A Simple 3-Dimensional Printed Aid for a Corrective Palmar Opening Wedge Osteotomy of the Distal Radius.

The reconstruction of malunited distal radius fractures is often challenging. Virtual planning techniques and guides for drilling and resection have been used for several years to achieve anatomic reconstruction. These guides have the advantage of leading to better operative results and faster surgery. Here, we describe a technique using a simple implant independent 3-dimensional printed drill guide and template to simplify the surgical reconstruction of a malunited distal radius fracture.

Dorsal Plate Osteosynthesis in Simple and Complex Fractures of the Distal Radius: A Radiological Analysis of 166 Cases.

Background To report the radiologic outcome and rate of complications of open reduction and internal fixation (ORIF) using a dorsal plate fixation of simple and complex distal radius fractures in adult patients. Methods Patients treated with dorsal ORIF of simple and complex distal radius fractures between December 2008 and April 2013 were included in this single-center retrospective study. Type of fracture, radiographic measurements, and complications were documented. Results One-hundred and sixty-six patients/fractures were included. Restoration of radial inclination (22° ± 3°) was achieved in 38%. Radial height (14 ± 1 mm) was least likely to be restored to normal values postoperative in 25%. Normal ulnar variance (0.7 ± 1.5 mm) could be observed in 60% and adequate volar tilt (11° ± 5°) was achieved in 50% at final follow-up. We observed one loss of reduction in an AO type C2 fracture and a total of 15 nonimplant-related minor clinical complications. Conclusion Our radiographic findings after dorsal plating are comparable to those published on volar plating. The changes in radial height and volar tilt could be attributed to projection-related differences in the radiographs and did not signify a loss of reduction in all cases. Clinical Relevance Dorsal plating of distal radius fractures is safe and remains an important approach in the treatment of complex distal radius fractures. Complications in our study were even less compared to those reported in the literature. Type of Study/Level of Evidence This is a Type IV study. Level of Experience of Surgeons The level of experience of surgeons is III-V.

Intra-Articular Distal Ulnar Sliding Osteotomy for Ulnar Shortening.

BACKGROUND: Ulnocarpal impaction is the most common reason to perform ulnar shortening osteotomy. There are 3 osteotomy techniques for ulnar shortening: transverse, step-cut, and oblique cut1-3.First described by Milch4 in 1941, extra-articular diaphyseal oblique or transverse shortening is the most frequently performed type of shortening. However, it is associated with a nonunion rate of up to 10%, and irritation by implants requiring removal occurs in up to 28% of cases5,6. Intra-articular procedures such as the wafer procedure affect the distal ulnar joint surface, which can lead to stiffness of the distal radioulnar joint (DRUJ) due to scar tissue formation and adhesion of the triangular fibrocartilage complex (TFCC)7. Lapner et al.8 described increased pressure in the DRUJ after the wafer procedure, which may lead to an early onset of osteoarthritis. Complication rates between 8% for open wafer procedures and 21% for arthroscopic wafer procedures have been described9.Intra-articular shortening has also been described by Slade and Gillon10 in 2007 and Hammert et al.11 in 2012 and was tested in cadavers by Greenberg et al.12 in 2013. This closing wedge technique preserves the distal joint surface of the ulna and also allows for easy correction of the inclination of the hub joint surface of the ulna.In contrast to the technique of Slade, our described osteotomy is steeper and longer proximally, which allows for fixation with >2 screws13-16. Rapid healing of the metaphyseal bone compared with diaphyseal bone is described, and implant removal is necessary less often14,17,18.With the described procedure, the interosseous membrane remains untouched, especially the distal oblique bundle, which additionally provides stability of the DRUJ in 40% of patients19. DESCRIPTION: A dorso-ulnar approach through the fifth extensor sheath is performed. The ulnocarpal joint and the DRUJ are accessed through an arthrotomy distal and proximal to the TFCC. The foveal attachment of the TFCC and the subsheath of the sixth extensor sheath are visualized. The osteotomy is intra-articular oblique from distal ulnar to proximal radial. Sliding the head of the ulna proximally achieves the desired shortening of up to 5 mm, and the head is fixed using 2, 3, or 4 cannulated headless screws. A slight correction of the axis of the ulnar head is also possible. ALTERNATIVES: An alternative to this procedure is extra-articular osteotomy using a palmar or dorsal ulnar approach. If necessary, additional ulnocarpal procedures can be performed in an open or arthroscopically assisted manner. RATIONALE: The shortening takes place only in the articular part of the distal aspect of the ulna. This procedure can easily be combined with TFCC repair, synovectomy of the DRUJ, or repair or reconstruction of the lunotriquetral ligament if needed. Shortening of up to 5 mm is possible.

The pi plate: an implant for unstable extension fractures of the distal radius in patients with osteoporotic bone.

Extension fractures of the distal radius are very common injuries in elderly women caused by moderate energy trauma. Nevertheless there is no consensus about how these fractures should be treated. Anatomic reduction of the distal radius is necessary to achieve good functional results. In particular, the elderly patient, who may have to use crutches or a walker, will need a pain-free wrist under axial load. The pi plate is designed for distal radius fractures. It has been widely criticized for causing irritation and/or rupture of the extensor tendons. Most complications of the implant can be avoided with a careful operative technique. To prevent ruptures of the extensor tendon implant removal after 4 to 6 months is recommended. In osteoporotic bone the pi plate guarantees good stability with minimal postoperative loss of reduction. The operative technique is described in detail and common complications are discussed.

Long-term results after repair and augmentation ligamentoplasty of rotatory subluxation of the scaphoid.

Twenty-two patients had scapholunate ligament repairs combined with a new augmentation ligamentoplasty for chronic scapholunate dissociation. All were evaluated by physical and radiologic examination after a mean postoperative follow-up period of 63 months (range, 12-134 mo). According to Green and O'Brien and Johnson and Carrera scores 5/8 had excellent, 13/12 good, and 4/2 fair results. Thirteen were free of pain; 6 had mild pain and 3 had moderate pain. Nineteen returned to their original occupation. There was an average loss of 10 degrees of flexion, 9 degrees of extension, and 11% of grip force compared with the opposite wrist. Radiologic examination showed an average decrease of 12 degrees of the scapholunate and 10 degrees of the radiolunate angles compared with the levels before surgery. No signs of degenerative osteoarthritis were found in 16 (73%) cases. Five wrists showed a distinct pattern of midcarpal degeneration correlating with notable dorsal intercalated segment instability after surgery, and 2 cases had signs of radioscaphoid degeneration.