Contact versus flexure fatigue of a fiber-filled composite.

OBJECTIVE: The intent of this project was to examine the effect of two different modes of fatigue loading, contact and flexure, on the flexure strength of a dental composite. METHODS: The composite was Restolux (a fiber-filled composite) formed as bars 3 mm x 3 mm x 25 mm in size. The cyclic loading ranges were 30-50, 60-80, and 90-110 N for contact loading and 20-40 and 40-60 N for the flexure loading. Number of cycles completed was 1, 1000 or 100,000 in four different media: air, water, artificial saliva, and a 50/50 mixture of water and ethanol. Specimens were aged in sealed polyethylene containers in their respective media for 4 months at 37 degrees C. RESULTS: Statistical analysis indicated a significantly lower flexure strength for the specimens flexure loaded versus contact loaded. For the flexure loaded specimens, the number of cycles had no significant effect, but the aging, load, and the media were all significant. For the contact loaded specimens, a significant effect was observed for the media, aging, and cycles completed, but no effect for the different cycling loads. SIGNIFICANCE: In summary, the decrease in flexure strength from flexure loading was mainly affected by the aging media, whereas, the decrease from contact loading was attributed mainly to the number of cycles.

Leaching and mechanical properties characterization of dental composites.

The objective of this study was to determine the leaching of Ba, Si, and Sr from four dental composites: Restolux (RX), Micronew (M), Renew (RW), and Choice (C) and to correlate the effects of such leaching with flexure strength and modulus of elasticity. The specimens were 3 x 3 x 25-mm bars, polished with 120- and 240-grit SiC paper, and were aged for 4, 6, and 8 months in artificial saliva, distilled water, and a 50/50 mixture of ethanol and distilled water. Inductively coupled plasma with mass spectroscopy (ICP/MS) was used to determine the ion concentrations after aging. The greatest release of Ba and Sr occurred after aging in 50/50 volume fraction mixture of ethanol/water and for Si in artificial saliva. The 50/50 solution caused a breakdown of the resin and glass matrix, resulting in an increase of Ba and Sr, whereas aging in artificial saliva resulted in an ion charge balance, which allowed an elevated and continuous release of Si. The flexure strength and the elastic modulus showed a gradual decrease over time, with the greatest decreases occurring following aging in the 50/50 water/ethanol solution, but little correlation with the leaching of the filler ions.