General rule for the energy of water-induced traps in organic semiconductors.

Charge carrier traps are generally highly detrimental for the performance of semiconductor devices. Unlike the situation for inorganic semiconductors, detailed knowledge about the characteristics and causes of traps in organic semiconductors is still very limited. Here, we accurately determine hole and electron trap energies for a wide range of organic semiconductors in thin-film form. We find that electron and hole trap energies follow a similar empirical rule and lie ~0.3-0.4 eV above the highest occupied molecular orbital and below the lowest unoccupied molecular orbital, respectively. Combining experimental and theoretical methods, the origin of the traps is shown to be a dielectric effect of water penetrating nanovoids in the organic semiconductor thin film. We also propose a solvent-annealing method to remove water-related traps from the materials investigated, irrespective of their energy levels. These findings represent a step towards the realization of trap-free organic semiconductor thin films.

A Strategy Inspired by the Cicada Shedding Its Skin for Synthesizing the Natural Material NaFe3 S5 ·2H2 O.

Sulfide minerals hold significant importance in both fundamental science and industrial advancement. However, certain natural sulfide minerals, such as NaFe3 S5 ·2H2 O (NFS), pose great challenges for exploitation and synthesis due to their high susceptibility to oxidation. To date, no successful precedent exists for synthesizing NFS. Here, a novel approach to synthesizing low-cost and pollution-free NFS with high stability using the high-pressure hydrothermal method based solely on knowledge of its chemical formula is presented. Moreover, an innovative strategy inspired by the cicada's molting process to develop unstable natural materials is proposed. The mechanical, thermal, optical, electrochemical, and magnetic properties of the NFS are thoroughly investigated. The storage of lithium, sodium, and potassium ions is primarily concentrated in the gap between (0 0 1) crystal planes. Additionally, as a catalyst for hydrogen evolution reaction (HER) at 10 mA cm-2 , micron-sized NFS exhibits an excellent overpotential of 6.5 mV at 90 °C, surpassing those of reported HER catalysts of similar size. This research bridges the gap in the sulfide mineral family, overcomes limitations of the high-pressure hydrothermal method, and paves the way for future synthesis of natural minerals, lunar minerals, and Martian minerals.

Barrierless Free Charge Generation in the High-Performance PM6:Y6 Bulk Heterojunction Non-Fullerene Solar Cell.

Organic solar cells are currently experiencing a second golden age thanks to the development of novel non-fullerene acceptors (NFAs). Surprisingly, some of these blends exhibit high efficiencies despite a low energy offset at the heterojunction. Herein, free charge generation in the high-performance blend of the donor polymer PM6 with the NFA Y6 is thoroughly investigated as a function of internal field, temperature and excitation energy. Results show that photocurrent generation is essentially barrierless with near-unity efficiency, regardless of excitation energy. Efficient charge separation is maintained over a wide temperature range, down to 100 K, despite the small driving force for charge generation. Studies on a blend with a low concentration of the NFA, measurements of the energetic disorder, and theoretical modeling suggest that CT state dissociation is assisted by the electrostatic interfacial field which for Y6 is large enough to compensate the Coulomb dissociation barrier.

Remarkably enhanced performance of the metathesis reaction of ethylene and 1-butene to propene using one-step prepared W-MCM-41 catalysts.

Highly dispersed tungsten species with an isolated tetrahedral WO x species structure are substantially beneficial for the metathesis reaction of ethylene and 1-butene to propene. The conventional impregnation method always leads to the formation of inactive crystalline WO3 thereby notably decreasing the amount of active sites. In this study, we synthesized a highly dispersed W-MCM-41 catalyst using the one-step precipitation method with a Si/W ratio of 30. The prepared catalyst showed excellent catalytic performance with a 1-butene conversion of 92.7% and a propene selectivity of 80.8%. In contrast, the impregnated catalyst with the same W loading as the one-step precipitation method resulted in a much lower 1-butene conversion of 76.5% and propene selectivity of 34.1%. Various characterization techniques including XRD, XPS, ICP-OES, UV-vis DRS, TEM, and Raman spectroscopy were applied to confirm that the one-step precipitation method can efficiently prepare well-dispersed W-MCM-41 catalysts with the desired structure in spite of the fact that the ideal dispersive structure was strongly dependent of the Si/W ratio and stirring time of the reaction mixture of tungstic acid and TEOS. In addition, the introduction of an upstream catalyst onto the W-MCM-41 catalyst could not obviously improve the 1-butene conversion and propene selectivity, which might be due to fast 1-butene isomerization easily occurring on the abundant Si-OH of the W-MCM-41 catalyst. This work provides new insights for the design of metathesis catalysts and reaction processes to efficiently convert ethylene and 1-butene into propene.

Morphology Determines Conductivity and Seebeck Coefficient in Conjugated Polymer Blends.

The impact of nanoscale morphology on conductivity and Seebeck coefficient in p-type doped all-polymer blend systems is investigated. For a strongly phase separated system (P3HT:PTB7), we achieve a Seebeck coefficient that peaks at S ∼ 1100 µV/K with conductivity σ ∼ 3 × 10-3 S/cm for 90% PTB7. In marked contrast, for well-mixed systems (P3HT:PTB7 with 5% diiodooctane (DIO), P3HT:PCPDTBT), we find an almost constant S ∼ 140 µV/K and σ ∼ 1 S/cm despite the energy levels being (virtually) identical in both cases. The results are interpreted in terms of a variable range hopping (VRH) model where a peak in S and a minimum in σ arise when the percolation pathway contains both host and guest sites, in which the latter acts as energetic trap. For well-mixed blends of the investigated compositions, VRH enables percolation pathways that only involve isolated guest sites, whereas the large distance between guest clusters in phase-separated blends enforces (energetically unfavorable) hops via the host. The experimentally observed trends are in good agreement with the results of atomistic kinetic Monte Carlo simulations accounting for the differences in nanoscale morphology.

Investigation on converting 1-butene and ethylene into propene via metathesis reaction over W-based catalysts.

Supported W catalysts were extensively investigated for the conversion of 1-butene and ethylene into propene by metathesis reaction. The performance of catalysts was compared by using unsupported WO3, pure SBA-15, supported W/SBA-15 with different W loadings, varied calcination temperatures, and by changing the pretreatment gas atmosphere. The above catalytic results could be employed to deduce the reaction mechanism combined with characterization techniques such as BET, XRD, UV-vis DRS, Raman, pyridine-IR, XPS, and H2-TPR. In this study, over the investigated W/SBA-15 catalysts, the results showed that the silanol group (Si-OH) in SBA-15 could act as a weak Brønsted acid site for 1-butene isomerization. However, the metathesis reaction was catalyzed by W-carbene species. The initially formed W-carbenes (W[double bond, length as m-dash]CH-CH3) as active sites were derived from the partially reduced isolated tetrahedral WO x species which contained W[double bond, length as m-dash]O or W-OH bonds in W5+ species as corresponding Lewis or Brønsted acid sites. Furthermore, the W/SBA-15 being pretreated by H2O led to a complete loss of the metathesis activity. This was mainly due to the sintering of isolated WO x species to form an inactive crystalline WO3 phase as demonstrated by XRD patterns. On the other hand, the reduction of WO x species remarkably suppressed by H2O pretreatment was also responsible for the metathesis deactivation. This study provides molecular level mechanisms for the several steps involved in the propene production, including 1-butene isomerization, W-carbene formation, and metathesis reaction.