Diabetic mitochondria are resistant to palmitoyl CoA inhibition of respiration, which is detrimental during ischemia.

The bioactive lipid intermediate palmitoyl CoA (PCoA) can inhibit mitochondrial ADP/ATP transport, though the physiological relevance of this regulation remains unclear. We questioned whether myocardial ischemia provides a pathological setting in which PCoA regulation of ADP/ATP transport would be beneficial, and secondly, whether the chronically elevated lipid content within the diabetic heart could make mitochondria less sensitive to the effects of PCoA. PCoA acutely decreased ADP-stimulated state 3 respiration and increased the apparent Km for ADP twofold. The half maximal inhibitory concentration (IC50 ) of PCoA in control mitochondria was 22 µM. This inhibitory effect of PCoA on respiration was blunted in diabetic mitochondria, with no significant difference in the Km for ADP in the presence of PCoA, and an increase in the IC50 to 32 µM PCoA. The competitive inhibition by PCoA was localised to the phosphorylation apparatus, particularly the ADP/ATP carrier (AAC). During ischemia, the AAC imports ATP into the mitochondria, where it is hydrolysed by reversal of the ATP synthase, regenerating the membrane potential. Addition of PCoA dose-dependently prevented this wasteful ATP hydrolysis for membrane repolarisation during ischemia, however, this beneficial effect was blunted in diabetic mitochondria. Finally, using 31 P-magnetic resonance spectroscopy we demonstrated that diabetic hearts lose ATP more rapidly during ischemia, with a threefold higher ATP decay rate compared with control hearts. In conclusion, PCoA plays a role in protecting mitochondrial energetics during ischemia, by preventing wasteful ATP hydrolysis. However, this beneficial effect is blunted in diabetes, contributing to the impaired energy metabolism seen during myocardial ischemia in the diabetic heart.

Multivariate cluster analysis of pharmaceutical formulation data using Andrews plots.

A multivariate clustering technique known as the Andrews Plot was applied to a set of previously published data describing a series of pharmaceutical tablet formulations. Dependent variable data were subjected to a trigonometric transform algorithm and unique sinusoidal patterns were obtained for each of 18 formulations characterized by a total of 12 granulation and tablet parameters. Three main formulation clusters were observed in close agreement with a previously published analysis of the same data set using principal components methodology. Interpretation of cluster behavior lead to conclusions closely aligned to those of the original investigators, although some alternate hypotheses also arise. Limitations of the Andrews plotting technique were explored. The method appears to have value in the analysis of complex data sets derived from pharmaceutical formulation characterizations.

Reproducibility of control strains for antibiotic susceptibility testing.

Inter- and intralaboratory reproducibility of susceptibility testing requires stable control strains. The Food and Drug Administration diffusion procedure recommends the Seattle strains of Staphylococcus aureus (ATCC 25923) and Escherichia coli (ATCC 25922) for this purpose. It was of interest to determine the present reproducibility of control cultures maintained in various laboratories over several years. Fifteen cultures each of S. aureus and E. coli were obtained from laboratories in different parts of the country. Their performance was compared with strains directly derived from ATCC. Diffusion susceptibility tests using a modified overlay technique were made with four replicates. Seven of the eight statistically significant differences in responses of the staphylococci were to penicillin, methicillin, or cephalothin. One culture was a penicillinase producer with a zone 15 mm less than the standard strain. Eleven of the 15 cultures showed no significant deviations or differences greater than 2 mm from the results with the strain derived directly from ATCC. All except the penicillinase producer were of identical phage type. Among 150 organism-antibiotic combinations tested with E. coli, all but one reading were within 2 mm of the standard. Four of the six statistically significant differences were in a culture from one laboratory. The stability of the cultures appears to have been influenced by the method of storage. Cultures that were kept frozen during extended storage were remarkably stable. Significant differences were found in cultures from four of five laboratories that maintained cultures in refrigerators or at ambient temperature.

Relationship of early readings of minimal inhibitory concentrations to the results of overnight tests.

Broth dilution minimal inhibitory concentration (MIC) readings were compared after different incubation periods and with different inoculum concentrations. The purpose was to determine the best conditions for obtaining early results as close as possible to overnight readings. Initially, 76 antibiotic-organism combinations were tested using the International Collaborative Study technique and inoculum and were read after 3, 8, and 18 h of incubation. Approximately 28% of tests showed fourfold or greater increases in MICs after 18 h of incubation compared with the 3-h readings. No overnight MICs were lower than early readings. MICs of single antibiotics against seven organisms were also read with an automatic particle counter to confirm the validity of the visual readings. Experiments were made to determine whether inoculum manipulation could reconcile the differences between 3- and 18-h MIC results. One hundred and eight organism-antibiotic combinations were tested comparing 3-h MIC readings using an inoculum of 10(7) organisms per ml with overnight readings using 10(5) per ml. In 71 cases, readings with both inocula were within the range tested and 57 (86%) were within +/-1 log(2) of each other and followed an approximately normal distribution. Improved comparability between early read and overnight MICs thus may be achieved by inoculum manipulation, and this may be a suitable approach in the future development of automated procedures.