A comprehensive understanding of lowly-hydrolyzed polyvinyl alcohol-based ternary solid dispersions with the use of a combined mixture-process design.

We recently reported lowly hydrolyzed polyvinyl alcohol (L-PVA, 70-74% hydrolyzed, about 580 polymerized, JR-05) as a promising matrix for hot-melt extrusion (HME) due to its unique micelle formation ability compared to the most commonly used PVA (87-89% hydrolyzed, about 580 polymerized). In the present study, we focused on the effect of composition [indomethacin (IND), L-PVA, sorbitol] and process parameters (temperature and screw speed) on each response, i.e. processing torque, and physicochemical properties such as residual crystallinity, residual ratio, and area under the dissolution curve (AUDC) in supersaturated solution using a HME by applying the design of experiment (DoE) approach. To overcome the poor processability of L-PVA, given its semicrystalline nature, we applied sorbitol as a plasticizer and systematically and simultaneously evaluated its influence on the outputs based on the mixture design combined with process factors. Few studies have focused on comprehensive evaluation of the composition and HME process conditions because obtaining a design space requires numerous experiments. We found that incorporating sorbitol into the L-PVA greatly improved the processing torque. However, sorbitol negatively influenced the degree of residual crystallinity and the AUDC of IND. Lastly, we established a laboratory-scale design space that could achieve high supersaturation and ensure adequate miscibility between each component, using an acceptable processing torque for HME, by applying the minimum amount of sorbitol. These fundamental results suggest that sorbitol maximizes the potency of L-PVA as a carrier in HME.