RESUMO
The Au partially embedded nanostructure (PEN) is synthesized by ion irradiation on an Au thin film deposited on a glass substrate using a 50 keV Ar ion. Scanning electron microscopy results show ion beam-induced restructuring from irregularly shaped nanostructures (NSs) to spherical Au NSs, and further ion irradiation leads to the formation of well-separated spherical nanoparticles. Higuchi's algorithm of surface analysis is utilized to find the evolution of surface morphology with ion irradiation in terms of the Hurst exponent and fractal dimension. The Au PEN is evidenced by Rutherford backscattering spectrometry and optical studies. Also, the depth of the mechanism behind synthesized PEN is explained on the basis of theoretical simulations, namely, a unified thermal spike and a Monte Carlo simulation consisting of dynamic compositional changes (TRIDYN). Another set of plasmonic NSs was formed on the surface by thermal annealing of the Au film on the substrate. Glucose sensing has been studied on the two types of plasmonic layers: nanoparticles on the surface and PEN. The results reveal the sensing responses of both types of plasmonic layers. However, PEN retains its plasmonic behavior as the NSs are still present after washing with water, which demonstrates the potential for reusability. RESEARCH HIGHLIGHTS: Synthesis of PENs by ion irradiation Utilization of Higuchi's algorithm to explore the surface morphology. Unified thermal spike and TRIDYN simulations being used to explain the results. Glucose is only used as a test case for reusability of substrate.
RESUMO
The effects of metal concentration and annealing temperature on the localized surface plasmon resonance (LSPR) properties of the Pd nanoparticles (NP) dispersed in carbon were investigated. The Pd/C nano-composite thin films with 7 to 39 atomic % concentration of metal content were deposited using the atom beam co-sputtering techniques and subjected to annealing at temperature varying from 300 °C to 600 °C. The UV-vis spectroscopy studies on as-prepared films displayed a Mie scattering profile, but not well-defined LSPR bands were observed for all the values of Pd concentration. This is attributed to the smaller size (3-4 nm) of Pd NPs and rough Pd/C interface, as confirmed from TEM studies. When samples were annealed at a temperature of 300 °C, three broad LSPR absorption bands in the visible region, along with a sharp peak at 210 nm, were observed and the effect of Pd concentration variation was insignificant on their position. The multiple LSPR bands were observed due to agglomeration NPs, which is consistent with earlier reports and is also observed in the TEM images. When annealing temperature was subsequently increased to 500 °C, a blue shift in the LSPR peak position with an increase in the Pd concentration was observed, which phenomena is attributed to the formation of bigger NPs with the formation of sharp NPs-interface at high temperature upon annealing. A monotonic increase in the magnitude and decrease in the FWHM with an increase in concentration suggested change in the dielectric function of sample due to the growth of NPs. This is further confirmed from XRD studies, where strain relaxation and grain growth were observed. The intensity of the SPR peak decreased with an increase in the annealing temperature. The LSPR peak disappeared on annealing at a temperature of 600 °C, suggesting the formation of continuous polycrystalline thin films of Pd. In summary, NPs size, metalmatrix interface, and concentration of metal play key roles in the tailoring the LSPR properties of the Pd.
RESUMO
The Cu (3 to 15 at%) is incorporated into ZnO thin film by atomic beam co-sputtering has been investigated for enhancement in room temperature ferromagnetism and green photo-luminance. These Cu-ZnO thin films examined with Raman spectroscopy, X-Ray Diffraction (XRD), UV-Visible spectroscopy, Hall measurement, magnetic force microscopy (MFM) and magnetic hysteresis. Raman spectroscopy, XRD confirms wurtzite structure and improvement in the crystallinity of ZnO upto 7% Cu. Further increase in Cu concentration results in growth in Cu nanoparticles. On increasing Cu concentration, there is decrement in transparency and increase in band gap with increase in n-type carrier concentration as confirmed from UV-Visible and Hall measurement studies. Magnetic measurement exhibited unique feature of room temperature ferromagnetic ordering in undoped and doped sample upto 3% Cu. The enhancement in magnetic moment as well as green emission in photoluminescence response with increase in Cu doping indicates that generation of large defects in ZnO by Cu doping, which can be attributed to combined effect of the presence of oxygen vacancies and/or structural inhomogeneity as well as formation of bound magnetic polarons. Importantly, synthesised Cu doped ZnO thin films can be used as spin LEDs and switchable spin-laser diodes.
RESUMO
BACKGROUND: The extremity gunshot wound (GSW) and penetrating splinter injuries from mine blast present a surgical challenge in the treatment of arterial trauma especially at non-vascular surgery centre. Adherence to specific principles of management is required for optimal limb salvage. METHODS: Fourteen vascular injuries in patients of GSW and mine explosions were managed at a zonal military hospital with successful outcome in two years. The diagnosis of arterial injury was done clinically. RESULTS: The commonest site of vascular injury was femoral. The methods of choice for repair were autogenous vein interposition or end-to-end anastomosis. All except for two patients retained a functional limb. CONCLUSION: All surgeons in peripheral hospitals should be trained in vascular injury repair to save life and limb. Our series shows that right timing and prompt treatment of vascular injuries in a peripheral hospital, can give satisfactory results.
RESUMO
BACKGROUND: The sudden increase in incidence and magnitude of mine blast injuries prompted us to highlight the problem and its management. METHODS: The cases of mine blast injuries occurring during mining and demining in a particular geographical area were analysed. Total 27 cases of mine blast injuries occurred during mining or demining operations in a period of 13 months. RESULTS: Various body regions were involved in the mine blast injuries but the main brunt was borne by feet and legs followed by multiple body regions due to splinters. 14 patients underwent below knee (BK) amputation while 4 patients required through knee (TK) amputations. The effect of blast was so severe that most of the cases required 2 to 5 times wound debridements. The initial aggressive debridement / open stump amputation saved the limb and life of all patients. CONCLUSION: A mine blast causes extensive injuries and psychological trauma. Management is needed urgently, surgery is difficult, and amputation is often inevitable. Maximum lives and limbs can be saved with aggressive debridement, repeated inspections and dressings under anaesthesia and definitive closure at optimum time.
RESUMO
A case of basal cell carcinoma presenting in an unusual manner as orbital myiasis is reported. Orbit was full of maggots. Histopathology examination from the margin of the ulcerative area confirmed the diagnosis of basal cell carcinoma, which was infested secondarily with larvae of flies. Turpentine oil packs were used to remove the maggots.
Assuntos
Oftalmopatias/parasitologia , Miíase , Doenças Orbitárias/parasitologia , Idoso , Animais , Carcinoma Basocelular/complicações , Neoplasias Oculares/complicações , Feminino , Humanos , LarvaRESUMO
30 patients were operated upon using Surgibone (Bovine Xenograft) for purpose of providing osteogenic stimulation and mechanical support. Good to excellent results were obtained in 93% of cases highlighting the efficacy of this bone graft. Its use can hence circumvent the associated morbidity of bone graft harvest and yet perform as effectively as autologous bone graft. Its high cost, however, restricts its use to specialised centres and institutional practice.
RESUMO
The ion-irradiation induced synthesis of embedded Au nanoparticles (NPs) into glass from islands of Au on a glass substrate is studied in the context of recoiling atoms, sputtering and viscous flow. Cross sectional transmission electron microscopy studies revealed the formation of Au NPs embedded in the glass substrates by the 50 keV Si(-) ion irradiation of irregularly shaped Au nanostructures on the glass surfaces at a fluence of 3 × 10(16) ions/cm(2). The depth profiles of Au in the samples were obtained from high-resolution Rutherford backscattering spectrometry studies. The results from TRIDYN simulation reveal the role of various ion-induced processes during the synthesis of the embedded Au NPs, viz. sputtering and recoiling atoms. Simulation and experimental results suggest that the viscous flow is one of the major factors that are responsible for the embedding of Au nanoparticles into the glass substrate.