Correction: Rate constants, processivity, and productive binding ratio of chitinase A revealed by single-molecule analysis.

Correction for 'Rate constants, processivity, and productive binding ratio of chitinase A revealed by single-molecule analysis' by Akihiko Nakamura et al., Phys. Chem. Chem. Phys., 2018, DOI: .

Rate constants, processivity, and productive binding ratio of chitinase A revealed by single-molecule analysis.

Serratia marcescens chitinase A is a linear molecular motor that hydrolyses crystalline chitin in a processive manner. Here, we quantitatively determined the rate constants of elementary reaction steps, including binding (kon), translational movement (ktr), and dissociation (koff) with single-molecule fluorescence imaging. The kon for a single chitin microfibril was 2.1 × 109 M-1 µm-1 s-1. The koff showed two components, k (3.2 s-1, 78%) and k (0.38 s-1, 22%), corresponding to bindings to different crystal surfaces. From the kon, k, k and ratio of fast and slow dissociations, dissociation constants for low and high affinity sites were estimated as 2.0 × 10-9 M µm and 8.1 × 10-10 M µm, respectively. The ktr was 52.5 nm s-1, and processivity was estimated as 60.4. The apparent inconsistency between high turnover (52.5 s-1) calculated from ktr and biochemically determined low kcat (2.6 s-1) is explained by a low ratio (4.8%) of productive enzymes on the chitin surface (52.5 s-1 × 0.048 = 2.5 s-1). Our results highlight the importance of single-molecule analysis in understanding the mechanism of enzymes acting on a solid-liquid interface.

Single-molecule Imaging Analysis of Binding, Processive Movement, and Dissociation of Cellobiohydrolase Trichoderma reesei Cel6A and Its Domains on Crystalline Cellulose.

Trichoderma reesei Cel6A (TrCel6A) is a cellobiohydrolase that hydrolyzes crystalline cellulose into cellobiose. Here we directly observed the reaction cycle (binding, surface movement, and dissociation) of single-molecule intact TrCel6A, isolated catalytic domain (CD), cellulose-binding module (CBM), and CBM and linker (CBM-linker) on crystalline cellulose Iα The CBM-linker showed a binding rate constant almost half that of intact TrCel6A, whereas those of the CD and CBM were only one-tenth of intact TrCel6A. These results indicate that the glycosylated linker region largely contributes to initial binding on crystalline cellulose. After binding, all samples showed slow and fast dissociations, likely caused by the two different bound states due to the heterogeneity of cellulose surface. The CBM showed much higher specificity to the high affinity site than to the low affinity site, whereas the CD did not, suggesting that the CBM leads the CD to the hydrophobic surface of crystalline cellulose. On the cellulose surface, intact molecules showed slow processive movements (8.8 ± 5.5 nm/s) and fast diffusional movements (30-40 nm/s), whereas the CBM-Linker, CD, and a catalytically inactive full-length mutant showed only fast diffusional movements. These results suggest that both direct binding and surface diffusion contribute to searching of the hydrolysable point of cellulose chains. The duration time constant for the processive movement was 7.7 s, and processivity was estimated as 68 ± 42. Our results reveal the role of each domain in the elementary steps of the reaction cycle and provide the first direct evidence of the processive movement of TrCel6A on crystalline cellulose.