A novel 6-mercaptopurine oral liquid formulation for pediatric acute lymphoblastic leukemia patients - results of a randomized clinical trial.

OBJECTIVE: Pediatric patients with acute lymphoblastic leukemia (ALL) are treated with oral 6-mercaptopurine (6MP) for nearly 2 years, but no pediatric formulation has been available. In this study, an oral 6MP liquid suitable for pediatric use was developed and tested in the target population. METHOD: A randomized cross-over study was performed in 20 pediatric ALL patients (age 1.9 - 14.6 years), comparing pharmacokinetics and pharmacodynamics of a newly developed 6MP liquid formulation to 6MP capsules, both taken orally for 4 weeks. RESULTS: Based upon trough levels of the principal active metabolite,6-thioguanine nucleotides (6-TGN),a relative bioavailability of the liquid vs. capsules of 1.01 was found (90% CI 0.86 - 1.20), demonstrating bioequivalence. This was supported by the similarly observed 6MP dosages needed for leucocyte depletion, for both formulations (35 mg/day (range 10 - 115 mg)). 75% of the parents/patients (p = 0.005) preferred the oral liquid over the capsules because of the ease of administration. CONCLUSION: We conclude that the novel 6MP liquid is a promising treatment for ALL.

Limited Health Risks in Performing Drug Reconstitution and Handling Tasks in Pharmacies-Results of an Occupational Risk Assessment Study.

OBJECTIVE: Some drugs need processing before they can be administered or dispensed. We measured airborne exposure of pharmacy staff to small particles when performing these tasks. METHODS: Reconstitution of powdered drugs in vials; crushing, splitting, and counting of tablets; and opening of capsules, using different ventilation strategies, were investigated in five pharmacies after in a worst-case approach. Airborne particulate matter was determined for a range of particles sizes. RESULTS: Mean particle concentrations ranged from not detectable to 1.03 µg/m 3 (<1 µm) and 589.7 µg/m 3 (<10 µm). Dust exhaust made tasks safer. Most hazardous was pouring out tablets from a bulk supply, and least hazardous was reconstitution of a powder for injection. CONCLUSIONS: Occupational exposure during routine handling of drugs can occur, but the risks vary greatly with the nature and duration of the tasks.

Performance of Tablet Splitters, Crushers, and Grinders in Relation to Personalised Medication with Tablets.

Swallowing problems and the required dose adaptations needed to obtain optimal pharmacotherapy may be a hurdle in the use of tablets in daily clinical practice. Tablet splitting, crushing, or grinding is often applied to personalise medication, especially for the elderly and children. In this study, the performance of different types of (commercially available) devices was studied. Included were splitters, screwcap crushers, manual grinders, and electric grinders. Unscored tablets without active ingredient were prepared, with a diameter of 9 and 13 mm and a hardness of 100-220 N. Tablets were split into two parts and the difference in weight was measured. The time needed to pulverise the tablets (crush time) was recorded. The residue remaining in the device (loss) was measured. The powder was sieved to obtain a particle fraction >600 µm and <600 µm. The median particle size and particle size distribution of the later fraction were determined using laser diffraction analysis. Splitting tablets into two equal parts appeared to be difficult with the devices tested. Most screwcap grinders yielded a coarse powder containing larger chunks. Manual and especially electric grinders produced a finer powder, making it suitable for administration via an enteral feeding tube as well as for use in individualised preparations such as capsules. In conclusion, for domestic and incidental use, a screwcap crusher may provide sufficient size reduction, while for the more demanding regular use in hospitals and nursing residences, a manual or electric grinder is preferred.

Bevacizumab for Intravitreal Injection: Impact of Sub-Visible Particles on the Shelf-Life of Repackaged Bevacizumab.

Purpose: Bevacizumab (Avastin) is a humanized monoclonal antibody approved by the European Medicines Agency for the intravenous treatment of cancer. However, it is often used as an intravitreal injection for the treatment of macular degeneration or edema. For this purpose, bevacizumab is repackaged from glass vials into plastic syringes. The formation of particles during this compounding process as well as during storage is a source of concern. The aim of this study was to test the sub-visible particulate contamination in bevacizumab material, both in the glass vial and after repackaging into polycarbonate BD Luer-Lok™ syringes. Methods: Syringes with repackaged bevacizumab from 3 different compounding hospital pharmacies were tested for sub-visible particles at different time points during storage at 2-8°C. Results: The batches of bevacizumab starting product complied with the European Pharmacopoeia (Ph. Eur.) for small-volume parenterals. Repackaging into syringes led to an immediate increase in small particles. The number of particles ≥25 µm increased 1.3-fold, and the number of particles ≥10 µm increased 5-fold, respectively. Storage of up to 37 days did not lead to an additional increase in particle counts. All batches complied with the national criteria for particles in intravitreal solutions. Conclusions: Particle count increased due to the repackaging process, but no substantial increase was observed during storage. Formation of sub-visible particles does not impact the shelf-life of bevacizumab repackaged into BD Luer-Lok syringes.