Efficient degradation of venlafaxine using intimately coupled high-active crystal facets exposed TiO2 and biodegradation system: Kinetic studies, biofilm stress behavior and transformation mechanism.

Intimately coupled photocatalysis and biodegradation (ICPB) system is a potential wastewater treatment technology, of which TiO2-based ICPB system has been widely studied. There are many ways to improve the degradation efficiency of the ICPB process, but no crystal facet engineering method has been reported yet. In this work, a new ICPB system coated with NaF-TiO2 exposing high energy facets was designed to degrade biorecalcitrant psychotropic drug - venlafaxine (VNF). Initially, the TiO2 crystal surface was modified with NaF, resulting in the formation of NaF-TiO2 with a 14.4% increase in the exposure ratio of (001). The contribution rate of ·OH was increased by 9.5%, and the contribution rate of h+ was increased by 33.2%. Next, NaF-TiO2 was loaded onto the surface of the sponge carrier, and then the ICPB system was constructed after about 15 days of biofilm formation. After the ICPB system was acclimated with VNF, the removal rate of COD decreased significantly (the lowest was 62.7%), but that of ammonia nitrogen remained at 50.5 ± 6.0% and the extracellular polymeric substance (EPS) secretion increased by 84.1 mg/g VSS. According to the high throughput results, at the phylum level, Proteobacteria and Chloroflexi together maintain the nitrogen removal capability and structural stability of the ICPB system. The relative abundance of Bacteroidota was significantly increased by 14.2%, suggesting that there may be some correlation between Bacteroidota and certain metabolites of the anti-depressant active ingredients. At the genus level, the Thauera (3.1%∼11.5%) is the major bacterial group that secretes EPS, protecting biofilm against external influences. Most of the changes in microorganisms are consistent with the decontamination properties and macroscopic appearance of EPS in the ICPB system. Finally, the degradation efficiency of ICPB system for VNF was investigated (92.7 ± 3.8%) and it was mostly through hydroxylation and demethylation pathways, with more small molecular products detected, providing the basis for biological assimilation of VNF. Collectively, the NaF-TiO2 based ICPB system would be lucrative for the future degradation of venlafaxine.

Environmentally relevant level of perfluorooctanoic acid affect the formation of aerobic granular sludge.

The growing increasing occurrence of perfluorooctanoic acid (PFOA) in wastewater has raised concerns about its potential impact on the environment. Nevertheless, the impact of PFOA at environmentally relevant level on the formation of aerobic granular sludge (AGS) is still a 'black box'. This study thus aims to fill this gap by comprehensive investigation of sludge properties, reactor performance and microbial community during the formation of AGS. It was found that 0.1 mg/L PFOA delayed the formation of AGS, causing relatively lower proportion of large size AGS at the end of operation process. Interestingly, the microorganisms contribute to the reactor's tolerance to PFOA by secreting more extracellular polymeric substances (EPS) to slow or block the entry of toxic substances into the cells. During the granule maturation period, the reactor nutrient removal especially chemical oxygen demand (COD) and total nitrogen (TN) were affected by PFOA, decreasing the corresponding removal efficiencies to ∼81.2% and ∼69.8%, respectively. Microbial analysis further revealed that PFOA decreased the abundances of Plasticicumulans, Thauera, Flavobacterium and Cytophagaceae_uncultured, but it has promoted Zoogloea and Betaproteobacteria_unclassified growth, which maintained the structures and functions of AGS. The above results revealed that the intrinsic mechanism of PFOA on the macroscopic representation of sludge granulation process was revealed, and it is expected to provide theoretical insights and practical support for direct adoption of municipal or industrial wastewater containing perfluorinated compounds to cultivate AGS.

[Change in Granulation Potential and Microbial Enrichment Characteristics of Sludge Induced by Microplastics].

Microplastics (MPs), as a new type of pollutant, are widely detected in sewage treatment plants. Currently, research on MPs in traditional sewage treatment systems has mainly been focused on the pollution level and distribution characteristics, with a lack of studying the impact of MPs on the sludge granulation. In order to explore the effect of MPs on the granulation process, a microplastic exposure test was conducted by adding polyethylene terephthalate microplastics (PET-MPs), which are widespread in the environment. The operating performance of the system, extracellular polymeric substance (EPS) composition, and flora enrichment were analyzed on the sludge granulation. The results showed that the exposure of PET-MPs significantly accelerated the sludge granulation process, whereas the increase in EPS content dominated by PN enhanced the sludge surface hydrophobicity; the granulation rate and EPS secretion were proportional to the exposed particle size. Microplastics and EPS secretions synergistically promoted the formation of granular sludge. However, continuous microplastic exposure led to deterioration of the system decontamination performance and inhibited the degradation process of pollutants, with the most negative effect of nitrite nitrogen accumulation under 250 µm PET-MPs exposure, as high as (5.08±0.24) mg·L-1. The high-throughput sequencing revealed that the microbial community diversity fell in the experimental group. The dominant bacteria at the phylum level were Proteobacteria and Bacteroidota on the sludge granulation. Rhodocyclaceae, Sphingomonadaceae, Flavobacteriaceae, and Rhodanobacteraceae promoted flocculation by increasing EPS secretion. The decrease in Comamonadaceae and Chitinophagaceae weakened the ammonia and nitrite oxidation capacity of the system, whereas the decrease in Rhodobacteraceae, Hyphomonadaceae, and Xanthomonadaceae inhibited the removal of nitrate nitrogen.

Interaction between perfluorooctanoic acid and aerobic granular sludge.

The increasing use of perfluorooctanoic acid (PFOA) raises concerns about its potential toxicity to the environment. However, the interaction between PFOA and aerobic granular sludge has never been documented. This work therefore aims to provide such support through investigating the fate of PFOA at environmentally relevant levels in aerobic granular sludge systems and its impact on aerobic granular sludge. Experimental results showed that 32.0%∼36.4% of wastewater PFOA was removed by aerobic granular sludge in stable operation when PFOA concentration was ranged from 0.1 to 1.0 mg/L. Mass balance analyses and X-ray photoelectron spectroscopy survey scan revealed that the removal of PFOA was dominated by adsorption rather than biodegradation, and sorption kinetic analysis indicated that inhomogeneous multilayer adsorption was responsible for this removal. The adsorbed PFOA deteriorated the settleability of granular sludge and biological nitrogen and phosphorus removal significantly. Experimental results showed that 1.0 mg/L PFOA inhibited anaerobic phosphate release, aerobic phosphate uptake, nitrate reduction, and nitrite reduction processes by 60%, 50%, 13.1%, and 5.8%, respectively. It was observed that PFOA induced large amounts of filamentous villus growing on the surface and increased the extracellular polymeric substances of granular sludge. Fourier-transform infrared spectra and X-ray photoelectron spectroscopy spectrum showed that several function groups in extracellular polymeric substances such as hydroxyl groups, amides and polysaccharides were affected by PFOA. It was also found that PFOA inhibited the cyclic transformations of polyhydroxyalkanoates and glycogen. Microbial community analyses showed that PFOA decreased the abundances of Nitrosomonas, Nitrospira, Accumulibacter, and other function microbes such as Rhodospirillaceae, Thauera, and Azoarcus.

Free ammonia-based sludge treatment reduces sludge production in the wastewater treatment process.

Excessive sludge production is one of the major challenges for biological wastewater treatment plants. This paper reports a new strategy to enhance sludge reduction from the wastewater treatment process. In this strategy, 1/5 of the sludge is withdrawn from the mainstream reactor into a side-stream unit for sludge treatment with 16 mg/L free ammonia (FA) for 24-40 h. The FA-treated sludge mixture is then returned to the mainstream reactor. To demonstrate this concept, two reactors treating synthetic domestic wastewater were operated, with one serving as the experimental reactor and the other as the control. Experimental results showed that the experimental reactor exhibited 20% lower in sludge production than the control. FA treatment effectively disintegrated a portion of extracellular or intracellular substances of sludge cells in the FA treatment unit and lowered the observed sludge yields in the mainstream reactor, which were the main reasons for the sludge reduction. Although FA treatment decreased the activities of nitrifiers, denitrifiers, and polyphosphate accumulating organisms in the FA treatment unit, this strategy did not negatively affect the reactor performance and sludge properties of the experimental reactor such as sludge settleability, organic removal, nitrogen removal and phosphorus removal. Further investigation showed that the organics released from the FA treatment process could be used by PAOs and denitrifiers for carbon sources.

Design strategies and applications of nacre-based biomaterials.

The field of tissue engineering and regenerative medicine relies heavily on materials capable of implantation without significant foreign body reactions and with the ability to promote tissue differentiation and regeneration. The field of bone tissue engineering in particular requires materials capable of providing enhanced mechanical properties and promoting osteogenic cell lineage commitment. While bone repair has long relied almost exclusively on inorganic, calcium phosphate ceramics such as hydroxyapatite and their composites or on non-degradable metals, the organically derived shell and pearl nacre generated by mollusks has emerged as a promising alternative. Nacre is a naturally occurring composite material composed of inorganic, calcium carbonate plates connected by a framework of organic molecules. Similar to mammalian bone, the highly organized microstructure of nacre endows the composite with superior mechanical properties while the organic phase contributes to significant bioactivity. Studies, both in vitro and in vivo, have demonstrated nacre's biocompatibility, biodegradability, and osteogenic potential, which are superior to pure inorganic minerals such as hydroxyapatite or non-degradable metals. Nacre can be used directly as a bulk implant or as part of a composite material when combined with polymers or other ceramics. While nacre has demonstrated its effectiveness in multiple cell culture and animal models, it remains a relatively underexplored biomaterial. This review introduces the formation, structure, and characteristics of nacre, and discusses the present and future uses of this biologically-derived material as a novel biomaterial for orthopedic and other tissue engineering applications. STATEMENT OF SIGNIFICANCE: Mussel derived nacre, a biological composite composed of mineralized calcium carbonate platelets and interplatelet protein components, has recently gained interest as a potential alternative ceramic material in orthopedic biomaterials, combining the integration and mechanical capabilities of calcium phosphates with increased bioactivity derived from proteins and biomolecules; however, there is limited awareness of this material's potential. Herein, we present, to our knowledge, the first comprehensive review of nacre as a biomaterial. Nacre is a highly promising yet overlooked biomaterial for orthopedic tissue engineering with great potential in a wide variety of material systems. It is our hope that publication of this article will lead to increased community awareness of the potential of nacre as a versatile, bioactive ceramic capable of improving bone tissue regeneration and will elicit increased research effort and innovation utilizing nacre.

[Degradation of styrene by coupling ultraviolet and biofiltration].

Purification of styrene by ultraviolet (UV)-biofiltration was studied in this paper. The light source and the biofilm carrier were ozone producing lamp at 185 nm and the peat, palm fiber, porous acticarbon, respectively. Styrene inlet concentration was controlled between 320-583 mg x m(-3), and the removal efficiency remained above 95% after stabilization. The UV converted styrene into more soluble and biodegradable intermediates, such as alcohol, aldehyde and acid, thus the performance of biofilter can be improved. In the stable operation stage, the variation of inlet concentration did not affect the removal efficiency when the total residence time (TRT) was long, however, the inlet concentration obviously affected the removal efficiency when the TRT decreased. The removal load of coupling system increased linearly with increasing inlet load, and the removal efficiency was higher than 95% under a TRT of 102 s. When TRT was 68 s and the inlet load was low, the variation of removal load complied with the law described above, but it gradually deviated from the straight line and tended to stabilized at a certain value when the inlet load became higher than 30 g x (m3 x h)(-). If considering the fluctuation of styrene concentration only, the contribution rate of ultraviolet photolysis to styrene removal was greater than that of the biofilter, and the removal effect could be restored on the fourth day, after closing the system for ten days and restarting.