Assessing health risks in bottled water: chemical compounds and their impact on human health.

Bottled mineral and spring water constitute one of the main sources of drinking water. Relevant legal acts in each country individually regulate the highest permitted concentrations of harmful substances in these waters. However, current regulations do not take into account newly emerging contaminants such as BPA. Analysis of the chemical composition of 72 bottled waters from the Polish market showed that undesirable elements occur in quantities that do not exceed the maximum permissible concentrations. Special attention should be paid to bottled therapeutic water, which may contain elevated concentrations of some micronutrients, such as Al, B, Ba, Fe, Mn, or Sr contributing to the pattern of health risk with excessive consumption of this type of water. The presence of BPA was confirmed in 25 tested waters. The calculated hazard index values showed that the most exposed group are children up to 12 years of age. The greatest attention should be paid to waters with high mineralisation, for which the calculated risk values are the highest.

Fluorescence Analysis of Biocide Efficiency in Antifouling Coatings against Cyanobacteria.

This study focused on the antifouling effect of copper oxide (Cu2O)- and zineb-based coatings against Cyanothece sp. ATCC 51142 by analysing photosynthetic activity using chlorophyll fluorescence. The photoautotrophically grown cyanobacterium was exposed to toxic coatings over a short-term period of 32 h. The study showed that Cyanothece cultures are particularly sensitive to biocides (i) released from antifouling paints and (ii) exhibited by contact with the coated surfaces. Changes in the maximum quantum yield of photosystem II (FV/FM) were observed within the first 12 h of exposure to the coatings. Partial recovery of FV/FM in Cyanothece was revealed 24 h post exposure to a copper- and zineb-free coating. In this research, we proposed an analysis of the evaluation of fluorescence data to study the initial response of cyanobacterial cells to copper- and non-copper-based antifouling coatings formulated with zineb. We evaluated the dynamics of coating toxicity by determining the characteristic time constants of changes in the FV/FM. Within the most toxic paints studied, those formulated with the highest concentration of Cu2O and zineb, the estimated time constants were 3.9 times lower compared to the copper- and zineb-free paint. The use of zineb in copper-based antifouling coatings enhanced the toxic effect of paints and contributed to a faster decline in photosystem II activity in Cyanothece cells. The analysis we proposed, along with the fluorescence screening results, may be useful in evaluating the initial antifouling dynamic action against photosynthetic aquacultures.

Impact of the landfill of ashes from the smelter on the soil environment: case study from the South Poland, Europe.

The following research describes the influence of a metallurgical ash dump on both the soil environment and the atmosphere. Soil samples were collected along a line positioned on an unprotected, hazardous ash dump and extended into the adjacent, arable land. Three soil depths were sampled at 0-20-, 20-40- and 40-60-cm depth intervals, and in each sample, pseudo-total concentrations of Cd, Cr, Cu, Fe, Mn, Ni, Pb, Ti, Zn, Li, Sr and V were analyzed. Additionally, emissions of CH4 and CO2 were measured at each sampling site. All emission measurements were taken in the same day, and the duration of gas measurements in each place was six minutes. The results demonstrate elevated concentrations of Cu, Cr, Pb and Zn on dump surface and along its margins, where the maximum concentrations of these elements are, respectively, 82, 23, 1144 and 8349 mg kg-1. Obtained results exceed several times both the natural background values and the values typical of local soils in the southern Poland. Moreover, natural background values for Fe, Mn, Ni, Li, Sr and V were exceeded, as well. Along the sampling line, no methane emission was detected, whereas the carbon dioxide flux varied from 7 to 42 g m-2 d-1. The reconnaissance study of the ash dump revealed a high contamination level of soils with heavy metals, which, together with the changes of soil environment, may cause migration of pollutants into the adjacent areas and, consequently, may generate hazard to the environment and, particularly, to the living organisms. Hence, further studies are necessary in order to evaluate the soil quality and the leaching of heavy metals from the dump.

Zeolite Composite Materials from Fly Ash: An Assessment of Physicochemical and Adsorption Properties.

Waste fly ash, with both low (with the addition of vermiculite) and high contents of unburned coal, were subjected to hydrothermal syntheses aiming to obtain zeolite composite materials-zeolite + vermiculite (NaX-Ver) and zeolite + unburned carbon (NaX-C). The composites were compared with parent zeolite obtained from waste fly ash with a low content of unburned carbon (NaX-FA). In this study, the physicochemical characteristics of the obtained materials were evaluated. The potential application of the investigated zeolites for the adsorption of ammonium ions from aqueous solutions was determined. Composite NaX-Ver and parent zeolite NaX-FA were characterized by comparable adsorption capacities toward ammonium ions of 38.46 and 40.00 mg (NH4+) g-1, respectively. The nearly 2-fold lower adsorption capacity of composite NaX-C (21.05 mg (NH4+) g-1) was probably a result of the lower availability of ion exchange sites within the material. Adsorbents were also regenerated using 1 M NaCl solution at a pH of 10 and subjected to 3 cycles of adsorption-desorption experiments, which proved only a small reduction in adsorption properties. This study follows the current trend of waste utilization (fly ash) and the removal of pollutants from aqueous solutions with respect to their reuse, which remains in line with the goals of the circular economy.