Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 5 de 5
Filtrar
Mais filtros

Base de dados
Tipo de documento
Intervalo de ano de publicação
1.
Opt Express ; 30(12): 22040-22050, 2022 Jun 06.
Artigo em Inglês | MEDLINE | ID: mdl-36224911

RESUMO

Precise and agile detection of radio frequency (RF) signals over an ultra-wide frequency range is a key functionality in modern communication, radar, and surveillance systems, as well as for radio astronomy and laboratory testing. However, current microwave solutions are inadequate for achieving the needed high performance in a chip-scale format, with the desired reduced cost, size, weight, and power. Photonics-based technologies have been identified as a potential solution but the need to compensate for the inherent noise of the involved laser sources have prevented on-chip realization of wideband RF signal detection systems. Here, we report an approach for ultra-wide range, highly-accurate detection of RF signals using a conceptually novel feed-forward laser's noise cancelling architecture integrated on chip. The technique is applied to realization of an RF scanning receiver as well as a complete radar transceiver integrated on a CMOS-compatible silicon-photonics chip, offering an unprecedented selectivity > 80 dB, spectral resolution < 1 kHz, and tunability in the full 0.5-35 GHz range. The reported work represents a significant step towards the development of integrated system-on-chip platforms for signal detection, analysis and processing in cognitive communication and radar network applications.

2.
Nature ; 507(7492): 341-5, 2014 Mar 20.
Artigo em Inglês | MEDLINE | ID: mdl-24646997

RESUMO

The next generation of radar (radio detection and ranging) systems needs to be based on software-defined radio to adapt to variable environments, with higher carrier frequencies for smaller antennas and broadened bandwidth for increased resolution. Today's digital microwave components (synthesizers and analogue-to-digital converters) suffer from limited bandwidth with high noise at increasing frequencies, so that fully digital radar systems can work up to only a few gigahertz, and noisy analogue up- and downconversions are necessary for higher frequencies. In contrast, photonics provide high precision and ultrawide bandwidth, allowing both the flexible generation of extremely stable radio-frequency signals with arbitrary waveforms up to millimetre waves, and the detection of such signals and their precise direct digitization without downconversion. Until now, the photonics-based generation and detection of radio-frequency signals have been studied separately and have not been tested in a radar system. Here we present the development and the field trial results of a fully photonics-based coherent radar demonstrator carried out within the project PHODIR. The proposed architecture exploits a single pulsed laser for generating tunable radar signals and receiving their echoes, avoiding radio-frequency up- and downconversion and guaranteeing both the software-defined approach and high resolution. Its performance exceeds state-of-the-art electronics at carrier frequencies above two gigahertz, and the detection of non-cooperating aeroplanes confirms the effectiveness and expected precision of the system.

3.
Opt Express ; 27(10): 14381-14391, 2019 May 13.
Artigo em Inglês | MEDLINE | ID: mdl-31163888

RESUMO

We propose and experimentally demonstrate a reconfigurable microwave photonic filter based on temporal Talbot effects. The microwave signal is first uniformly sampled by a train of optical pulses through electro-optic intensity modulation. The sampled optical pulses are then directed to a Talbot-based optical signal processor, consisting of an electro-optic temporal phase modulator and a chromatic dispersion line. The Talbot-based microwave photonic filter (TMPF) exploits the inherent properties of the Talbot self-imaging effect for mitigating pulse-to-pulse intensity fluctuations of optical pulses to transmit some fluctuation frequencies and mitigate or entirely block other microwave spectral components. The output microwave signal is finally reconstructed from the processed optical pulses and the resultant RF response is measured by a network analyzer. The TMPF exhibits an RF response with periodic, symmetric-profile passbands whose center frequency and free spectral range (FSR) are defined by the sampling rate and the dispersion value. The filter passbands can be reconfigured electrically, in discrete steps, by adjusting the modulation function of the phase modulator, i.e., without the need for manual adjustment of the optical components. This enables the capability of selection of specific passbands among the primary passbands. The phase modulation function is provided using an arbitrary waveform generator, with the potential for fast tuning of the filter's spectral response. The bandwidth of the filter passband can also be easily customized by adjusting the sampling pulse's temporal width using an optical bandpass filter. Examples of filter performance in various passband configurations are also presented in the time domain to further validate the operation of the filter.

4.
Appl Opt ; 56(31): 8811-8815, 2017 Nov 01.
Artigo em Inglês | MEDLINE | ID: mdl-29091696

RESUMO

An innovative and effective architecture for lidar systems is presented and experimentally demonstrated. The proposed scheme can also be easily exploited for optical communications. In particular, the system includes an innovative lidar software-defined architecture based on optically coherent detection, overcoming current drawbacks of time of flight incoherent systems. The experiments demonstrate the ability to perform long range detection resorting to the waveform compression on the continuous wave approach, obtaining a range resolution of 15 cm with a sensitivity of -95 dBm. Beside the bulk implementation, the system has been also implemented in a photonic integrated circuit using complementary metal-oxide-semiconductor-compatible silicon on insulator technology with an extremely reduced footprint of 1.5 mm×3.5 mm. The testing of the integrated device confirms the effectiveness of this proof-of-concept realization.

5.
Opt Lett ; 40(7): 1358-61, 2015 Apr 01.
Artigo em Inglês | MEDLINE | ID: mdl-25831332

RESUMO

We propose a novel architecture for implementing a dual-frequency lidar (DFL) exploiting differential Doppler shift measurement. The two frequency tones, needed for target velocity measurements, are selected from the spectrum of a mode-locked laser operating in the C-band. The tones' separation is easily controlled by using a programmable wavelength selective switch, thus allowing for a dynamic trade-off among robustness to atmospheric turbulence and sensitivity. Speed measurements for different tone separations equal to 10, 40, 80, and 160 GHz are demonstrated, proving the system's capability of working in different configurations. Thanks to the acquisition system based on an analog-to-digital converter and digital-signal processing, real-time velocity measurements are demonstrated. The MLL-based proposed architecture enables the integration of the DFL with a photonic-based radar that exploits the same laser for generating and receiving radio-frequency signal with high performance, thus allowing for simultaneous or complementary target observations by exploiting the advantages of both radar and lidar.

SELEÇÃO DE REFERÊNCIAS
Detalhe da pesquisa