Micropollutant removal and disinfection byproduct control by sequential peroxymonosulfate-UV treatment in water: A case study with sulfamethoxazole.

UV/peroxymonosulfate (UV/PMS) advanced oxidation process has attracted significant attention for removal of micropollutants in water. However, during practical water treatment applications, the PMS treatment must be performed before the UV treatment to achieve full contact. In this study, sulfamethoxazole (SMX) was selected as the target micropollutant. Four different operational approaches, including UV alone, PMS alone, simultaneous UV/PMS and sequential PMS-UV, were compared for their differences in SMX removal and disinfection by-product (DBP) formation potentials during chlorine-driven disinfection. Among the four approaches, UV/PMS and PMS-UV achieved over 90% removal efficiencies for SMX without substantial differences. For raw water, the trichloronitromethane (TCNM) formation potential after treatment with PMS-UV was lower than that after UV/PMS treatment. The time interval over which the PMS-UV process was conducted had little effect on the final removal efficiency for SMX. However, a brief (5 min) pre-PMS treatment significantly reduced the TCNM formation potential and the genotoxicity from DBPs. The formation risk for TCNM during chlorination increased markedly with increasing PMS dosages, and the appropriate dosage under these experimental conditions was suggested to be 0.5-1.0 mmol/L. Under alkaline conditions, PMS-UV treatment can enhance SMX degradation as well as dramatically reduced the formation potentials for haloketones, haloacetonitriles and halonitromethanes. This study suggests that proper optimization of UV/PMS processes can remove SMX and reduce its DBP formation.