RESUMO
Tenofovir alafenamide (TAF) is a BCS Class III compound and an oral pro-drug of Tenofovir (TFV) with limited oral bioavailability. The bioavailability of the oral intake increases with food as a result of the low stability of the active substance in the stomach. The reference drug is "Vemlidy® 25 mg Film Tablet", which contains 25 mg of TAF in "hemifumarate" form, is under patent protection until 15.08.2032 by Gilead, and so the "monofumarate" form was used in the present study. At first, a pilot study was conducted involving 12 subjects under fed conditions. The results of the pilot study revealed the test and reference products were not bioequivalent, as a result of insufficient statistical power and high inter-subject variability. Secondly, a physiologically based pharmacokinetic (PBPK) simulation was performed based on the pilot study results and literature data. Finally, the power of the design was increased and the pivotal study design was optimized into a four-period, full-replicated, cross-over study with 34 subjects under fed conditions and it was concluded that the test and reference products were bioequivalent. In conclusion, the present study proved the importance of a correct study design with higher statistical power for a BCS Class III compound with high variability, to present the pharmacokinetics.
Assuntos
Alanina , Disponibilidade Biológica , Estudos Cross-Over , Comprimidos , Tenofovir , Equivalência Terapêutica , Tenofovir/farmacocinética , Tenofovir/administração & dosagem , Tenofovir/análogos & derivados , Humanos , Projetos Piloto , Alanina/farmacocinética , Alanina/química , Adulto , Masculino , Administração Oral , Adulto Jovem , Adenina/análogos & derivados , Adenina/farmacocinética , Adenina/administração & dosagem , Pró-Fármacos/farmacocinética , Pró-Fármacos/administração & dosagemRESUMO
The main objective of this study was the development of pH-independent controlled release valsartan matrix tablet in Quality by design (QbD) framework. The quality target product profile (QTPP), critical quality attributes (CQAs) and critical material attributes (CMAs) were defined by science and risk-based methodologies. Potential risk factors were identified with Fishbone diagram. Following, CMAs were further investigated with a semi-quantitative risk assessment method, which has been revised with mitigated risks after development and optimization studies. According to defined critical material attributes, which one of them was determined to be the dissolution, formulation optimization study was performed by using a statistical design of experiment. Formulation variables have been identified and fixed first with a 'One factor at a time (OFAT)' approach. After OFAT studies, a statistical experimental design was conducted with the most critical material attributes. Statistical design space and mathematical prediction equations have been developed for dissolution and hardness, which is important to predict drug dissolution behavior. In conclusion, a pH-independent release has been achieved for weakly acidic drug valsartan with a deeper understanding of drug product quality, with the science and risk-based approaches of QbD tools.
Assuntos
Química Farmacêutica/métodos , Composição de Medicamentos/métodos , Desenvolvimento de Medicamentos , Pesquisa Farmacêutica/métodos , Valsartana/química , Preparações de Ação Retardada/administração & dosagem , Sistemas de Liberação de Medicamentos , Liberação Controlada de Fármacos , Excipientes , Concentração de Íons de Hidrogênio , Modelos Químicos , Projetos de Pesquisa , Comprimidos , Valsartana/administração & dosagemRESUMO
The in-vitro cytotoxicity, in-vitro permeability and in-vivo pharmacokinetics of a BCS Class-II drug - rufinamide - in a 3DP tablet formulation were evaluated. The cytotoxicity of the 3DP tablet formulation was evaluated with an MTT test; in-vitro permeability was evaluated with a Caco-2 cell culture study; and in-vivo pharmacokinetics were evaluated in Wistar albino male rats. The pharmacokinetic studies were performed following a two-sequence and single-period design approach. The highest Caco-2 permeability was obtained with the 3DP tablet formulation; and the highest cell viability was achieved with the 3DP tablet in both the Hep G2 and Caco-2 cell lines. In the in-vivo pharmacokinetic study, AUC and Cmax values were higher in the 3DP tablet formulation than in the Inovelon® film tablet at a 40 mg/kg dose. Thanks to the increased solubility of the active substance, higher in-vitro permeability and in-vivo absorption were achieved with the 3DP tablet formulation, and with lower cytotoxicity. Based on these promising findings, the 3DP tablet formulation can be considered an effective lower-dose treatment than commercial preparations.
Assuntos
Produção de Droga sem Interesse Comercial , Água , Humanos , Ratos , Animais , Disponibilidade Biológica , Células CACO-2 , Ratos Wistar , Comprimidos/farmacocinética , Solubilidade , Técnicas de Cultura de Células , TecnologiaRESUMO
The aim of this study is to investigate pharmacokinetic parameters of test and reference film tablet formulations of a highly variable drug, pinaverium bromide, under fasting conditions and to assess their bioequivalence in accordance with the FDA and EMA criteria. A randomised open-label, single oral dose, three-sequence, three-period, semi-replicated, cross-over trial was conducted with 36 healthy subjects. The intrasubject variability of reference products for Cmax and AUC0-tlast was found to be more than 50%. While bioequivalence was proven according to the FDA reference scaled average bioequivalence approach with only 36 subjects, more than 200 subjects are required to demonstrate bioequivalence in accordance with the EMA bioequivalence guideline. It is believed that the EMA bioequivalence criteria are too stringent for highly variable drugs whose intrasubject variability are more than 30% for both Cmax and AUC0-tlast and that in consequence the EMA ought to revise their bioequivalence guidelines for such drugs in the future.
Assuntos
Morfolinas , Área Sob a Curva , Estudos Cross-Over , Voluntários Saudáveis , Humanos , Comprimidos , Equivalência TerapêuticaRESUMO
Lennox-Gastaut Syndrome (LGS) is a rare form of childhood epilepsy. Rufinamide is an orphan drug indicated for the treatment of LGS. Three-Dimensional Printing (3DP) is a process in which solid objects are created based on a digital file by adding materials layer by layer. Fused deposition modelling (FDM) is a 3DP technique with the advantages of solid dispersion systems and the ability to use various pharmaceutical excipients in small scales, which makes this technology favorable for the production of orphan drugs. Rufinamide is a water-insoluble lipophilic compound which can exist in different polymorphic forms. The therapeutic dose is 3200 mg/day, at which rufinamide exhibits nonlinear pharmacokinetics, which may be attributed to its limited solubility. The main purpose of this paper is to improve the dissolution of rufinamide through the use of 3DP technology. For this purpose, optimum 3DP tablets were developed based on 3DP manufacturability and dissolution behaviors. The findings suggest that a mixture of hydroxypropyl methylcellulose (HPMC), Soluplus®, Kollidon® VA64, Gelucire® 48/16 and Triacetin are suitable excipients for FDM-3DP technology that can improve the dissolution of rufinamide. The optimum 3DP tablet shows significantly higher dissolution than Inovelon® at the therapeutic dose due to its improved wdissolution.