thickness of the shield at either position. For lower energies the shield is more effective at the collimator rather than on the skin.