Volatilisation of major, minor, and trace elements during thermal processing of fly ashes from waste- and wood-fired power plants in oxidising and reducing gas atmospheres.

This study assesses the volatility of 15 elements (As, Bi, C, Cd, Cl, Cu, K, Mn, Na, P, Pb, S, Sb, Sn, and Zn) during thermal processing of fly ashes obtained from four waste-to-energy plants and one wood-combustion plant. Differences in volatility in oxidising and reducing atmospheres (air and 10% H2/90% N2) were assessed at two temperatures, 700 and 1000 °C. P and Mn were predominately retained in all ashes regardless of the operating atmosphere and temperature. Other elements showed significant variation in volatility depending on the type of fly ash, atmosphere, and temperature. Heat-treatment of the wood-combustion fly ash in the air atmosphere resulted in low release of K, Na, and all investigated heavy metals and metalloids. Several valuable elements, including Zn, Sb, Sn, and Bi, were significantly more volatile in the reducing atmosphere than in the oxidising atmosphere, particularly at 1000 °C. Other elements were either less volatile, equally volatile, or only marginally more volatile when the ashes were heated at 1000 °C in the reducing atmosphere. These elements include C, Cl, Cu, and, in the case of fly ashes derived from municipal solid waste, Cd and Pb. A two-step process, in which municipal solid waste incineration fly ash is first heated in an oxidising atmosphere and then in a reducing atmosphere, is proposed for production of a chloride-free zinc concentrate. Evaluation of the two-step process at 880 °C shows good potential for selective volatilisation of Zn with other valuable elements, including Sn, Sb, and Bi.

Thermal treatment of municipal solid waste incineration fly ash: Impact of gas atmosphere on the volatility of major, minor, and trace elements.

Development of thermal processes for selective recovery of Zn and other valuable elements from municipal solid waste incineration (MSWI) fly ash requires comprehensive knowledge of the impact of gas atmosphere on the volatile behaviour of the element constituents of the ash at different reaction temperatures. This study assesses the partitioning of 18 elements (Al, As, Bi, C, Ca, Cd, Cl, Cu, K, Mg, Na, P, Pb, S, Sb, Sn, Ti, and Zn) between condensed and gaseous phases during thermal treatment of MSWI fly ash in both oxidising gas and reducing gas atmospheres, at different temperatures spanning the range 200-1050 °C. The operating atmosphere had major impacts on the partitioning of the following elements: As, Bi, C, Cd, Cu, Na, Pb, S, Sb, Sn, and Zn. The partitioning of these elements cannot be accurately predicted over the full range of investigated operating conditions with global thermodynamic equilibrium calculations alone, i.e. without also considering chemical kinetics and mass transfer. In oxidising conditions, the following elements were predominately retained in condensed phases, even at high temperatures: As, Bi, Sb, Sn, and Zn. All these elements, except As, were largely released to the gas phase (>70%) at high temperatures in reducing conditions. The impact of gas atmosphere on the volatility of Cd and Pb was greatest at low reaction temperatures (below ~750 °C). Results for volatile matrix elements, specifically C, Cl, K, Na, and S, are interpreted in terms of the mechanisms governing the release of these elements to the gas phase.

The subtle effects of iron-containing metal surfaces on the reductive carbonylation of RuCl3.

The use of iron-containing metal surfaces, Fe, Fe-Cr-alloy and stainless steel, for the synthesis of mixed metal Ru-Fe compounds has been studied. The studied process was reductive carbonylation of RuCl3 in the presence of a metal surface. Reactions were carried out in ethanol solutions under 10-50 bar carbon monoxide pressure at 125 degrees C using an autoclave. During the reaction the metal surface was oxidized, releasing iron into the solution and acting as a sacrificial source of iron. Under these conditions the corrosion of the metal surface was facile and produced a series of iron-containing species. In addition to the formation of most obvious iron(II) products, such as [Fe(H2O)6]2+ or [FeCl2(H2O)4] the use of the metal surface also provided a route to novel labile trinuclear [Ru2Cl2(mu-Cl)4(CO)6FeL2] (L = H2O, EtOH) complexes. The stability and reactivity of the [Ru2Cl2(mu-Cl)4(CO)6FeL2] complexes were further studied using computational DFT methods. Based on the computational results a reaction route has been suggested for the formation and decomposition of [Ru2Cl2(mu-Cl)4(CO)6FeL2].