RESUMO
The objective of this study was to evaluate the insecticidal activity of the polyphenolic compounds found in neem on S. frugiperda larvae. Three neem extracts (1:12 (m/v) with 70% ethanol, 1:12 (m/v) with 0% ethanol (only water), and 1:4 (m/v) with 0% ethanol) were employed. Subsequently, the extraction of phytochemical compounds of each extract was performed using ultrasound and microwave technologies simultaneously. The compound characterization was performed by HPLC-mass. In addition, the insecticidal evaluation of the neem extract was performed against S. frugiperda of the second-stage larvae. The extracts were applied by spraying the larvae according to each bioassay. Results showed that the extract obtained with a 1:12 (m/v) relationship and 70% ethanol was effective for the control of S. frugiperda larvae. In this extract, the predominant organic compound families were: methoxyflavones, flavonols, hydroxycoumarins, anthocyanins, methoxycinnamic acid, and alkylflavones. Phytochemical compounds obtained from neem seeds with environmentally friendly solvents and alternative technologies (ultrasound and microwave) have potent insecticidal activity against S. frugiperda larvae.
Assuntos
Azadirachta , Inseticidas , Animais , Antocianinas , Azadirachta/química , Humanos , Inseticidas/química , Inseticidas/farmacologia , Larva , Sementes , SpodopteraRESUMO
Thermoplastic starch (TPS) has emerged as an essential alternative to produce environmentally friendly packaging; however, retrogradation is a disadvantage that affects its shelf life. This study analyzed the co-plasticizing effect of isosorbide on the mechanical, thermal, physicochemical, and microstructural properties and the retrogradation of films obtained by blown film extrusion from thermoplasticized starch with mixtures of glycerol and isosorbide in different ratios (3:0, 2:1, 1:2, and 0:3, respectively). The results showed that the higher concentration of isosorbide significantly increased the tensile strength; however, it reduced the elongation. Retrogradation modeled using the Avrami equation showed that the presence of isosorbide reduced the retrogradation rate (k) and modified the recrystallization mechanism (n). The relative crystallinity in the plasticized TPS films was reduced to 89%, and the adsorption significantly decreased. Isosorbide was very important in reducing the retrogradation of TPS. The best performance was obtained with the 2:1 ratio of glycerol/isosorbide due to the synergistic effect between the plasticizers. The results would allow tuning the properties of TPS films by combining glycerol/isosorbide in different ratios, which enables the design of materials tailored to potential application requirements.
RESUMO
Depressive symptoms are diagnosed by physicians using scales but their pathophysiology is unclear. Low serotonin (5-HT) levels play an important role in depression, and the 5-HT transporter (5-HTT) is an important regulator of plasma serotonin levels and reuptake. Additionally, the 5-HTT gene-linked polymorphic region (5-HTTLPR) is associated with depression. The aim was to clarify the roles of plasma serotonin levels in plasma and the 5HTTPLR polymorphism in depressive symptoms in older adults. A total of 84 older adult participants were evaluated. Depressive symptoms were measured using the Center for Epidemiologic Studies Depression Scale of 20 items (CESD-20). The plasma serotonin levels were determined by ELISA, and the 5-HTTLPR genotype was analyzed by PCR. Depressive symptoms were present in 39.3% (N = 33) of the participants. The median plasma serotonin level was 204.34 ng/mL (SD = 93.88). A significant correlation was found between the CESD-20 scale and plasma serotonin levels (r = -.256; p = .019). Low serotonin levels were associated with the presence of depressive symptoms (p = .001). The 5-HTTLPR analysis showed that of the 84 older adults, 35.7% had the SS genotype, 10.7% had the LL genotype, and 53.6% were heterozygous. The 5-HTTLPR polymorphism was not associated with depressive symptoms (p = .587) and plasma serotonin levels (p = 0.391). Depressive symptoms correlate with low serotonin levels in plasma, but not with the 5-HTTLPR polymorphism in older Mexican adults.
Assuntos
Depressão , Serotonina , Idoso , Depressão/genética , Genótipo , Humanos , Polimorfismo Genético , Proteínas da Membrana Plasmática de Transporte de Serotonina/genéticaRESUMO
In the present work, multiple-wall carbon nanotubes (MWCNTs) were surface modified in an environmentally friendly way, using low-frequency ultrasonic energy. This type of modification was carried-out using two different types of organic acids, citric acid (CA) and oxalic acid (OA). The modification of the MWCNTs was confirmed by Fourier-transform infrared spectroscopy (FTIR), where functional groups such as OH, C=O, O-C=O and COOH were detected. By means of Raman spectroscopy, an increase in carbon surface defects was found. On the other hand, using X-ray photoelectron spectroscopy (XPS), oxidation was evidenced on the surface of the modified MWCNT. In both Raman spectroscopy and XPS, the results indicate a greater modification when CA is used, possibly due to the fact that CA has a larger number of functional groups. MWCNT-CA showed good dispersion in methanol, while MWCNT-OA showed good stability in methanol and ethanol. Finally, a 20% removal of creatinine efficiency improvement was found with respect to the unmodified MWCNTs, while no improvement was found in the case of urea and uric acid.
RESUMO
ABSTRACT The purpose of tissue engineering (regenerative medicine) is to develop materials that replace human tissue, having as main characteristics' biodegradability, biocompatibility, no toxicity, osteoconductivity, which lead to cell maturation and proliferation. Due to the importance of the development of this type of materials, several researchers have used biopolymers and calcium phosphate salts (hydroxyapatite) as composites to be used in this area as drug releases, scaffolds, implants, among others. Different biopolymers can be suitable for this type of application, in this work we have described the most widely used biopolymers for biomedical purposes, such as alginate, collagen, gellan gum, chitosan, and polylactic acid, in addition to a detailed description of hydroxyapatite, biopolymers, as well as biopolymer/hydroxyapatite composites, to highlight their potential and the most relevant characteristics of these materials.