Preparation and Decomposition of Spherical CL-20 Composites with Enhanced Laser Absorbance and Decreased Mechanical Sensitivity.

Direct initiation of secondary explosives by a semiconductor laser is highly demanded, but it is challenging to exclude the use of sensitive primers. Most laser-sensitive energetic materials are usually mechanically sensitive. In order to reduce the mechanical sensitivity (MS) of 2,4,6,8,10,12-hexanitro-2,4,6,8,10,12-hexaazaisowurtzitane (CL-20) while improving laser absorbance in the near-infrared band, spherical CL-20 composites (SCCs) embedded with nano aluminum (Al) powder and graphene-based catalyst (GO-CHZ-Co) were prepared by a spray drying method. These SCCs have been characterized comprehensively in terms of their morphologies, particle size distribution, laser absorbance, thermal decomposition behaviors, MS, and laser ignition properties. Results show that the maximum critical impact energy of SCCs was 3.8 J, which is 2.8 J higher than that of pristine ε-CL-20. The critical friction load was increased by at most 108 N compared to pristine CL-20. The absorbance has also been significantly increased up to almost 70% in the wavelength between 400 and 1400 nm, where the peak absorption is located in the region of 800-900 nm. In addition, the initial decomposition temperature (Ti) of SCCs is lower than that of pure CL-20, especially in the presence of GO-CHZ-Co. The apparent activation energy (Ea) for the decomposition of SCCs was largely dependent on the particle size of Al. Preliminary ignition tests indicate that the SCCs can be ignited successfully by a small-power laser.

Mass production of bulk artificial nacre with excellent mechanical properties.

Various methods have been exploited to replicate nacre features into artificial structural materials with impressive structural and mechanical similarity. However, it is still very challenging to produce nacre-mimetics in three-dimensional bulk form, especially for further scale-up. Herein, we demonstrate that large-sized, three-dimensional bulk artificial nacre with comprehensive mimicry of the hierarchical structures and the toughening mechanisms of natural nacre can be facilely fabricated via a bottom-up assembly process based on laminating pre-fabricated two-dimensional nacre-mimetic films. By optimizing the hierarchical architecture from molecular level to macroscopic level, the mechanical performance of the artificial nacre is superior to that of natural nacre and many engineering materials. This bottom-up strategy has no size restriction or fundamental barrier for further scale-up, and can be easily extended to other material systems, opening an avenue for mass production of high-performance bulk nacre-mimetic structural materials in an efficient and cost-effective way for practical applications.Artificial materials that replicate the mechanical properties of nacre represent important structural materials, but are difficult to produce in bulk. Here, the authors exploit the bottom-up assembly of 2D nacre-mimetic films to fabricate 3D bulk artificial nacre with an optimized architecture and excellent mechanical properties.