Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 8 de 8
Filtrar
Mais filtros

Base de dados
Tipo de documento
Intervalo de ano de publicação
1.
Phys Rev Lett ; 117(19): 195901, 2016 Nov 04.
Artigo em Inglês | MEDLINE | ID: mdl-27858436

RESUMO

Heat conduction possesses (thermal) modes in analogy with acoustics even without oscillation. Here, we establish thermal mode spectroscopy to measure the thermal diffusivity of small specimens. Local heating with a light pulse excites such modes that show antinodes at the heating point, and photothermal detection at another antinode spot allows measuring relaxation behavior of the desired mode selectively: The relaxation time yields thermal diffusivity. The Ritz method is proposed for arbitrary geometry specimens. This method is applicable even to a diamond crystal with ∼1 mm dimensions.

2.
Sci Rep ; 11(1): 8929, 2021 Apr 26.
Artigo em Inglês | MEDLINE | ID: mdl-33903604

RESUMO

Nucleation by sedimentation of colloidal particles on a flat surface is experimentally observed, and effect of attractive depletion force generated by polymers on nucleation is investigated. Sedimentation forms polycrystalline colloidal crystal on a flat surface, and above the threshold polymer concentration, ratio of the spontaneous nucleation increases, resulting in a decrease in the grain size, whereas dependence of the contact angle on the polymer concentration was not observed. We show that the interaction between particles and the flat surface mainly affects the spontaneous nucleation, not the interaction between the particles, and it is demonstrated that the nucleation process can be numerically reproduced using the rate equations.

3.
Sci Rep ; 9(1): 12836, 2019 Sep 06.
Artigo em Inglês | MEDLINE | ID: mdl-31492865

RESUMO

Crystallization from amorphous solids is generally caused by activating phonons in a wide frequency range during heat treatment. In contrast, the activation of phonons in a narrow frequency range using ultrasonic treatment also causes crystallization below the glass transition temperature. These behaviors indicate that crystallization is related to the atomic motion in the glass state, and it is suggested that the activation of specific atomic motion can cause crystallization without increasing temperature. In this study, we observe nucleation and nuclei growth caused by mechanical oscillation in a hard-sphere colloidal glass and evaluate the effect of mechanical oscillation on the structural evolution in the early stage of the crystallization. Oscillation between 5 and 100 Hz is applied to the colloidal glass, and it is observed that the nucleation rate increases under the 70 Hz oscillation, resulting in formation of stable nuclei in a short amount of time. The nuclei growth is also accelerated by the 70 Hz oscillation, whereas increases in the nucleation rate and nuclei growth were not observed at other frequencies. Finally, activation of the diffusion-based rattling of particles by caging is considered as a possible mechanism of the observations.

4.
Sci Rep ; 7(1): 1369, 2017 05 02.
Artigo em Inglês | MEDLINE | ID: mdl-28465535

RESUMO

Crystallization of a hard-sphere colloidal glass by mechanical oscillation is investigated, and accelerated crystallization is found at a specific frequency. The crystallization frequency increases as attractive force between particles increases, indicating that interparticle interaction affects the crystallization frequency. Time scale of the mechanical oscillation is different from that of the slow relaxation, and notable relationship with the low-frequency mode is not observed. The experimental results are not explained by the previously proposed model for crystallization by oscillatory shear. Conversely, we speculate that activations of the fast relaxation and particle motion in crystal-like clusters are possible causes of the observations.

5.
Ultrasonics ; 42(1-9): 491-4, 2004 Apr.
Artigo em Inglês | MEDLINE | ID: mdl-15047334

RESUMO

We propose an advanced method to determine the elastic-stiffness coefficients Cij of thin films using resonance ultrasound spectroscopy (RUS). It uses free-vibration resonance frequencies of a film/substrate layered solid and derives inversely the film's Cij from the resonance frequencies. We develop a piezoelectric tripod consisting of two pinducers and one support to place the specimen on it and measure the resonance frequencies with high enough accuracy. Furthermore, we achieve mode identification by measuring deformation distributions on the vibrating specimen surface using laser-Doppler interferometry. Accurate measurements of frequencies and correct mode identification are the keys for deducing reliable Cij of the film. We applied this technique to copper thin films deposited of Si substrates. The resulting film's Cij are considerably smaller than the bulk's Cij and show anisotropy between the out-of-plane direction and in-plane direction.

6.
Nat Commun ; 4: 2343, 2013.
Artigo em Inglês | MEDLINE | ID: mdl-23933685

RESUMO

Diamond is the stiffest known material. Here we report that nanopolycrystal diamond synthesized by direct-conversion method from graphite is stiffer than natural and synthesized monocrystal diamonds. This observation departs from the usual thinking that nanocrystalline materials are softer than their monocrystals because of a large volume fraction of soft grain-boundary region. The direct conversion causes the nondiffusional phase transformation to cubic diamond, producing many twins inside diamond grains. We give an ab initio-calculation twinned model that confirms the stiffening. We find that shorter interplane bonds along [111] are significantly strengthened near the twinned region, from which the superstiff structure originates. Our discovery provides a novel step forward in the search for superstiff materials.

7.
Biosens Bioelectron ; 26(4): 1273-7, 2010 Dec 15.
Artigo em Inglês | MEDLINE | ID: mdl-20656469

RESUMO

Novel thin-film oscillator biosensors are developed using picosecond ultrasound method. 100-nm silicon-nitride thin films and 16-nm Pt thin films are used, and ultrashort light pulses are focused on their surfaces to excite the through-thickness resonance vibrations, which are detected by the delayed probe-light pulses using the optoelastic effect. Their fundamental resonance frequencies are 45 and 132 GHz, corresponding to theoretical mass sensitivities of 5.0×10(-5) and 2.2×10(-5) pg/cm(2)/Hz, respectively. These thin-film biosensors are used for detecting human immunoglobulin G (hIgG) with Staphylococcus aureus protein A nonspecifically immobilized on the film surfaces. Injection of a 5 nM analyte caused 2% decrease in the resonance frequency.


Assuntos
Técnicas Biossensoriais/instrumentação , Técnicas Biossensoriais/métodos , Humanos , Imunoglobulina G/análise , Luz , Dispositivos Ópticos , Fenômenos Ópticos , Platina , Técnicas de Microbalança de Cristal de Quartzo , Compostos de Silício , Proteína Estafilocócica A/análise , Vibração
8.
Phys Rev Lett ; 99(3): 035502, 2007 Jul 20.
Artigo em Inglês | MEDLINE | ID: mdl-17678294

RESUMO

We measured the out-of-plane elastic constants C(33) of a Co/Pt superlattice by picosecond ultrasound, and found that they were closely related to the thickness ratio of Co and Pt layers; C(33) was smaller than the prediction from the bulk values except for a specific thickness ratio. This behavior can be explained by the weak bonding at the interfaces that occurs to reduce the elastic strain energy, not by the interfacial strain. This view explained the relationship among C(33), the elastic strain energy, and perpendicular magnetic anisotropy.

SELEÇÃO DE REFERÊNCIAS
Detalhe da pesquisa