Elimination of Screening Urine Cultures Prior to Elective Joint Arthroplasty.

Discontinuing routine processing of screening urine cultures prior to elective joint arthroplasty resulted in substantial reduction in urine cultures ordered and antimicrobial prescriptions for asymptomatic bacteriuria, without any significant impact on incidence of prosthetic joint infection. This simple change would be scalable across institutions with potential for significant healthcare savings.

Characteristics of Adsorption/Desorption Process on Dolomite Adsorbent in the Copper(II) Removal from Aqueous Solutions.

The removal of hazardous heavy metals that have been released into the environment due to industrial activities has become an important issue in recent years. The presented study concerned the removal of copper(II) ions from aqueous solutions using dolomites. Dolomite is a very attractive adsorbent due to its wide availability, low cost, good adsorption, and environmental compatibility. The paper describes the properties of D-I and D-II dolomites from two different open-cast mines in Poland. The properties of natural adsorbents were determined based on point of zero charges (PZC), elemental analysis of the adsorbent composition, FT-IR, XRD, and SEM spectra analysis. Depending on the initial concentration of the solution used, the adsorption efficiency of copper(II) ions was 58-80% for D-I and 80-97% for D-II. The adsorption mechanism in the case of D-II dolomite was mainly based on ion exchange, while chemisorption dominated the D-I dolomite surface. Considering the possibility of the regeneration and reuse of the adsorbent, dolomite D-II is a better material (the desorption efficiency of copper(II) ions was 58-80%). The adsorption behavior of dolomites has been described using six adsorption isotherms. The best fit was obtained for the Redlich-Peterson, Jovanovic, and Langmuir isotherms, indicating that monolayer adsorption occurred. The maximum adsorption capacity for copper(II) was 378 mg/g of D-I and 308 mg/g of D-II.

Characteristics of the Properties of Absodan Plus Sorbent and Its Ability to Remove Phosphates and Chromates from Aqueous Solutions.

The aim of the research was to characterize the parameters of the diatomite sorbent Absodan Plus as well as to assess its suitability for the adsorption of chromates and phosphates from acidic aqueous solutions simulating the conditions occurring in some types of industrial wastewater. The scope of the research includes XRD, SEM, BET, and PZC analyses, and 3D observation of commercial diatomite granules and batch tests to determine the constants of kinetics and the equilibrium of chromates and phosphates adsorption. Absodan Plus is a diatomite commercial material containing an amorphous phase (33%) and is also the crystalline phase of quartz, hematite, and grossite. The material is macro- and mesoporous and its specific surface area is about 30 m2/g. Its PZC is around pH = 5.5-6.0 and in an acidic environment is able to adsorb the anions. The saturation of the adsorbent surface with molecules of the adsorbed substance occurs after 2 h for chromates and 2.5 h for phosphates. The maximum adsorption capacity of Absodan Plus in terms of phosphorus and chromium amounts to 9.46 mg P/g and 39.1 mg Cr/g, respectively. As shown by XRD analysis, Absodan Plus contains an admixture of hematite, which can support the removal of chromium and phosphorus.