[Accurate determination of three new antihypertensive drugs illegally added to food using ultra-high performance liquid chromatography-tandem mass spectrometry].

Effective strategies are required to address food safety issues related to the illegal addition of antihypertensive drugs to food and claims of antihypertensive function. In this study, a novel ultra-high performance liquid chromatography-triple-quadrupole mass spectrometry (UHPLC-MS/MS) method was developed for the simultaneous determination of three antihypertensive drugs (azilsartan, candesartan cilexetil, and lacidipine) in 12 food matrices (pressed candies, solid beverages, alternative teas, tea drinks, biscuits, jellies, mixed liquors, oral liquids, medicinal teas, tablets, hard capsules, and soft capsules). Initially, mass spectrometry parameters, such as the collision energies of the three antihypertensive drugs, were optimized. Subsequently, the response intensities and chromatographic separation conditions of the three drugs in different mobile phases were compared. In addition, to enhance the recoveries, various extraction solvents and purification methods, including solid-phase extraction (SPE) columns and the QuEChERS technique, were investigated. In the developed method, sample determination involved three steps. First, the sample was extracted using 0.2% (v/v) formic acid in acetonitrile and then filtered using high-speed centrifugation, in addition, the extracted solution of alternative tea and medicinal tea was purified using the QuEChERS technique. Second, the supernatant was diluted with water, and filtered through a 0.22 µm polytetrafluoroethylene (PTFE) membrane. Finally, the analytes were separated on an Agilent Eclipse Plus RRHD C18 column (50 mm×2.1 mm, 1.8 µm) using a 5 mmol/L ammonium formate aqueous solution and acetonitrile as the mobile phases under gradient elution conditions and then detected using UHPLC-MS/MS with positive electrospray ionization (ESI) in the multiple reaction monitoring (MRM) mode. Quantitative analysis was performed using a matrix-matched external standard method. Methodological validation showed good linear relationships for all three antihypertensive drugs in the investigated concentration ranges, with correlation coefficients (r2) greater than 0.996. The limit of detection (LOD) and limit of quantification (LOQ) of lacidipine were 0.02 mg/kg and 0.04 mg/kg, respectively, whereas those of the other two drugs were 0.01 mg/kg and 0.02 mg/kg, respectively. In the 12 food matrices, the average recoveries of the drugs ranged from 86.6% to 107.5% with relative standard deviations (RSDs) of 1.1%-10.9% (n=6) at low, medium, and high spiked levels. Furthermore, this method was successfully applied to the analysis of real food samples. Overall, the newly developed method is simple, rapid, sensitive, accurate, and suitable for the qualitative and quantitative determination of antihypertensive drugs in different food matrices. This work could provide technical support for food safety agencies in implementing measures against the illegal addition of antihypertensive drugs to food.

Multicolor Fluorescent Inks Based on Lanthanide Hybrid Organogels for Anticounterfeiting and Logic Circuit Design.

With the rapid development of information technology, the encrypted storage of information is becoming increasingly important for human life. The luminescent materials with a color-changed response under physical or chemical stimuli are crucial for information coding and anticounterfeiting. However, traditional fluorescent materials usually face problems such as a lack of tunable fluorescence, insufficient surface-adaptive adhesion, and strict synthesis conditions, hindering their practical applications. Herein, a series of luminescent lanthanide hybrid organogels (Ln-MOGs) were rapidly synthesized using a simple method at room temperature through the coordination between lanthanide ions and 2,6-pyridinedicarboxylic acid and 5-aminoisophthalic acid. And the multicolor fluorescent inks were also prepared based on the Ln-MOG and hyaluronic acid, with the advantages of being easy to write, color-adjustable, and water-responsive discoloration, which has been applied to paper-based anticounterfeiting technology. Inspired by the responsiveness of the fluorescent inks to water, we designed a logic system that can realize single-input logic operations (NOT and PASS1) and double-input logic operations (NAND, AND, OR, NOR, XOR). The encryption of a binary code can be actualized utilizing different luminescent response modes based on the logic circuit system. By adjusting the energy sensitization and luminescence mechanism of lanthanide ions in the gel structure, the information reading and writing ability of the fluorescent inks were verified, which has great potential in the field of multicolor pattern anticounterfeiting and information encryption.

[Simultaneous determination of six fluorescent whitening agents in plastic and paper packaging materials by high performance liquid chromatography].

A novel analytical method was developed for the simultaneous determination of six fluorescent whitening agents (FWAs:FWA 135, FWA 184, FWA 185, FWA 199, FWA 378 and FWA 393) in paper and plastic food packaging materials by high performance liquid chromatography with fluorescence detection (HPLC-FLD). The sample was extracted with mixed solution of chloroform and acetonitrile (3:7, v/v), then cleaned up by HLB solid phase extraction column. Qualitative and quantitative analyses were carried out by HPLC. The sample was separated on a Phenomenex C18 column using acetonitrile and 5 mmol/L ammonium acetate aqueous solution as mobile phases. The results indicated that the linear range of FWA393 was 15-1500 µg/L and the linear ranges of the other five FWAs were 5-500 µg/L with correlation coefficients greater than 0.999. The recoveries in spiked samples were between 80.4% and 125.0% with RSDs (n=6) of 1%-13%. Furthermore, this method was applied to analyze 12 samples in the market to verify the practicality of the method. The method showed the advantages of simplicity, high recovery and good precision, and is suitable for the detection of the six fluorescent whitening agents in food packaging materials.

Migration kinetics of four photo-initiators from paper food packaging to solid food simulants.

The migration behaviour of four photo-initiators (BP, EHA, MBP and Irgacure 907) was studied by 'printing' onto four different food-packaging materials (Kraft paper, white cardboard, Polyethylene (PE)-coated paper and composite paper) and tracking movement into the food simulant: Tenax-TA (porous polymer 2,6-diphenyl furan resin). The results indicated that the migration of the photo-initiators was related to the molecular weight and log Ko/w of each photo-initiator. At different temperatures, the migration rates of the photo-initiators were different in papers with different thicknesses. The amount of each photo-initiator found in the food was closely related to the food matrix. The Weibull model was used to predict the migration load into the food simulants by calculating the parameters τ and ß and determining the relationship of the two parameters with temperature and paper thickness. The established Weibull model was then used to predict the migration of each photo-initiator with respect to different foods. A two-parameter Weibull model fitted the actual situation, with some deviation from the actual migration amount.

[Simultaneous determination of 9 ultraviolet stabilizers in food plastic packaging materials by solid phase extraction-high performance liquid chromatography].

An effective high performance liquid chromatographic (HPLC) method has been developed for the simultaneous determination of 9 ultraviolet stabilizers in food plastic packaging materials. The food packaging samples were firstly extracted by methanol-ethyl acetate, and then purified by a C18 solid-phase extraction (SPE) column. The target compounds were separated on a ZORBAX SB-C18 column (250 mm x 4.6 mm, 5 microm) in gradient elution mode using methanol and water as mobile phases. The detection wavelength was at 310 nm. The linear plots of the nine ultraviolet stabilizers were obtained between 0.2 and 10 mg/L, with the correlation coefficients of above 0. 999 for the nine ultraviolet stabilizers. The limits of detection for this method were in the range from 0.05 to 0.1 mg/L. The recoveries spiked in commercial food plastic packaging materials were in the range of 70.2% - 89.0% with the relative standard deviations of 0.4% - 4.5%. The results indicated that the method is simple, accurate, and suitable for the simultaneous determination of the nine ultraviolet stabilizers in food plastic packaging materials.