Atomic and Molecular Collisions at Liquid Surfaces.

The gas-liquid interface remains one of the least explored, but nevertheless most practically important, environments in which molecular collisions take place. These molecular-level processes underlie many bulk phenomena of fundamental and applied interest, spanning evaporation, respiration, multiphase catalysis, and atmospheric chemistry. We review here the research that has, during the past decade or so, been unraveling the molecular-level mechanisms of inelastic and reactive collisions at the gas-liquid interface. Armed with the knowledge that such collisions with the outer layers of the interfacial region can be unambiguously distinguished, we show that the scattering of gas-phase projectiles is a promising new tool for the interrogation of liquid surfaces with extreme surface sensitivity. Especially for reactive scattering, this method also offers absolute chemical selectivity for the groups that react to produce a specific observed product.

Reactive-Atom Scattering from Liquid Crystals at the Liquid-Vacuum Interface: [C12mim][BF4] and 4-Cyano-4'-Octylbiphenyl (8CB).

Two complementary approaches were used to study the liquid-vacuum interface of the liquid-crystalline ionic liquid 1-dodecyl-3-methylimidazolium tetrafluoroborate ([C12mim][BF4]) in the smectic A (SmA) and isotropic phases. O atoms with two distinct incident translational energies were scattered from the surface of [C12mim][BF4]. Angle-dependent time-of-flight distributions and OH yields, respectively, were recorded from high- and low-energy O atoms. There were no significant changes in the measurements using either approach, nor the properties derived from them, accompanying the transition from the SmA to the isotropic phase. This indicates that the surface structure of [C12mim][BF4] remains essentially unchanged across the phase boundary, implying that the bulk order and surface structure are not strongly correlated for this material. This effect is ascribed to the strong propensity for the outer surfaces of ionic liquids to be dominated by alkyl chains, over an underlying layer rich in anions and cation head groups, whether or not the bulk material is a liquid crystal. In a comparative study, the OH yield from the surface of the liquid crystal, 8CB, was found to be affected by the bulk order, showing a surprising step increase at the SmA-nematic transition temperature, whose origin is the subject of speculation.

Picosecond carrier dynamics in InAs and GaAs revealed by ultrafast electron microscopy.

Understanding the limits of spatiotemporal carrier dynamics, especially in III-V semiconductors, is key to designing ultrafast and ultrasmall optoelectronic components. However, identifying such limits and the properties controlling them has been elusive. Here, using scanning ultrafast electron microscopy, in bulk n-GaAs and p-InAs, we simultaneously measure picosecond carrier dynamics along with three related quantities: subsurface band bending, above-surface vacuum potentials, and surface trap densities. We make two unexpected observations. First, we uncover a negative-time contrast in secondary electrons resulting from an interplay among these quantities. Second, despite dopant concentrations and surface state densities differing by many orders of magnitude between the two materials, their carrier dynamics, measured by photoexcited band bending and filling of surface states, occur at a seemingly common timescale of about 100 ps. This observation may indicate fundamental kinetic limits tied to a multitude of material and surface properties of optoelectronic III-V semiconductors and highlights the need for techniques that simultaneously measure electro-optical kinetic properties.

Surface Structure of Alkyl/Fluoroalkylimidazolium Ionic-Liquid Mixtures.

The gas-liquid interface of ionic liquids (ILs) is critically important in many applications, for example, in supported IL phase (SILP) catalysis. Methods to investigate the interfacial structure in these systems will allow their performance to be improved in a rational way. In this study, reactive-atom scattering (RAS), surface tension measurements, and molecular dynamics (MD) simulations were used to study the vacuum interface of mixtures of partially fluorinated and normal alkyl ILs. The underlying aim was to understand whether fluorinated IL ions could be used as additives to modify the surface structure of one of the most widely used families of alkyl ILs. The series of ILs 1-alkyl-3-methylimidazolium bis(trifluoromethylsulfonyl)imide ([Cnmim][Tf2N]) with n = 4-12 were mixed with a fixed-length, semiperfluorinated analogue (1H,1H,2H,2H-perfluorooctyl)-3-methylimidazolium bis(trifluoromethylsulfonyl)imide ([C8mimF13][Tf2N]), forming [Cnmim](1-x)[C8mimF13]x[Tf2N] mixtures, where x is the bulk mole fraction of the fluorinated component. The RAS-LIF method combined O-atom projectiles with laser-induced fluorescence (LIF) detection of the product OH as a measure of surface exposure of the alkyl chains. For [C8mim](1-x)[C8mimF13]x[Tf2N] mixtures, RAS-LIF OH yields are below those expected from stoichiometry. There are quantitatively consistent negative deviations from linearity of the surface tension. Both results imply that the lower-surface-tension fluoroalkyl material dominates the surface. A similar deficit is found for alkyl chain lengths n = 4, 6, 8, and 12 and for all (nonzero) x investigated by RAS-LIF. Accessible-surface-area (ASA) analyses of the MD simulations for [Cnmim](1-x)[C8mimF13]x[Tf2N] mixtures qualitatively reproduce the same primary effect of fluoro-chain predominance of the surface over most of the range of n. However, there are significant quantitative discrepancies between MD ASA predictions and experiment relating to the strength of any n-dependence of the relative alkyl coverage at fixed x, and on the x-dependence at fixed n. These discrepancies are discussed in the context of detailed examinations of the surface structures predicted in the MD simulations. Potential explanations, beyond experimental artifacts, include inadequacies in the classical force fields used in the MD simulations or the inability of simple ASA algorithms to capture dynamical factors that influence RAS-LIF yields.

Resonance Raman studies of the (His)(Cys)3 2Fe-2S cluster of MitoNEET: comparison to the (Cys)4 mutant and implications of the effects of pH on the labile metal center.

MitoNEET is a 2Fe-2S outer mitochondrial membrane protein that was initially identified as a target for anti-diabetic drugs. It exhibits a novel protein fold, and in contrast to other 2Fe-2S proteins such as Rieske proteins and ferredoxins, the metal clusters in the mitoNEET homodimer are each coordinated by one histidine residue and three cysteine residues. The interaction of the ligating His87 residue with the 2Fe-2S moiety is especially significant because previous studies have shown that replacement with Cys in the H87C mutant stabilizes the cluster against release. Here, we report the resonance Raman spectra of this naturally occurring Fe(2)S(2)(His)(Cys)(3) protein to assess local structural changes associated with cluster lability. Comparison of mitoNEET to its ferredoxin-like H87C mutant indicates that Raman peaks in the approximately 250-300 cm(-1) region of mitoNEET are influenced by the Fe-His87 moiety. Systematic pH-dependent resonance Raman spectral changes were observed in this spectral region for native mitoNEET but not the H87C mutant. The approximately 250-300 cm(-1) region of native mitoNEET is also sensitive to phosphate buffer. Thus, conditions that influence cluster release are shown here to concomitantly affect the resonance Raman spectrum in the region with Fe-His contribution. These results support the hypothesis that the Fe-N(His87) interaction is modulated within the physiological pH range, and this modulation may be critical to the function of mitoNEET.

Probing Conformational Heterogeneity at the Ionic Liquid-Vacuum Interface by Reactive-Atom Scattering.

The atomic-level description of liquid interfaces has lagged behind that of solid crystalline surfaces because existing experimental techniques have been limited in their capability to report molecular structure in a fluctuating liquid interfacial layer. We have moved toward a more detailed experimental description of the gas-liquid interface by studying the F-atom scattering dynamics on a common ionic liquid, 1-butyl-3-methylimidazolium bis(trifluoromethylsulfonyl)imide. When given contrast by deuterium labeling, the yield and dynamical behavior of reactively scattered HF isotopologues can resolve distinct signatures from the cation butyl, methyl, and ring groups, which help to quantify the relative populations of cation conformations at the liquid-vacuum interface. These results demonstrate the importance of molecular organization in driving site-specific reactions at the extreme outer regions of the gas-liquid interface.