A novel natural scaffold layer improving efficiency, stability and reproducibility of Perovskite solar cells.

In this study, our hypothesis was to demonstrate the usability of a natural clay structure as scaffold layer in perovskite solar cells (PSCs). Sepiolite, which is a natural and environmentally friendly clay structure, has a very high active surface area and can easily be dispersed in solvents. In addition we predicted that crystallization could easily occur on their surfaces due to their surface chemistry. In the study, we firstly used a natural clay as scaffold layer in PSCs. It is observed that, efficiency, reproducibility and stability of PSCs have been significantly improved. Improvements in efficiency have been observed to be between 30 and 50% depending on the type of perovskite solvent used. In addition, the surface chemistry of the sepiolite resulted in better crystallization as well as stability. Due to its high-water adsorption capability, sepiolite makes the perovskite crystal more stable by trapping the residual water molecules as well as penetrated water molecules from environment. Consequently, we demonstrated that, a natural, low-cost and environmentally friendly clay may be an alternative material which may contribute to the commercialization of PSCs.

Amplifying the dielectric constant of shellac by incorporating natural clays for organic field effect transistors (OFETs).

We demonstrate in this work the practical use of uniform mixtures of a bioresin shellac and four natural clays, i.e. montmorillonite, sepiolite, halloysite and vermiculate as dielectrics in organic field effect transistors (OFETs). We present a thorough characterization of their processability and film forming characteristic, surface characterization, elaborate dielectric investigation and the fabrication of field effect transistors with two classic organic semiconductors, i.e. pentacene and fullerene C60. We show that low operating voltage of approximately 4 V is possible for all the OFETs using several combinations of clays and shellac. The capacitance measurements show an improvement of the dielectric constant of shellac by a factor of 2, to values in excess of 7 in the uniform mixtures of sepiolite and montmorillonite with this bioresin.

Synthesis and application of colloidal CdS quantum dots as interface modification material in perovskite solar cells.

In this study, colloidal CdS quantum dots were synthesized, structurally characterized, and their effect on performance of perovskite solar cells was observed by using them as interface modification agent between TiO2/perovskite. Colloidal CdS quantum dots were synthesized based on two-phase method and characterized by X-ray diffraction and Transmission Electron Microscopy techniques. The average particle size of CdS quantum dots have found to be around 5 nm. Oleic acid was used as capping agent during synthesis to lead solubility in organic solvents. Obtained quantum dots are coated on compact TiO2 layer for surface modification. A decrease was observed when oleic acid capped CdS quantum dots were used at interface, while significant improvement was observed when ligand exchange was carried out by pyridine before perovskite layer. Reference solar cells showed 11.6% efficiency, while pyridine capped CdS modified solar cells' efficiency was 13.2%. Besides the improvement in efficiency, reproducibility of solar cells also was increased by using pyridine capped CdS as interface material.