A long side chain imidazolium-based graft-type anion-exchange membrane: novel electrolyte and alkaline-durable properties and structural elucidation using SANS contrast variation.

Newly designed styrylimidazolium-based grafted anion-exchange membranes (StIm-AEMs), in which imidazolium ionic groups are attached to styrene at the far side from the graft chains, were prepared by radiation-induced graft polymerization of p-(2-imidazoliumyl) styrene onto poly(ethylene-co-tetrafluoloethylene) (ETFE) films, followed by N-alkylation and ion-exchange reactions. StIm-AEM having an ion exchange capacity (IEC) of 0.54 mmol g-1 with a grafting degree (GD) of ∼18%, possesses practical conductivity (>50 mS cm-1) even with a very low water uptake (∼10%) and high stability over 600 h in a 1 M KOH solution at 80 °C. There exists a critical IEC (IECc) in the range of 0.7-0.8 mmol g-1 over which the membrane showed high water uptake, which resulted in pronounced susceptibility to hydrolysis. Using small-angle neutron scattering technique with a contrast variation method, we found the hydrophilic phase in StIm-AEMs with IECs lower and higher than IECc shows "reverse-micelles" with water domains dispersed in the polymer matrix and "micelles" with graft polymer aggregates dispersed in the water matrix, respectively. The further analysis of micelle structures using the hard-sphere liquid model and Porod limit analysis reveals that the interfacial structures of ionic groups are essential for the electrochemical properties and durability of StIm-AEMs. In addition, StIm-AEM with an IEC of 0.95 mmol g-1 and the maximum power density of 80 mW cm-2 in the hydrazine hydrate fuel cell test, exhibited long-term durability under constant current (8.0 mA) up to 455 h, which, thus far, is the best durability at 80 °C for platinum-free alkaline-type liquid fuel cells.

Reverse relationships of water uptake and alkaline durability with hydrophilicity of imidazolium-based grafted anion-exchange membranes.

We found unprecedented reverse relationships in anion-exchange membranes (AEMs) for Pt-free alkaline fuel cell systems, i.e., the increase in hydrophobicity increased water uptake and susceptibility to hydrolysis. AEMs with graft copolymers that composed of anion-conducting 2-methyl-N-vinylimidazolium (Im) and hydrophobic styrene (St) units were employed. We characterized two new structures in these AEMs using a small-angle neutron scattering with a contrast variation method. (1) The distribution of graft polymers in conducting (ion channel) or non-conducting (hydrophobic amorphous poly(ethylene-co-tetrafluoroethylene) (ETFE)) phase was evaluated in a quantitative manner. High fraction in conducting layer for AEMs having high grafting degrees was found using the proposed structural model of "conducting/non-conducting two-phase system". (2) Assuming a hard-sphere fluid model, we found AEMs having high St contents and low alkaline durability possessed nanophase-separated water puddles with diameters of 3-4 nm. The AEM having a low St content and the best alkaline durability did not show evident nanophase separation. The above hierarchical structures elucidate the unexpected reverse relationships that the AEM having highly hydrophobic graft polymers was subjected to the morphological transition to give water puddles at nanoscale. The imidazolium groups that were located at the boundary between graft polymers and water puddles should be susceptible to hydrolysis.

Imidazolium-based anion exchange membranes for alkaline anion fuel cells: (2) elucidation of the ionic structure and its impact on conducting properties.

In our previous study (Soft Matter, 2016, 12, 1567), the relationship between the morphology and properties of graft-type imidazolium-based anion exchange membranes (AEMs) was revealed, in that the semi-crystalline features of the polymer matrix maintain its mechanical properties and the formation of interconnected hydrophilic domains promotes the membrane conductivity. Here, we report a novel ionic structure of the same graft-type AEMs with different grafting degrees, analyzed using a small-angle X-ray scattering method under different relative humidity (RH) conditions. The characteristic "ionomer peak" with a corresponding correlation distance of approximately 1.0 nm was observed at RH < 80%. This distance is much smaller than the literature-reported mean distance between two ionic clusters, but close to the Bjerrum length of water. Since the representative number of water molecules per cation, nw, was small, we proposed that dissociated ion-pairs are distributed in the hydrophilic domains (ion-channels). At RH < 80%, ion-channels are disconnected, however in liquid water, they are well-connected as evidenced by the sharp increase in nw. The disconnected ion-channels even under relatively high RH conditions should be a substantial factor for the low power generation efficiency of AEM-type fuel cells.

Imidazolium-based anion exchange membranes for alkaline anion fuel cells: elucidation of the morphology and the interplay between the morphology and properties.

We investigated the morphology and swelling behavior of a new graft-type of anion exchange membrane (AEM) containing 2-methylimidazolium groups by using a contrast variation small angle neutron scattering (SANS) technique. These AEMs were prepared by radiation-induced grafting of 2-methyl-1-vinylimidazole and styrene into poly(ethylene-co-tetrafluoroethylene) (ETFE) films and subsequent N-alkylation with methyliodide, and possessed both high alkaline durability and high conductivity. Our results showed that the crystalline lamellar and crystallite structures originating from the pristine ETFE films were more or less conserved in these AEMs, but the lamellar d-spacing in both dry and wet membranes was enlarged, indicating an expansion of the amorphous lamellae due to the graft chains introduced in the grafting process and the water incorporated in the swelling process. For the first time, the swelling behavior of the AEMs was studied quantitatively in various water mixtures of water and deuterated water with different volume ratios (contrast variation method), and the morphology of these membranes was elucidated by three phases: phase (1) crystalline ETFE domains, which offer good mechanical properties; phase (2) hydrophobic amorphous domains, which are made up of amorphous ETFE chains and offer a matrix to create conducting regions; phase (3) interconnected hydrated domains, which are composed of the entire graft chains and water and play a key role in promoting the conductivity.

First determination of the inhibitor complex structure of human hematopoietic prostaglandin D synthase.

Hematopoietic prostaglandin (PG) D synthase (H-PGDS) is responsible for the production of PGD(2) as an allergy or inflammation mediator in mast and Th2 cells. We determined the X-ray structure of human H-PGDS complexed with an inhibitor, 2-(2'-benzothiazolyl)-5-styryl-3-(4'-phthalhydrazidyl) tetrazolium chloride (BSPT) at 1.9 A resolution in the presence of Mg(2+). The styryl group of the inhibitor penetrated to the bottom of the active site cleft, and the tetrazole ring was stabilized by the stacking interaction with Trp104, inducing large movement around the alpha5-helix, which caused the space group of the complex crystal to change from P2(1) to P1 upon binding of BSPT. The phthalhydrazidyl group of BSPT exhibited steric hindrance due to the cofactor, glutathione (GSH), increasing the IC(50) value of BSPT for human H-PGDS from 36.2 micro M to 98.1 micro M upon binding of Mg(2+), because the K(m) value of GSH for human H-PGDS was decreased from 0.60 micro M in the presence of EDTA to 0.14 micro M in the presence of Mg(2+). We have to avoid steric hindrance of the GSH molecule that was stabilized by intracellular Mg(2+) in the mM range in the cytosol for further development of structure-based anti-allergic drugs.