RESUMO
We report a joint experimental and theoretical investigation of the high pressure structural and vibrational properties of terbium sesquioxide (Tb2O3). Powder X-ray diffraction and Raman scattering measurements show that cubic Ia3Ì (C-type) Tb2O3 undergoes two phase transitions up to 25 GPa. We observe a first irreversible reconstructive transition to the monoclinic C2/m (B-type) phase at â¼7 GPa and a subsequent reversible displacive transition from the monoclinic to the trigonal P3Ì m1 (A-type) phase at â¼12 GPa. Thus, Tb2O3 is found to follow the well-known C â B â A phase transition sequence found in other cubic rare earth sesquioxides with cations of larger atomic mass than Tb. Our ab initio theoretical calculations predict phase transition pressures and bulk moduli for the three phases in rather good agreement with experimental results. Moreover, Raman-active modes of the three phases have been monitored as a function of pressure, while lattice-dynamics calculations have allowed us to confirm the assignment of the experimental phonon modes in the C- and A-type phases as well as to make a tentative assignment of the symmetry of most vibrational modes in the B-type phase. Finally, we extract the bulk moduli and the Raman-active mode frequencies together with their pressure coefficients for the three phases of Tb2O3. These results are thoroughly compared and discussed in relation to those reported for rare earth and other related sesquioxides as well as with new calculations for selected sesquioxides. It is concluded that the evolution of the volume and bulk modulus of all the three phases of these technologically relevant compounds exhibit a nearly linear trend with respect to the third power of the ionic radii of the cations and that the values of the bulk moduli for the three phases depend on the filling of the f orbitals.
RESUMO
The P-T phase diagram of the hydrated magnesium carbonate nesquehonite (MgCO3·3H2O) has not been reported in the literature. In this paper, we present a joint experimental and computational study of the phase stability and structural behavior of this cementitious material at high-pressure and high-temperature conditions using in situ single-crystal and synchrotron powder X-ray diffraction measurements in resistive-heated diamond anvil cells plus density functional theory calculations. Our results show that nesquehonite undergoes two pressure-induced phase transitions at 2.4 (HP1) and 4.0 GPa (HP2) at ambient temperature. We have found negative axial compressibility and thermal expansivity values, likely related to the directionality of the hydrogen bonds. The equations of state of the different phases have been determined. All the room-temperature compression effects were reversible. Heating experiments at 0.7 GPa show a first temperature-induced decomposition at 115 °C, probably into magnesite and a MgCO3·4H2O phase.
RESUMO
The vibrational and structural behaviors of Ni3V2O8 and Co3V2O8 orthovanadates have been studied up to around 20 GPa by means of X-ray diffraction, Raman spectra, and theoretical simulations. Both materials crystallize in an orthorhombic Kagomé staircase structure (space group: Cmca) at ambient conditions, and no phase transition was found in the whole pressure range. In order to identify the symmetry of the detected Raman-active modes under high pressure, single crystal samples of those materials were used in a polarized Raman and infrared setup. Moreover, high-pressure powder X-ray diffraction measurements were performed for Co3V2O8, and the results confirmed the structure stability also obtained by other diagnostic techniques. From this XRD analysis, the anisotropic compressibilities of all axes were calculated and the unit-cell volume vs pressure was fitted by a Birch-Murnaghan equation of state, obtaining a bulk modulus of 122 GPa.
RESUMO
The optical properties of two-dimensional materials can be effectively tuned by strain induced from a deformable substrate. In the present work we combine first-principles calculations based on density functional theory and the effective Bethe-Salpeter equation with high-pressure optical measurements to thoroughly describe the effect of strain and dielectric environment onto the electronic band structure and optical properties of a few-layered transition-metal dichalcogenide. Our results show that WS2 remains fully adhered to the substrate at least up to a -0.6% in-plane compressive strain for a wide range of substrate materials. We provide a useful model to describe effect of strain on the optical gap energy. The corresponding experimentally determined out-of-plane and in-plane stress gauge factors for WS2 monolayers are -8 and 24 meV/GPa, respectively. The exceptionally large in-plane gauge factor confirms transition metal dichalcogenides as very promising candidates for flexible functionalities. Finally, we discuss the pressure evolution of an optical transition closely lying to the A exciton for bulk WS2 as well as the direct-to-indirect transition of the monolayer upon compression.