The Influence of Selective Laser Melting (SLM) Process Parameters on In-Vitro Cell Response.
Int J Mol Sci
; 19(6)2018 May 30.
Article
em En
| MEDLINE
| ID: mdl-29849015
ABSTRACT
The use of laser 3D printers is very perspective in the fabrication of solid and porous implants made of various polymers, metals, and its alloys. The Selective Laser Melting (SLM) process, in which consolidated powders are fully melted on each layer, gives the possibility of fabrication personalized implants based on the Computer Aid Design (CAD) model. During SLM fabrication on a 3D printer, depending on the system applied, there is a possibility for setting the amount of energy density (J/mm³) transferred to the consolidated powders, thus controlling its porosity, contact angle and roughness. In this study, we have controlled energy density in a range 8â»45 J/mm³ delivered to titanium powder by setting various levels of laser power (25â»45 W), exposure time (20â»80 µs) and distance between exposure points (20â»60 µm). The growing energy density within studied range increased from 63 to 90% and decreased from 31 to 13 µm samples density and Ra parameter, respectively. The surface energy 55â»466 mN/m was achieved with contact angles in range 72â»128° and 53â»105° for water and formamide, respectively. The human mesenchymal stem cells (hMSCs) adhesion after 4 h decreased with increasing energy density delivered during processing within each parameter group. The differences in cells proliferation were clearly seen after a 7-day incubation. We have observed that proliferation was decreasing with increasing density of energy delivered to the samples. This phenomenon was explained by chemical composition of oxide layers affecting surface energy and internal stresses. We have noticed that TiO2, which is the main oxide of raw titanium powder, disintegrated during selective laser melting process and oxygen was transferred into metallic titanium. The typical for 3D printed parts post-processing methods such as chemical polishing in hydrofluoric (HF) or hydrofluoric/nitric (HF/HNO3) acid solutions and thermal treatments were used to restore surface chemistry of raw powders and improve surface.
Palavras-chave
Texto completo:
1
Base de dados:
MEDLINE
Assunto principal:
Titânio
Limite:
Humans
Idioma:
En
Ano de publicação:
2018
Tipo de documento:
Article