RESUMO
This paper will present a simple method for measuring the radon exhalation rate from the medium surface in two cycles and also avoiding the effects of back-diffusion and chamber leakage. The method is based on a combination of the "accumulation chamber" technique and a radon monitor. The radon monitor performs the measurement of the radon concentration inside the accumulation chamber, and then the radon exhalation rate can be obtained by simple calculation. For reducing the systematic error and the statistical uncertainty, too short of total measurement time is not appropriate, and the first cycle time should be about 70 % of the total measurement. The radon exhalation rate from the medium surface obtained through this method is in good agreement with the reference value. This simple method can be applied to develop and improve the instruments for measuring radon exhalation rate.
Assuntos
Poluentes Radioativos do Ar/análise , Monitoramento de Radiação/métodos , Radônio/análise , Difusão , Monitoramento de Radiação/instrumentaçãoRESUMO
Radon-222 (Rn-222) exhalation rate is vital for estimating radiation risk from many kinds of materials. AlphaGUARD measures the radon concentration based on the ionization chamber principle, which is currently recognized as a reference instrument to measure radon. In China, measurements of radon exhalation rate are performed by AlphaGUARD operated in flow-through mode on a reference device to verify measurement accuracy. These measurements are performed in both open and closed loop. AlphaGUARD can fast rapidly the variation of the radon concentration in the chamber, which is tightly pressed against the surface of the medium to accumulate the exhaled radon. When the model is used to obtain the radon exhalation rate, the radon exhalation rates obtained by nonlinear data fitting on the measured radon concentrations are similar to the reference value of the device. The difference of radon exhalation rate values of six measurements is small.
Assuntos
Poluentes Radioativos do Ar , Monitoramento de Radiação , Radônio , Radônio/análise , Expiração , Poluentes Radioativos do Ar/análiseRESUMO
Radon exhalation rate from soil is a critical factor in evaluating environmental radon levels. However, AlphaGUARD PQ2000PRO may have some sensitivity towards thoron, which can have a significant impact on radon measurement. The traditional radon exhalation models generally ignore the presence of thoron, leading to an overestimation of the radon exhalation rate from soil. To handle this issue, a new model was proposed based on an analysis of several previous studies on radon exhalation theories. To prove the feasibility of the model, the radon exhalation rate measurements were performed by two different types of detectors-AlphaGUARD PQ2000PRO and RAD7. The radon exhalation rate obtained by using the new model is in good agreement with that obtained by using the theoretical model of radon exhalation of RAD7 within one standard error. This new model can be applied to accurately measure radon exhalation rate from soil by the PIC detector (PQ2000PRO).
Assuntos
Poluentes Radioativos do Ar , Monitoramento de Radiação , Radônio , Poluentes Radioativos do Solo , Radônio/análise , Solo , Poluentes Radioativos do Ar/análise , Expiração , Poluentes Radioativos do Solo/análiseRESUMO
The U.S. Environmental Protection Agency established the maximum contaminant level limit for radon concentration in drinking water as 11.1 Bq L-1. A new device based on the bubbling method with a 290 mL sample bottle was designed for intermittent continuous measurement of water radon concentration. A STM32 is used to control the switch of the water pump and the valves. The Water-Radon-Measurement software written in C# is to connect RAD7 and calculate the water radon concentration automatically.
RESUMO
As Rn-222 decays, an alpha particle is emitted and the residual polonium nucleus recoils in the opposite direction. At the end of the recoil path, 88% of the polonium atoms have a positive charge and 12% are neutral. The electric potential distribution in the 60 ml hemispherical internal cell of the radon monitor based on electrostatic collection is studied for reducing the combined probability of the positively charged Po-218 and the OH- produced by the ionization of water vapour in the air. The COMSOL software is used to simulate the electric potential distribution in the internal cell of the radon monitor based on the electrostatic collection method at 27°C, a pressure of 0.1 Mpa. For improving the collection efficiency of Po-218 ions, the average collection time along vertical and oblique lines is calculated when the upper surface of the internal cell is plastic, uncharged metal and charged metal, respectively. Assuming that the gas in the internal cell is uniformly distributed, the results show that if the upper surface of the hemispherical internal cell is plastic or uncharged metal, the electric potential formed in the internal cell is more uniform, and it is beneficial to reduce the total collection time of the positively charged Po-218 ions, thereby improving collection efficiency. The simulation results can be used as an effective reference for optimizing the design of the internal cell structure of the radon monitor based on electrostatic collection method.
Assuntos
Poluentes Radioativos do Ar , Polônio , Radônio , Radônio/análise , Polônio/análise , Eletricidade Estática , Vapor , Poluentes Radioativos do Ar/análise , PlásticosRESUMO
Radon exhaled from building material surfaces is an important source of indoor radon. Yangjiang, located in the southern part of mainland China, is well-known as a high background radiation area (HBRA). Rather, high levels of radon and thoron concentration have been observed in adobe and brick houses. Reducing the indoor radon concentration remains an important issue in the high background radiation areas of China and the world. Generally, the walls of Chinese dwellings are solid. In this paper, a simple one-dimensional model for predicting the radon diffusion in a cavity wall is proposed, and an analysis formula describing the radon exhalation rate from cavity wall surfaces is presented. The influence on the radon exhalation rate due to leakage through structural joints and building material cracks is analyzed. The simulation results indicate that the radon exhalation rate from a cavity wall surface is far lower than that from a solid wall. The structure of cavity walls themselves is therefore useful as a mechanism for reducing the indoor radon in high background radiation areas across the world.
Assuntos
Poluentes Radioativos do Ar , Poluição do Ar em Ambientes Fechados , Monitoramento de Radiação , Radônio , Poluentes Radioativos do Ar/análise , Poluição do Ar em Ambientes Fechados/análise , Radiação de Fundo , China , Materiais de Construção , Expiração , Habitação , Radônio/análiseRESUMO
The method for measuring radon exhalation rate from the medium surface with a ventilation chamber is un-replaceable when surveying the radon exhalation rate continuously. Generally, the pump flow rate is an important parameter to obtain the radon exhalation rate from the measurement model. Our previous research indicated that the results of those measurements are inaccurate when the air change rate is not far larger than the effective decay constant. A no flow meter method is proposed for measuring radon exhalation from the medium surface with a ventilation chamber. A constant K is used to replace the sum of the air change rate and the effective decay constant. The radon exhalation rate and the value of K can be obtained by nonlinear data fitting through a novel model. The air flow rate is not a parameter of this model, and the flow meter is unnecessary in this measurement. The radon exhalation rates obtained by verification experiments are within the accepted values for the reference value. This method can be applied to develop and improve the instruments for measuring radon exhalation rate.
RESUMO
Optically-stimulated luminescent dosimeters are capable of being interrogated multiple times post-irradiation. Each interrogation removes a fraction of the signal stored within the optically-stimulated luminescent dosimeter. This signal loss must be corrected to avoid systematic errors in estimating the average signal of a series of optically-stimulated luminescent dosimeter interrogations and requires a minimum number of consecutive readings to determine an average signal that is within a desired accuracy of the true signal with a desired statistical confidence. This paper establishes a technical basis for determining the required number of readings for a particular application of these dosimeters when using certain OSL dosimetry systems.
Assuntos
Artefatos , Guias como Assunto , Iluminação/normas , Dispositivos Ópticos/normas , Dosimetria Termoluminescente/instrumentação , Dosimetria Termoluminescente/normas , Calibragem/normas , Desenho de Equipamento , Análise de Falha de Equipamento , Iluminação/instrumentação , Doses de Radiação , Reprodutibilidade dos Testes , Semicondutores , Sensibilidade e EspecificidadeRESUMO
The radon exhalation rate can be obtained quickly and easily from the evolution of radon concentration over time in the accumulation chamber. Radon monitoring based on the electrostatic collection method is not interfered with by (220)Rn. In this paper, we propose that the difference between radon and (218)Po concentrations in the measurement cell of this kind of radon exhalation monitor is the main system error, and it changes with time and different effective decay constants. Based on the results of simulation experiments, we propose that the calibration factor obtained from the suitable experiment cannot completely correct the system error, even if it is useful to reduce the measurement error. The better way for reducing measurement error is to use the new measurement model which we have proposed in recent years.
Assuntos
Poluentes Radioativos do Ar/análise , Monitoramento de Radiação/instrumentação , Monitoramento de Radiação/métodos , Radônio/análise , Calibragem , Modelos TeóricosRESUMO
The accident at the Fukushima Daiichi Nuclear Power Plant (FDNPP) in Japan resulted in significant releases of fission products. While substantial data exist concerning outdoor air radioactivity following the accident, the resulting indoor radioactivity remains pure speculation without a proper method for estimating the ratio of the indoor to outdoor airborne radioactivity, termed the airborne sheltering factor (ASF). Lacking a meaningful value of the ASF, it is difficult to assess the inhalation doses to residents and evacuees even when outdoor radionuclide concentrations are available. A simple model was developed and the key parameters needed to estimate the ASF were obtained through data fitting of selected indoor and outdoor airborne radioactivity measurement data obtained following the accident at a single location. Using the new model with values of the air exchange rate, interior air volume, and the inner surface area of the dwellings, the ASF can be estimated for a variety of dwelling types. Assessment of the inhalation dose to individuals readily follows from the value of the ASF, the person's indoor occupancy factor, and the measured outdoor radioactivity concentration.
Assuntos
Poluentes Radioativos do Ar/análise , Poluição do Ar em Ambientes Fechados/análise , Monitoramento de Radiação , Acidente Nuclear de Fukushima , Japão , Análise de RegressãoRESUMO
This paper presents a process in which a radon monitor based on the electrostatic collection method is used to measure the (222)Rn and (220)Rn exhalation rates simultaneously and continuously employing a ventilation-type accumulation chamber. Generally, the radon exhalation rate can be measured by accumulation technique, but cannot be measured continuously. The advantage of this method using a ventilation-type accumulation chamber is that the radon exhalation rates can be measured continuously. Even though the environmental air is drawn into the chamber, the low atmospheric values of radon and thoron do not influence the measurement accuracy. The (222)Rn and (220)Rn exhalation rates error from the environmental air is less than 5% in this experiment.
Assuntos
Poluentes Radioativos do Ar/análise , Monitoramento de Radiação/métodos , Radônio/análise , Poluentes Radioativos do Solo/análise , Solo/química , Eletricidade EstáticaRESUMO
Generally, 88% of the freshly generated 218Po ions decayed from 222Rn are positively charged. These positive ions become neutralized by recombination with negative ions, and the main source of the negative ions is the OH- ions formed by radiolysis of water vapor. However, the neutralization rate of positively charged 218Po versus the square root of the concentration of H2O will be a constant when the concentration of H2O is sufficiently high. Since the electron affinity of the hydroxyl radical formed by water vapor is high, the authors propose that the hydroxyl radical can grab an electron to become OH-. Because the average period of collision with other positively charged ions and the average life of the OH- are much longer than those of the electron, the average concentration of negative ions will grow when the water vapor concentration increases. The authors obtained a model to describe the growth of OH- ions. From this model, it was found that the maximum value of the OH- ion concentration is limited by the square root of the radon concentration. If the radon concentration is invariant, the OH- ion concentration should be approximately a constant when the water vapor concentration is higher than a certain value. The phenomenon that the neutralization rate of positively charged 218Po versus the square root of the water vapor concentration will be saturated when the water vapor concentration is sufficiently high can be explained by this mechanism. This mechanism can be used also to explain the phenomenon that the detection efficiency of a radon monitor based on the electrostatic collection method seems to be constant when the water vapor concentration is high.
Assuntos
Polônio/química , Radioquímica , Água/química , Hidróxidos/química , Radônio/química , VolatilizaçãoRESUMO
Several measurements of the radon concentration are performed by RAD7 in the University of South China. We find that 30-40 min is needed for RAD7 for tracing the concentration of the standard radon chamber. There are two reasons. The first is that the sufficient time of air cycle is needed for the radon concentration in internal cell of RAD7 equal to that of the environment; and the second is that the sufficient decay time is needed for the (218)Po concentration in internal cell of RAD7 equal to that of the radon. We used a zeroth order approximation to describe the evolution of the environment radon concentration, and obtained a novel algorithm for quick and continuous tracing the change of radon concentration. The corrected radon concentration obtained through this method is in good agreement with the reference value. This method can be applied to develop and improve the instruments for tracing the change of radon concentration quickly.