RESUMO
The creation of 2D van der Waals materials with ferromagnetism above room temperature is an essential goal toward their practical utilization in spin-based applications. Recent studies suggest that intercalating lithium in exfoliated flakes of the ferromagnet Fe3-xGeTe2 induces a nonzero magnetization at T â¼ 300 K. However, the nanoscale nature of such experiments precludes precise observations of structural and chemical changes upon intercalation. Here, we report the preparation of sodium-intercalated NaFe2.78GeTe2 as well as the investigation into its structure and magnetic properties. Sodium readily intercalates into the van der Waals gap, as revealed by synchrotron X-ray diffraction. Concurrently, the Fe2.78GeTe2 layer becomes heavily charge doped and strained via chemical pressure, yet retains its structure and ferromagnetic transition temperature of â¼140 K. However, we observe the presence of a ferromagnetic amorphous iron germanide impurity over a wide range of synthetic conditions, leading to room-temperature magnetization. This work highlights the importance of strain and electronic control for manipulating the Curie temperature in 2D ferromagnets, while emphasizing the need for careful chemical analysis when exploring phenomena in exfoliated layers.
RESUMO
Monolayer van der Waals (vdW) magnets provide an exciting opportunity for exploring two-dimensional (2D) magnetism for scientific and technological advances, but the intrinsic ferromagnetism has only been observed at low temperatures. Here, we report the observation of room temperature ferromagnetism in manganese selenide (MnSe x) films grown by molecular beam epitaxy (MBE). Magnetic and structural characterization provides strong evidence that, in the monolayer limit, the ferromagnetism originates from a vdW manganese diselenide (MnSe2) monolayer, while for thicker films it could originate from a combination of vdW MnSe2 and/or interfacial magnetism of α-MnSe(111). Magnetization measurements of monolayer MnSe x films on GaSe and SnSe2 epilayers show ferromagnetic ordering with a large saturation magnetization of â¼4 Bohr magnetons per Mn, which is consistent with the density functional theory calculations predicting ferromagnetism in monolayer 1T-MnSe2. Growing MnSe x films on GaSe up to a high thickness (â¼40 nm) produces α-MnSe(111) and an enhanced magnetic moment (â¼2×) compared to the monolayer MnSe x samples. Detailed structural characterization by scanning transmission electron microscopy (STEM), scanning tunneling microscopy (STM), and reflection high energy electron diffraction (RHEED) reveals an abrupt and clean interface between GaSe(0001) and α-MnSe(111). In particular, the structure measured by STEM is consistent with the presence of a MnSe2 monolayer at the interface. These results hold promise for potential applications in energy efficient information storage and processing.
RESUMO
Dental enamel forms extracellularly as thin ribbons of amorphous calcium phosphate (ACP) that initiate on dentin mineral in close proximity to the ameloblast distal membrane. Secreted proteins are critical for this process. Enam-/- and Ambn-/- mice fail to form enamel. We characterize enamel ribbon formation in wild-type (WT), Amelx-/- and Mmp20-/- mouse mandibular incisors using focused ion beam scanning electron microscopy (FIB-SEM) in inverted backscatter mode. In Amelx-/- mice, initial enamel mineral ribbons extending from dentin are similar in form to those of WT mice. As early enamel development progresses, the Amelx-/- mineral ribbons develop multiple branches, resembling the staves of a Japanese fan. These striking fan-shaped structures cease growing after attaining ~ 20 µm of enamel thickness (WT is ~ 120 µm). The initial enamel mineral ribbons in Mmp20-/- mice, like those of the Amelx-/- and WT, extend from the dentin surface to the ameloblast membrane, but appear to be fewer in number and coated on their sides with organic material. Remarkably, Mmp20-/- mineral ribbons also form fan-like structures that extend to ~ 20 µm from the dentin surface. However, these fans are subsequently capped with a hard, disorganized outer mineral layer. Amelogenin cleavage products are the only matrix components absent in both Amelx-/- and Mmp20-/- mice. We conclude that MMP20 and amelogenin are not critical for enamel mineral ribbon initiation, orientation, or initial shape. The pathological fan-like plates in these mice may form from the lack of amelogenin cleavage products, which appear necessary to form ordered hydroxyapatite.