MgB2 for MRI Magnets: Test Coils and Superconducting Joints Results.

Among key design and operation issues for MgB2 relevant to MRI magnets are: uniformity of current-carrying capacity over long lengths (>2 km) of wire; and reliability of a splicing technique. This paper presents experimental results of current-carrying capacities of a small test coil and joints, both made from MgB2 round wires, multifilament and monofilament (mono), manufactured by Hyper Tech Research, Inc. The test coils were wound with 95-m long unreacted, C (carbon)-doped MgB2 multifilament wire, sintered at 700°C for 90 min. The critical currents were measured in the 4.2 K-15 K and 0 T-5 T ranges. We have modified our original splicing technique, proven successful with unreacted, un-doped MgB2 multifilament wire sintered at 570°C, and applied it to splice both un-doped and C-doped mono wires sintered at 700°C. Most consistently good results were obtained using the un-doped mono wires. Also presented are results of a small joint-coil-PCS assembly of mono wire, operated in persistent mode at 50 A at >10 K.

High performance, advanced-internal-magnesium-infiltration (AIMI) MgB2 wires processed using a vapor-solid reaction route.

MgB2 superconducting wires made using a Mg infiltration method have reached a higher performance than either in-situ or ex-situ mixed powder based routes. Indeed, very high layer J c coupled with whole-strand J e (critical current per total strand cross section) exceeding 104 A cm-2 at 4.2 K, 10 T have been found for monocore MgB2 wires. However, previous multicore infiltration route wires have not reached their potential for J e due to partially reacted and non-uniform MgB2 layers. This study shows that 18-core MgB2 AIMI wires processed using a low temperature route can attain higher and more uniform J e values due to a more uniform MgB2 reaction layer. The formation of fully reacted, uniform MgB2 layers is attributed to the switch from a liquid-solid to a vapor-solid reaction route.

Conceptual designs of conduction cooled MgB2 magnets for 1.5 and 3.0T full body MRI systems.

Conceptual designs of 1.5 and 3.0 T full-body magnetic resonance imaging (MRI) magnets using conduction cooled MgB2 superconductor are presented. The sizes, locations, and number of turns in the eight coil bundles are determined using optimization methods that minimize the amount of superconducting wire and produce magnetic fields with an inhomogeneity of less than 10 ppm over a 45 cm diameter spherical volume. MgB2 superconducting wire is assessed in terms of the transport, thermal, and mechanical properties for these magnet designs. Careful calculations of the normal zone propagation velocity and minimum quench energies provide support for the necessity of active quench protection instead of passive protection for medium temperature superconductors such as MgB2. A new 'active' protection scheme for medium Tc based MRI magnets is presented and simulations demonstrate that the magnet can be protected. Recent progress on persistent joints for multifilamentary MgB2 wire is presented. Finite difference calculations of the quench propagation and temperature rise during a quench conclude that active intervention is needed to reduce the temperature rise in the coil bundles and prevent damage to the superconductor. Comprehensive multiphysics and multiscale analytical and finite element analysis of the mechanical stress and strain in the MgB2 wire and epoxy for these designs are presented for the first time. From mechanical and thermal analysis of our designs we conclude there would be no damage to such a magnet during the manufacturing or operating stages, and that the magnet would survive various quench scenarios. This comprehensive set of magnet design considerations and analyses demonstrate the overall viability of 1.5 and 3.0 T MgB2 magnet designs.