1H and 13C solution- and solid-state NMR investigation into wax products from the Fischer-Tropsch process.

ABSTRACT

(1)H and (13)C solid- and solution-state NMR have been used to characterise waxes produced in the Fischer-Tropsch reaction, using Co-based catalysts either unpromoted or promoted with approximately 1 wt% of either cerium or rhenium. The aim was to measure average structural information at the submolecular level of the hydrocarbon waxes produced, along with identification of the minor products, such as oxygenates and olefins, which are typically observed in these waxes. A parameter of key interest is the average number of carbon atoms within the hydrocarbon chain (N(C)). A wax prepared using an unpromoted Co/Al(2)O(3) catalyst had N(C)∼20, whilst waxes made using rhenium- or cerium-promoted Co/Al(2)O(3) catalysts were found to have N(C)∼21. All three samples contained small amounts of oxygenates and alkenes. The subtle differences found in the waxes, in particular the minor species produced, demonstrate that the different promoters have different effects during the reaction, with the Re-promoted catalyst producing the fewest by-products. It is shown in (13)C solid-state NMR spectra that for that for longer chain (compared to the lengths of chain in previous studies) waxes that the lack of resolution and the complexities added by the differential cross-polarisation (CP) dynamics mean that it is difficult to accurately determine N(C) from this approach. However the N(C) determined by (13)C CP magic angle spinning NMR is broadly consistent with the more accurate solution approaches used and suggest that the wax characteristics do not change in solution. On this basis an alternative approach for determining N(C) is suggested based on (1)H solution state NMR that provides a higher degree of accuracy of the chain length as well as information on the minor constituents.