Effect of high pressure heating on physical and chemical characteristics of Asian sea bass (Lates calcarifer) backbone.

Physical and chemical properties of Asian sea bass (Lates calcarifer) backbone subjected to high pressure heating (autoclaving, 121ºC) for different times (30 min; AT-30; 60 min; AT-60; 90 min; AT-90) were studied. As heating time augmented, the increases in protein, α-amino group and hydroxyproline contents in liquor were attained, while hardness was declined indicating that more organic compounds were leached out from the bone matrix. More pronounced XRD pattern was observed in backbone autoclaved for 90 min as a consequence of nano-hydroxyapatite crystals agglomeration. Extension of high-pressure heating time reduced the organic matters as elucidated by TGA and DTA data. Asian sea bass backbone heated at 121ºC for 90 min using autoclave had the lowered protein and lipid contents but increased ash content with highest calcium (29.65 ± 0.69%), phosphorus (15.80 ± 0.07%) and iron (15.10 ± 0.61 mg/kg) contents, compared to those with shorter heating time. Therefore, pre-heat treatment could reduce the organic compounds and decrease bone hardness for further process, especially for bio-calcium production.

Chemical Compositions and Characteristics of Biocalcium from Pre-Cooked Tuna Bone as Influenced by Sodium Chloride Pretreatment and Defatting by Asian Seabass Lipase.

Pre-cooked bone is a waste product generated during tuna processing and can serve as a potential source of biocalcium (BC). Generally, non-collagenous protein and fat must be removed properly from bone. A NaCl solution can be used to remove such proteins, while fish lipase can be used in a green process, instead of solvent, for fat removal. Thus, this study aimed to investigate the impact of NaCl pretreatment at different concentrations in combination with heat to eliminate non-collagenous proteins, and to implement fish lipase treatments at varying levels for fat removal, for BC production from pre-cooked tuna bone. Optimal NaCl pretreatment of bone was achieved when a 5% NaCl solution at 80 °C was used for 150 min. The lowest lipid content was obtained for bone defatted with crude lipase extract (CLE) at 0.30 Unit/g of bone powder for 2 h. BC powder from bone defatted with CLE (DF-BC) possessed greater contents of ash, calcium, and phosphorus and smaller particle sizes than the control BC powder. X-ray diffractograms suggested that both BC powders consisted of hydroxyapatite as a major compound, which had a crystallinity of 62.92-63.07%. An elemental profile confirmed the presence of organic and inorganic matter. Thus, BC powder could be produced from pre-cooked tuna bone using this 'green process'.

Chemical Compositions and Characteristics of Biocalcium from Asian Sea Bass (Lates calcarifer) Scales as Influenced by Pretreatment and Heating Processes.

Asian sea bass scales discarded from the fish processing industry contain collagen and calcium. The production of biocalcium can increase their value. The effect of alkaline pretreatment on non-collagenous protein removal from scales was investigated. The alkaline pretreatment of scales was optimal when 2 M NaOH solution was used for 10 min. The impacts of heating processes of varying times on chemical compositions and characteristics of biocalcium (BC) powder from alkali-pretreated scales were also studied. A lower loss of hydroxyproline (HYP) and decreased hardness of scales were obtained when the scales were treated with a boiling process. BC powders from the scales subjected to boiling (B-BC) had higher yield and HYP content than BC powders using a high-pressure heating (HP-BC) process. An augmented heating time (10-30 min) lowered yield, HYP, moisture, and protein contents in BC powder regardless of the heating processes. HP-BC powder had higher ash, calcium, and phosphorus contents than B-BC powder. A whiter color and larger mean particle size were attained for the B-BC powders. X-ray diffractograms revealed that all BC powders had hydroxyapatite, which had a crystallinity of 53.60-66.54%, as a major component. FTIR spectra confirmed that all BC powders comprised proteins and inorganic matter. BC powder from scales with high yield and satisfactory characteristics could be used in calcium supplements.

Textural, Sensory, and Chemical Characteristic of Threadfin Bream (Nemipterus sp.) Surimi Gel Fortified with Bio-Calcium from Bone of Asian Sea Bass (Lates calcarifer).

The effects of Asian sea bass (Lates calcarifer) bio-calcium (ASBB) at different levels (0, 2, 4, 6, 8, and 10%) (w/w) on properties of threadfin bream (Nemipterus sp.) surimi gel were investigated. ASBB addition increased breaking force and deformation, while reduced expressible moisture content (p < 0.05) of surimi gel. L* (lightness), a* (redness), and b* (yellowness) values were increased with augmenting ASBB levels; however, whiteness slightly decreased in surimi gel incorporated with ASBB (p < 0.05). Higher likeness scores were noticed in surimi gel containing ASBB, compared to that of the control. However, a slight decrease in the likeness score was noticed in surimi gel with 10% (w/w) ASBB (p < 0.05). Surimi gel added with 8% (w/w) ASBB possessed the increase in breaking force by 80% from the control and had the highest likeness score. Texture profile analysis of surimi gel added with ASBB showed the improved texture characteristics with coincidentally higher storage modulus of surimi paste. Surimi gel with 8% (w/w) ASBB had a denser and finer microstructure with higher ash, calcium, and phosphorous contents, compared to the control. Thus, incorporation of bio-calcium up to 8% (w/w) not only increased mineral content, but also improved textural, sensory, and microstructural properties of surimi gel.

Physical and chemical characteristics of Asian sea bass bio-calcium powders as affected by ultrasonication treatment and drying method.

The effects of ultrasonication and drying method on particle size and other product characteristics of bio-calcium powder from Asian sea bass (Lates calcarifer) backbone were investigated. Ultrasonication was performed at different amplitudes (60%, 70%, and 80%) for varying periods (15 and 30 min). Ultrasonication at higher amplitudes for a longer time reduced the powder particle size more effectively (p < .05), but had no impact on zeta potential (p > .05). The bio-calcium powder ultrasonicated at 70% amplitude for 15 min had the smallest particle size (3.38 µm) when compared to the control (28.85 µm). When the ultrasonicated bio-calcium was subjected to drying, freeze-drying produced powders with higher calcium solubility but lower whiteness than hot air (tray) drying. The results suggest that the ultrasonication is a potential suitable method to reduce the size of bio-calcium powders, while the drying method slightly affected the product characteristics. The bio-calcium powder could serve as a suitable functional ingredient for food fortification aimed at improving the calcium bioavailability. Particle size of bio-calcium powder from fishbone could affect the mouth feel and calcium solubility when used for food product fortification. This work showed that ultrasonication could be used to obtain up to 10-fold reduction in the particle size of fishbone bio-calcium powders, which promotes increased calcium solubility when subjected to simulated gastrointestinal tract digestion. Few differences in characteristics of the bio-calcium powder were observed for freeze-dried and hot air-dried samples. Thus, an economical, safe, and fast process can be implemented for the production of small particle size bio-calcium powder from fishbone.

Protein hydrolysate from salmon frames: Production, characteristics and antioxidative activity.

Protein hydrolysates from two forms of salmon frames named "chunk" and "mince" were produced and characterized. Both samples were subjected to hydrolysis using alcalase and papain at 1%-3% (w/w protein) for 0-240 min. Hydrolysate prepared with either protease at 3% for 180 min had the solid yield of 24.05%-26.39%. Hydrolysates contained 79.20%-82.01% proteins, 6.03%-6.34% fat, 9.81%-11.09% ash, and 4.02%-5.80% moisture. Amino acid profile showed that all hydrolysates had glutamic acid/glutamine (113.45-117.56 mg/g sample), glycine (77.86-86.18 mg/g sample), aspartic acid/asparagine (76.04-78.67 mg/g sample), lysine (61.97-65.99 mg/g sample), and leucine (54.30-57.31 mg/g sample) as the predominant amino acids. The size distributions determined by gel filtration chromatography varied, depending on proteases and the form of frame used for the hydrolysis. Different hydrolysates showed varying antioxidant capacities. Thus, protein hydrolysates from salmon frame could be used as a nutritive supplement in the protein deficient foods. PRACTICAL APPLICATIONS: Frames of salmon are by-products from salmon fish processing industries. The frames contained the remaining meat, hence they can be used for the preparation of protein hydrolysates. Generally, hydrolysates from fish by-products have been regarded as a promising food supplement, because they are rich in amino acids. Additionally, hydrolysates possess antioxidant activity, which is of health benefit. To produce the hydrolysate with less time consumption, the use of frame chunk instead of minced frame can be of better choice. Thus, frame of salmon, especially in chunk form, could be used as a raw material for production of protein hydrolysate using alcalase. The hydrolysate produced from salmon frame could serve as an alternative nutritive supplement to tackle the nutrition inadequacies in foods.

Electronic Transport Properties of Epitaxial Si/SiGe Heterostructures Grown on Single-Crystal SiGe Nanomembranes.

To assess possible improvements in the electronic performance of two-dimensional electron gases (2DEGs) in silicon, SiGe/Si/SiGe heterostructures are grown on fully elastically relaxed single-crystal SiGe nanomembranes produced through a strain engineering approach. This procedure eliminates the formation of dislocations in the heterostructure. Top-gated Hall bar devices are fabricated to enable magnetoresistivity and Hall effect measurements. Both Shubnikov-de Haas oscillations and the quantum Hall effect are observed at low temperatures, demonstrating the formation of high-quality 2DEGs. Values of charge carrier mobility as a function of carrier density extracted from these measurements are at least as high or higher than those obtained from companion measurements made on heterostructures grown on conventional strain graded substrates. In all samples, impurity scattering appears to limit the mobility.

Strain engineered SiGe multiple-quantum-well nanomembranes for far-infrared intersubband device applications.

SiGe/Si quantum wells are of great interest for the development of Group-IV THz quantum cascade lasers. The main advantage of Group-IV over III-V materials such as GaAs is that, in the former, polar phonon scattering, which significantly diminishes the efficiency of intersubband light emission, is absent. However, for SiGe/Si multiple-quantum-well structures grown on bulk Si, the lattice mismatch between Si and Ge limits the critical thickness for dislocation formation and thus the number of periods that can be grown. Similarly, the use of composition-graded SiGe films as a lattice-matched substrate leads to the transfer of dislocations from the graded buffer substrate into the quantum wells, with a consequent decrease in light emission efficiency. Here we instead employ nanomembrane strain engineering to fabricate dislocation-free strain relaxed substrates, with lattice constants that match the average lattice constants of the quantum wells. This procedure allows for the growth of many periods with excellent structural properties. The samples in this work were grown by low-pressure chemical vapor deposition and characterized via high-resolution X-ray diffraction and far-infrared transmission spectroscopy, showing narrow intersubband absorption features indicative of high crystalline quality.