Self-healing flexible strain sensor fabricated through 3D printing template sacrifice for motion monitoring with enhanced healing and mechanical performance.

With the advancements in flexible materials and information technology, flexible sensors are becoming increasingly pervasive in various aspects of life and production. They hold immense potential for further development in areas such as motion detection, electronic skin, soft robots, and wearable devices. Aminopropyl-terminated polydimethylsiloxane (PDMS) was used as the raw material, while a diisocyanate reagent served as the cross-linking agent for the polymerization reaction, which involved the introduction of ureido groups, containing N-H and C=O bonds, into the long siloxane chain. The dynamic hydrogen bonding between the clusters completes the self-healing of the material. Using 1-[3-(trimethoxysilyl)propyl]urea as a grafting agent, the urea groups are introduced into graphene oxide and carbon nanotubes (CNTs) as conductive fillers. Subsequently, a flexible polymer is used as the substrate to prepare conductive flexible self-healing composites. By controlling the amount of conductive fillers, flexible strain materials with varying sensitivities are obtained. Design the structure of the flexible strain sensor using three-dimensional (3D) modeling software with deposition printing method.

Evaluation of Temperature Sensors for Detection of Heat Sources Using Additive Printing Method.

Electrohydrodynamic (EHD) inkjet printing is an efficient technique for printing multiple sensors in a multifaceted area. It can be applied to various fields according to the shape of the printing result and the algorithm employed. In this study, temperature sensors capable of detecting heat sources were fabricated. Inks suitable for EHD inkjet printing were produced, and optimal parameters for printing were determined. Printing was performed using the corresponding parameters, and various printing results were obtained. Furthermore, an experiment was conducted to confirm the temperature measurement characteristics of the results and the tolerance of the sensor. Grid-type sensors were fabricated based on the results, and the sensor characteristics were confirmed in an orthogonal form. Heat was applied to arbitrary positions. Resistance to changes due to heat was measured, and the location at which the heat was generated was detected by varying the change in resistance. Through this study, efficient heat control can be achieved, as the location of the heat source can be identified quickly.