The use of a novel injectable hydrogel nucleus pulposus replacement in restoring the mechanical properties of cyclically fatigued porcine intervertebral discs.

Repeated flexion and extension of an intervertebral disc has been shown to affect the angular stiffness of spinal motion segments and is a barometer of the mechanical integrity of the disc. A degenerated disc that loses height causes higher levels of stress on the annulus and facet joints which may increase its level of degeneration; restoring disc height may therefore help to slow this degenerative cascade. Previous research has indicated that nucleus implants have the potential to improve the mechanical characteristics of a disc and an implant that is custom-fit to the intervertebral disc yields the best results with respect to decreasing annular degeneration. Two groups of porcine spinal motion segments were exposed to repeated flexion and extension. One group was then injected with a novel hydrogel while the other group was used as a control. Both groups were then exposed to another round of cyclic flexion and extension to examine the effect that the hydrogel had on restoring the original mechanics to the motion segments. Angular stiffness was restored to the group which received the hydrogel injection in addition to a significant improvement in specimen height. No significant changes were seen in the group which did not receive an injection. It would appear that use of the novel injectable hydrogel is able to restore angular stiffness to cyclically fatigued spinal motion segments. It is also important to note that continued repetition of the event causing specimen fatigue after performing hydrogel injection will result in an eventual return to the same fatigued state.

Characterization of injectable hydrogels based on poly(N-isopropylacrylamide)-g-chondroitin sulfate with adhesive properties for nucleus pulposus tissue engineering.

The goal of this work is to develop an injectable nucleus pulposus (NP) tissue engineering scaffold with the ability to form an adhesive interface with surrounding disc tissue. A family of in situ forming hydrogels based on poly(N-isopropylacrylamide)-graft-chondroitin sulfate (PNIPAAm-g-CS) were evaluated for their mechanical properties, bioadhesive strength, and cytocompatibility. It was shown experimentally and computationally with the Neo-hookean hyperelastic model that increasing the crosslink density and decreasing the CS concentration increased mechanical properties at 37 °C, generating several hydrogel formulations with unconfined compressive modulus values similar to what has been reported for the native NP. The adhesive tensile strength of PNIPAAm increased significantly with CS incorporation (p < 0.05), ranging from 0.4 to 1 kPa. Live/Dead and XTT assay results indicate that the copolymer is not cytotoxic to human embryonic kidney (HEK) 293 cells. Taken together, these data indicate the potential of PNIPAAm-g-CS to function as a scaffold for NP regeneration.

Implications of poly(N-isopropylacrylamide)-g-poly(ethylene glycol) with codissolved brain-derived neurotrophic factor injectable scaffold on motor function recovery rate following cervical dorsolateral funiculotomy in the rat.

OBJECT: In a follow-up study to their prior work, the authors evaluated a novel delivery system for a previously established treatment for spinal cord injury (SCI), based on a poly(N-isopropylacrylamide) (PNIPAAm), lightly cross-linked with a polyethylene glycol (PEG) injectable scaffold. The primary aim of this work was to assess the recovery of both spontaneous and skilled forelimb function following a cervical dorsolateral funiculotomy in the rat. This injury ablates the rubrospinal tract (RST) but spares the dorsal and ventral corticospinal tract and can severely impair reaching and grasping abilities. METHODS: Animals received an implant of either PNIPAAm-g-PEG or PNIPAAm-g-PEG + brain-derived neurotrophic factor (BDNF). The single-pellet reach-to-grasp task and the staircase-reaching task were used to assess skilled motor function associated with reaching and grasping abilities, and the cylinder task was used to assess spontaneous motor function, both before and after injury. RESULTS: Because BDNF can stimulate regenerating RST axons, the authors showed that animals receiving an implant of PNIPAAm-g-PEG with codissolved BDNF had an increased recovery rate of fine motor function when compared with a control group (PNIPAAm-g-PEG only) on both a staircase-reaching task at 4 and 8 weeks post-SCI and on a single-pellet reach-to-grasp task at 5 weeks post-SCI. In addition, spontaneous motor function, as measured in the cylinder test, recovered to preinjury values in animals receiving PNIPAAm-g-PEG + BDNF. Fluorescence immunochemistry indicated the presence of both regenerating axons and BDA-labeled fibers growing up to or within the host-graft interface in animals receiving PNIPAAm-g-PEG + BDNF. CONCLUSIONS: Based on their results, the authors suggest that BDNF delivered by the scaffold promoted the growth of RST axons into the lesion, which may have contributed in part to the increased recovery rate.

A pilot study of poly(N-isopropylacrylamide)-g-polyethylene glycol and poly(N-isopropylacrylamide)-g-methylcellulose branched copolymers as injectable scaffolds for local delivery of neurotrophins and cellular transplants into the injured spinal cord.

OBJECT: The authors investigated the feasibility of using injectable hydrogels, based on poly(N-isopropylacrylamide) (PNIPAAm), lightly cross-linked with polyethylene glycol (PEG) or methylcellulose (MC), to serve as injectable scaffolds for local delivery of neurotrophins and cellular transplants into the injured spinal cord. The primary aims of this work were to assess the biocompatibility of the scaffolds by evaluating graft cell survival and the host tissue immune response. The scaffolds were also evaluated for their ability to promote axonal growth through the action of released brain-derived neurotrophic factor (BDNF). METHODS: The in vivo performance of PNIPAAm-g-PEG and PNIPAAm-g-MC was evaluated using a rodent model of spinal cord injury (SCI). The hydrogels were injected as viscous liquids into the injury site and formed space-filling hydrogels. The host immune response and biocompatibility of the scaffolds were evaluated at 2 weeks by histological and fluorescent immunohistochemical analysis. Commercially available matrices were used as a control and examined for comparison. RESULTS: Experiments showed that the scaffolds did not contribute to an injury-related inflammatory response. PNIPAAm-g-PEG was also shown to be an effective vehicle for delivery of cellular transplants and supported graft survival. Additionally, PNIPAAm-g-PEG and PNIPAAm-g-MC are permissive to axonal growth and can serve as injectable scaffolds for local delivery of BDNF. CONCLUSIONS: Based on the results, the authors suggest that these copolymers are feasible injectable scaffolds for cell grafting into the injured spinal cord and for delivery of therapeutic factors.