RESUMO
A methodology has been demonstrated to consolidate Ti-6Al-4V powder without taking it to the liquid state by novel combination of the electron beam melting additive manufacture and hot isostatic pressing processes. This results in improved static mechanical properties (both strength and yield) in comparison to standard EBM processed material. In addition, the ability to generate microstructurally graded components has been demonstrated by generating a component with a significant change in both microstructure and mechanical properties. This is revealed by the use of electron backscattered diffraction and micro hardness testing to produce maps showing a clear distinction between materials consolidated in different ways. The variation in microstructure and mechanical properties is attributed to the different thermal history experienced by the material at different locations. In particular, it is found that the rapid cooling experienced during EBM leads to a typical fine α lath structure, whereas a more equiaxed α grains generated by diffusion is found in HIP consolidated powder.
RESUMO
Without post-manufacture HIPing the fatigue life of electron beam melting (EBM) additively manufactured parts is currently dominated by the presence of porosity, exhibiting large amounts of scatter. Here we have shown that the size and location of these defects is crucial in determining the fatigue life of EBM Ti-6Al-4V samples. X-ray computed tomography has been used to characterise all the pores in fatigue samples prior to testing and to follow the initiation and growth of fatigue cracks. This shows that the initiation stage comprises a large fraction of life (>70%). In these samples the initiating defect was often some way from being the largest (merely within the top 35% of large defects). Using various ranking strategies including a range of parameters, we found that when the proximity to the surface and the pore aspect ratio were included the actual initiating defect was within the top 3% of defects ranked most harmful. This lays the basis for considering how the deposition parameters can be optimised to ensure that the distribution of pores is tailored to the distribution of applied stresses in additively manufactured parts to maximise the fatigue life for a given loading cycle.
RESUMO
Metallic powder bed additive manufacturing is capable of producing complex, functional parts by repeatedly depositing thin layers of powder particles atop of each other whilst selectively melting the corresponding part cross-section into each layer. A weakness with this approach arises when melting overhanging features, which have no prior melted material directly beneath them. This is due to the lower thermal conductivity of the powder relative to solid material, which as a result leads to an accumulation of heat and thus distortion. The Electron Beam Melting (EBM) process alleviates this to some extent as the powder must first be sintered (by the beam itself) before it is melted, which results in the added benefit of increasing the thermal conductivity. This study thus sought to investigate to what extent the thermal conductivity of local regions in a titanium Ti-6Al-4V powder bed could be varied by imparting more energy from the beam. Thermal diffusivity and density measurements were taken of the resulting sintered samples, which ranged from being loosely to very well consolidated. It was found that the calculated thermal conductivity at two temperatures, 40 and 730 °C, was more than doubled over the range of input energies explored.